위상변화를 이용한 표면탄성파 가스센서
Surface acoustic wave gas sensors by utilizing the phase change
0
조회
0
다운로드
0
인용
0
참고문헌
초록
Abstract
This paper describes the development of a surface acoustic wave gas sensor that is designed to detect volatile gas by monitering phase change of output signal as a function of time. The sensor consists of SAW oscillators with a center frequency of 100MHz fabricated on 128o Y-Z LiNbO3 substrates. Experimental results, which show the phase change of output signal under the absorption of volatile gas onto sensors, are presented. The proposed sensor has the properties of high sensitivity compare to the conventional SAW gas sensor and chemical selectivity. Thus, it is thought these results are applicable for use in sensor array of an high performance electronic nose system.
참고문헌 (6)
- S. Bender,F. L. Dickert,W. Mokwa,and P. Pachatz, "Investigation on temperature controlled monolithic integrated surface acoustic wave gas sensors", 93, pp.164~168 (2003)
- Y. J. Lee,H. B. Kim,Y. R. Roh,H. M. Cho, "Development of a SAW gas sensor for monitering SO2 gas", 64, pp.173~178 (1998)
- R. Andrew Mcgill,Douglas B. Chrisey et al, "Performance of optimization of surface acoustic wave chemical sensors", pp.140~146 (1997)
- 이찬우, "SOx 가스감지용 SAW 가스 센서 개발", 5(3), pp.41~48 (1996)
- 전춘배, "SAW 가스센서의 제작 및 특성", pp.40~45 (1994)
- F. Bender,N. Barie,G. Romoudis,A. Voigt,and M. Rapp,, "Development of a preconcentration unit for a SAW sensor micro array and its use for indoor air quality monitering", 93, pp.135~141 (2003)