Differences in molar relationships and occlusal contact areas evaluated from the buccal and lingual aspects using 3-dimensional digital models
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
Objective: The aims of this study were to use a 3-dimensional (3D) system to compare molar relationship assessments performed from the buccal and lingual aspects, and to measure differences in occlusal contact areas between Class II and Class I molar relationships. Methods: Study casts (232 pairs from 232 subjects, yielding a total of 380 sides) were evaluated from both the buccal and lingual aspects, so that molar relationships could be classified according to the scheme devised by Liu and Melsen. Occlusal contact areas were quantified using 3D digital models, which were generated through surface scanning of the study casts. Results: A cusp-to-central fossa relationship was observed from the lingual aspect in the majority of cases classified from the buccal aspect as Class I (89.6%) or mild Class II (86.7%). However, severe Class II cases had lingual cusp-to-mesial triangular fossa or marginal ridge relationships. Mean occlusal contact areas were similar in the Class I and mild Class II groups, while the severe Class II group had significantly lower values than either of the other 2 groups (p < 0.05). Conclusions: Buccal and lingual assessments of molar relationships were not always consistent. Occlusal contact areas were lowest for the Class II-severe group, which seems to have the worst molar relationships - especially as seen from the lingual aspect.
Abstract
Objective: The aims of this study were to use a 3-dimensional (3D) system to compare molar relationship assessments performed from the buccal and lingual aspects, and to measure differences in occlusal contact areas between Class II and Class I molar relationships. Methods: Study casts (232 pairs from 232 subjects, yielding a total of 380 sides) were evaluated from both the buccal and lingual aspects, so that molar relationships could be classified according to the scheme devised by Liu and Melsen. Occlusal contact areas were quantified using 3D digital models, which were generated through surface scanning of the study casts. Results: A cusp-to-central fossa relationship was observed from the lingual aspect in the majority of cases classified from the buccal aspect as Class I (89.6%) or mild Class II (86.7%). However, severe Class II cases had lingual cusp-to-mesial triangular fossa or marginal ridge relationships. Mean occlusal contact areas were similar in the Class I and mild Class II groups, while the severe Class II group had significantly lower values than either of the other 2 groups (p < 0.05). Conclusions: Buccal and lingual assessments of molar relationships were not always consistent. Occlusal contact areas were lowest for the Class II-severe group, which seems to have the worst molar relationships - especially as seen from the lingual aspect.
참고문헌 (21)
- Liu D, "Reappraisal of Class II molar relationships diagnosed from the lingual side", Clin Orthod Res, 4, pp.97~104 (2001)
- Casko JS, "Objective grading system for dental casts and panoramic radiographs. American Board of Orthodontics", Am J Orthod Dentofacial Orthop, 114, pp.589~599 (1998)
- Russell CW, "An atlas of tooth form. 4th ed", pp.12~ (1969), WB Saunders
- Keating AP, "A comparison of plaster, digital and reconstructed study model accuracy", J Orthod, 35, pp.191~201 (2008)
- Cha BK, "Applications of three-dimensionally scanned models in orthodontics", Int J Comput Dent, 10, pp.41~52 (2007)
- Bishara SE, "Changes in the molar relationship between the deciduous and permanent dentitions: a longitudinal study", Am J Orthod Dentofacial Orthop, 93, pp.19~28 (1988)
- Braun S, "The effect of maxillary first molar derotation on arch length", Am J Orthod Dentofacial Orthop, 112, pp.538~544 (1997)
- Hansen GK, "The rotation of maxillary first molars, mandibular first molars, and maxillary first premolars in acceptable occlusions", Aust Orthod J, 14, pp.242~246 (1997)
- Lamons FF, "The problem of the rotated maxillary first permanent molar", Am J Orthod, 47, pp.246~272 (1961)
- Moorrees CF, "Growth studies of the dentition: a review", Am J Orthod, 55, pp.600~616 (1969)
- Durbin DS, "Changes in tooth contacts following orthodontic treatment", Am J Orthod Dentofacial Orthop, 90, pp.375~382 (1986)
- Gazit E, "Occlusal contacts following orthodontic treatment. Measured by a photocclusion technique", Angle Orthod, 55, pp.316~320 (1985)
- Luke DA, "Chewing efficiency in relation to occlusal and other variations in the natural human dentition", Br Dent J, 159, pp.401~403 (1985)
- van der Bilt A, "Assessment of mastication with implications for oral rehabilitation: a review", J Oral Rehabil, 38, pp.754~780 (2011)
- Sierpinska T, "The effect of mastication on occlusal parameters in healthy volunteers", Adv Med Sci, 53, pp.316~320 (2008)
- Garcia Cartagena A, "Analysis of two methods for occlusal contact registration with the T-Scan system", J Oral Rehabil, 24, pp.426~432 (1997)
- Garrido Garcia VC, "Evaluation of occlusal contacts in maximum intercuspation using the T-Scan system", J Oral Rehabil, 24, pp.899~903 (1997)
- Aras K, "Masticatory performance, maximum occlusal force, and occlusal contact area in patients with bilaterally missing molars and distal extension removable partial dentures", Int J Prosthodont, 22, pp.204~209 (2009)
- 최윤정, "교정 치료 후 교합력, 교합면적의 변화", 대한치과교정학회지, 40(3), pp.176~183 (2010), 대한치과교정학회
- Sultana MH, "Changes in occlusal force and occlusal contact area after active orthodontic treatment: a pilot study using pressure-sensitive sheets", J Oral Rehabil, 29, pp.484~491 (2002)
- Korn M, "Aberrant eruption and its relationship to crowding: the need for early detection and management", Alpha Omegan, 92, pp.19~27 (1999)