양형 튜블러 샤프트 요크 적용 가변 슬라이딩 중간축 모듈의 토크 변경에 따른 응력 분포 특성
The Effect of Torque Variation on the Stress Distribution Characteristics in A-IMS Module with both Side Tubular Shaft Yoke
0
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
The objective of this study is to investigate the effect of torque variation on stress distributions in A-IMS module with both side tubular shaft yoke by numerically. In order to achieve this, the torque value was increased from 10Nm to 40Nm, and the results of this work were confirmed in terms of Von-mises Stress and the displacement characteristics. As the torque in module assembly was increased, the stress in tubular shaft york and splined shaft york was increased linearly. The indentation due to the steel ball was occurred in over 40N·m torque which is over the yield strength condition. The largest displacement occurred in the tubular shaft yoke 1, however, it does not exceed the yield strength and is supposed to be restored due to the elasticity. Therefore, it was concluded that there is no problem for the manufacturing of A-IMS with both side tubular shaft yoke.
Abstract
The objective of this study is to investigate the effect of torque variation on stress distributions in A-IMS module with both side tubular shaft yoke by numerically. In order to achieve this, the torque value was increased from 10Nm to 40Nm, and the results of this work were confirmed in terms of Von-mises Stress and the displacement characteristics. As the torque in module assembly was increased, the stress in tubular shaft york and splined shaft york was increased linearly. The indentation due to the steel ball was occurred in over 40N·m torque which is over the yield strength condition. The largest displacement occurred in the tubular shaft yoke 1, however, it does not exceed the yield strength and is supposed to be restored due to the elasticity. Therefore, it was concluded that there is no problem for the manufacturing of A-IMS with both side tubular shaft yoke.
참고문헌 (7)
- K. H. Choi, "Finite Element Analysis and Shape Design for Coated Intermediate Shaft of Steering System", Conference of KSAE, pp.1284~1288 (2009)
- 이현구, "자동차 조향장치 비대칭 핀치요크의 원가절감을 위한 냉간단조 공정단축 설계", 한국기계기술학회지, 16(2), pp.1365~1370 (2014), 한국기계기술학회[DOI]
- 민세훈, "상부금형 변경에 따른 상용 A-IMS 핵심 부품 최적화 설계", 한국기계기술학회지, 18(2), pp.294~300 (2016), 한국기계기술학회[DOI]
- 염진섭, "샤프트 홀의 길이에 따른 A-IMS 튜블러 샤프트의 가공특성", 한국기계기술학회지, 20(1), pp.96~101 (2018), 한국기계기술학회[DOI]
- S. H. Kim, "Press Die design Engineering", pp.15~ (2010), Dae Kwang Seo rim
- S. M. Lee, "Press Die design", pp.15~ (2012), Gi Jeon Yeon Gu Sa
- S. C. Choi, "Expert system for cold forging process design", Journal of KSTP, 2(2), pp.1~7 (1993)