Comparative analysis of physicochemical properties of root perforation sealer materials
1
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
Objectives: This study evaluated the solubility, dimensional alteration, pH, electrical conductivity, and radiopacity of root perforation sealer materials. Materials and Methods: For the pH test, the samples were immersed in distilled water for different periods of time. Then, the samples were retained in plastic recipients, and the electrical conductivity of the solution was measured. The solubility, dimensional alteration, and radiopacity properties were evaluated according to Specification No. 57 of the American National Standards Institute/American Dental Association (ANSI/ ADA). Statistical analyses were carried out using analysis of variance (ANOVA) and Tukey’s test at a significance level of 5%. When the sample distribution was not normal, a nonparametric ANOVA was performed with a Kruskal-Wallis test (α = 0.05). Results: The results showed that white structural Portland cement (PC) had the highest solubility, while mineral trioxide aggregate (MTA)-based cements, ProRoot MTA (Dentsply-Tulsa Dental) and MTA BIO (Ângelus Ind. Prod.), had the lowest values. MTA BIO showed the lowest dimensional alteration values and white PC presented the highest values. No differences among the tested materials were observed in the the pH and electrical conductivity analyses. Only the MTA-based cements met the ANSI/ADA recommendations regarding radiopacity, overcoming the three steps of the aluminum step wedge. Conclusions: On the basis of these results, we concluded that the values of solubility and dimensional alteration of the materials were in accordance with the ANSI/ADA specifications. PCs did not fulfill the ANSI/ADA requirements regarding radiopacity. No differences were observed among the materials with respect to the pH and electrical conductivity analyses.
Abstract
Objectives: This study evaluated the solubility, dimensional alteration, pH, electrical conductivity, and radiopacity of root perforation sealer materials. Materials and Methods: For the pH test, the samples were immersed in distilled water for different periods of time. Then, the samples were retained in plastic recipients, and the electrical conductivity of the solution was measured. The solubility, dimensional alteration, and radiopacity properties were evaluated according to Specification No. 57 of the American National Standards Institute/American Dental Association (ANSI/ ADA). Statistical analyses were carried out using analysis of variance (ANOVA) and Tukey’s test at a significance level of 5%. When the sample distribution was not normal, a nonparametric ANOVA was performed with a Kruskal-Wallis test (α = 0.05). Results: The results showed that white structural Portland cement (PC) had the highest solubility, while mineral trioxide aggregate (MTA)-based cements, ProRoot MTA (Dentsply-Tulsa Dental) and MTA BIO (Ângelus Ind. Prod.), had the lowest values. MTA BIO showed the lowest dimensional alteration values and white PC presented the highest values. No differences among the tested materials were observed in the the pH and electrical conductivity analyses. Only the MTA-based cements met the ANSI/ADA recommendations regarding radiopacity, overcoming the three steps of the aluminum step wedge. Conclusions: On the basis of these results, we concluded that the values of solubility and dimensional alteration of the materials were in accordance with the ANSI/ADA specifications. PCs did not fulfill the ANSI/ADA requirements regarding radiopacity. No differences were observed among the materials with respect to the pH and electrical conductivity analyses.
참고문헌 (40)
- Krupp C, "Treatment outcome after repair of root perforations with mineral trioxide aggregate: a retrospective evaluation of 90 teeth", J Endod, 39, pp.1364~1368 (2013)
- 박동성, "세 가지 역충전재의 근단부 폐쇄 효과에 관한 전기화학적 연구", Restorative Dentistry and Endodontics, 29(4), pp.365~369 (2004), 대한치과보존학회
- Darvell BW, ""MTA"-an Hydraulic Silicate Cement : review update and setting reaction", Dent Mater, 27, pp.407~422 (2011)
- Malhotra N, "Mineral trioxide aggregate: a review of physical properties", Compend Contin Educ Dent, 34, pp.e25~e32 (2013)
- Borges AH, "Comparative study of physicochemical properties of MTA-based and Portland cements", Acta Odontol Latinoam, 23, pp.175~181 (2010)
- Parirokh M, "Mineral trioxide aggregate: a comprehensive literature review-Part III: Clinical applications, drawbacks, and mechanism of action", J Endod, 36, pp.400~413 (2010)
- Camilleri J., "Hydration mechanisms of mineral trioxide aggregate", Int Endod J, 40, pp.462~470 (2007)
- 이정호, "THE EFFECT OF SEVERAL ROOT-END FILLING MATERIALS ON MG63 OSTEOBLAST-LIKE CELLS", Restorative Dentistry and Endodontics, 35(3), pp.222~228 (2010), 대한치과보존학회
- Payal Saxena, "Biocompatibility update", Restorative Dentistry and Endodontics, 38(3), pp.119~127 (2013), 대한치과보존학회
- 송민주, "Cytotoxicity of newly developed pozzolan cement and other root-end filling materials on human periodontal ligament cell", Restorative Dentistry and Endodontics, 39(1), pp.39~44 (2014), 대한치과보존학회[DOI]
- Cavenago BC, "Influence of powder-to-water ratio on radiopacity, setting time, pH, calcium ion release and a micro-CT volumetric solubility of white mineral trioxide aggregate", Int Endod J, 47, pp.120~126 (2014)
- Silva Neto JD, "Root perforations treatment using mineral trioxide aggregate and Portland cements", Acta Cir Bras, 25, pp.479~484 (2010)
- Silva Neto JD, "Portland cement with additives in the repair of furcation perforations in dogs", Acta Cir Bras, 27, pp.809~814 (2012)
- Camilleri J, "The chemical constitution and biocompatibility of accelerated Portland cement for endodontic use", Int Endod J, 38, pp.834~842 (2005)
- Torabinejad M, "Sealing ability of a mineral trioxide aggregate when used as a root end filling material", J Endod, 19, pp.591~595 (1993)
- 장석우, "Chemical characteristics of mineral trioxide aggregate and its hydration reaction", Restorative Dentistry and Endodontics, 37(4), pp.188~193 (2012), 대한치과보존학회
- Estrela C, "Antimicrobial and chemical study of MTA, Portland cement, calcium hydroxide paste", Sealapex and Dycal. Braz Dent J, 11, pp.3~9 (2000)
- Camilleri J, "Mineral trioxide aggregate: a review of the constituents and biological properties of the material", Int Endod J, 39, pp.747~754 (2006)
- ABCP, "Basic guide of Portland cement utilization" (2002), Brazilian Association of Portland Cement
- Garboczi EJ, "Shape analysis of a reference cement", Cem Concr Res, 34, pp.1933~1937 (2004)
- Borges AH, "Radiopacity evaluation of Portland and MTA-based cements by digital radiographic system", J Appl Oral Sci, 19, pp.228~232 (2011)
- Dammaschke T, "Chemical and physical surface and bulk material characterization of white ProRoot MTA and two Portland cements", Dent Mater, 21, pp.731~738 (2005)
- ANSI, "Specification No. 57. Endodontic sealing materials", pp.2000, ADA
- Carvalho-Junior JR, "Solubility and dimensional change after setting of root canal sealers: a proposal for smaller dimensions of test samples", J Endod, 33, pp.1110~1116 (2007)
- Tanomaru-Filho M, "Radiopacity evaluation of root-end filling materials by digitization of images", J Appl Oral Sci, 16, pp.376~379 (2008)
- Islam I, "Comparison of the physical and mechanical properties of MTA and portland cement", J Endod, 32, pp.193~197 (2006)
- Hwang YC, "Chemical composition, radiopacity, and biocompatibility of Portland cement with bismuth oxide", Oral Surg Oral Med Oral Pathol Oral Radiol Endod, 107, pp.e96~e102 (2009)
- Kogan P, "The effects of various additives on setting properties of MTA", J Endod, 32, pp.569~572 (2006)
- Duarte MA, "Evaluation of the propylene glycol association on some physical and chemical properties of mineral trioxide aggregate", Int Endod J, 45, pp.565~570 (2012)
- Fridland M, "Mineral trioxide aggregate (MTA) solubility and porosity with different water-to-powder ratios", J Endod, 29, pp.814~817 (2003)
- de Martins GR, "Sealing ability of castor oil polymer as a root-end filling material.", J Appl Oral Sci, 17, pp.220~223 (2009)
- Danesh G, "A comparative study of selected properties of ProRoot mineral trioxide aggregate and two Portland cements", Int Endod J, 39, pp.213~219 (2006)
- Bortoluzzi EA, "The influence of calcium chloride on the setting time, solubility, disintegration, and pH of mineral trioxide aggregate and white Portland cement with a radiopacifier", J Endod, 35, pp.550~554 (2009)
- Fridland M, "MTA solubility: a long term study", J Endod, 31, pp.376~379 (2005)
- Wiltbank KB, "Effect of selected accelerants on the physical properties of mineral trioxide aggregate and Portland cement", J Endod, 33, pp.1235~1238 (2007)
- Duarte MA, "pH and calcium ion release of 2 root-end filling materials", Oral Surg Oral Med Oral Pathol Oral Radiol Endod, 95, pp.345~347 (2003)
- Estrela C, "Characterization of calcium oxide in root perforation sealer materials", Braz Dent J, 23, pp.539~546 (2012)
- Santos AD, "Physico-chemical properties of MTA and a novel experimental cement", Int Endod J, 38, pp.443~447 (2005)
- Goncalves JL, "Evaluation of physico-chemical properties of Portland cements and MTA", Braz Oral Res, 24, pp.277~283 (2010)
- Hungaro Duarte MA, "Radiopacity of portland cement associated with different radiopacifying agents", J Endod, 35, pp.737~740 (2009)