다상조직강의 조직 분율에 따른 수소주입의 영향
The Influence of Hydrogen Charging with the Volume Fraction of Phases in Dual Phase Steels
0
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
A study on microstructure control of multi-phase steel have been implemented to higher strength with improved formability. However, it is well known that the high strength of steel are susceptible to hydrogen embrittlement. The mechanisms of hydrogen embrittlement is caused by complex interactions. In this paper,the test specimens were fabricated to 5 type of 590DP steels at different levels of volume faction. The hydrogen charging was conducted by electrochemical hydrogen-charge method with varying charging time. The relationship between hydrogen concentration and volume fraction of 590DP steel was established by SP test and SEM-fractography. It was shown that the hydrogen amounts charged in 590DP steels increased with increasing the volume faction of austenite. The maximum loads of the 590DP steels in SP test were sharply decreased with increasing hydrogen charging time. The results of SEM-fractography investigation showed typical brittle-fracture surfaces for hydrogen-charged 590DP steels
Abstract
A study on microstructure control of multi-phase steel have been implemented to higher strength with improved formability. However, it is well known that the high strength of steel are susceptible to hydrogen embrittlement. The mechanisms of hydrogen embrittlement is caused by complex interactions. In this paper,the test specimens were fabricated to 5 type of 590DP steels at different levels of volume faction. The hydrogen charging was conducted by electrochemical hydrogen-charge method with varying charging time. The relationship between hydrogen concentration and volume fraction of 590DP steel was established by SP test and SEM-fractography. It was shown that the hydrogen amounts charged in 590DP steels increased with increasing the volume faction of austenite. The maximum loads of the 590DP steels in SP test were sharply decreased with increasing hydrogen charging time. The results of SEM-fractography investigation showed typical brittle-fracture surfaces for hydrogen-charged 590DP steels
참고문헌 (11)
- R. P. Gangloff, , Metall. Trans, 8A, pp.1043~1105 (1977)
- B. G. Pound, , Acta Metall. Mater, 38, pp.2373~2381 (1990)
- T. Kushida, , Tetsu-to-Hagane, 82, pp.297~302 (1996)
- J. P. Hirth, , Metall, Mater. Trans., 11A, pp.861~890 (1980)
- T. Zhang, , Mater. Sci. Eng. A, 347, pp.291~299 (2003)
- G. E. Lucas, , Metall. Mater. Trans., 21A, pp.1105~ (1990)
- Y. H. Kim, , J. Metall. Mater. Trans., 14A, pp.1883~ (1983)
- K. Yokoyama, , Acta Mater., 57, pp.1875~ (2009)
- 강계명, "자동차 박강판용 고강도 DP강 표면층의 수소거동", 한국가스학회지, 14(6), pp.39~44 (2010), 한국가스학회
- Kota Murakami, "ASME, 6", 563~ (2006)
- 박재우, "소형펀치시험을 이용한 자동차용 고강도강 수소취성 평가", 한국재료학회지, 22(1), pp.29~34 (2012), 한국재료학회