탄성 버퍼층 결합형 마이크로 프로브
Elastic Buffer Layer Coupled Micro Probe
1
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In this paper, a new structure of probe unit is designed and fabricated with PDMS, which is well-known elastic material, as a buffer layer for increasing overdrive force and mechanical strength. In general, PDMS is widely used as actuation material due to its elasticity and compatibility of fabrication process. In this work, PDMS layer is chosen for mechanical elasticity of the proposed probe unit. We achieved the high overdrive force by placing PDMS buffer layer under the silicon based cantilever due to its elasticity. Moreover, the relation between prove length and overdrive force was measured by experiment in this work. Therefore, the various specifications of the micro prove unit can be designed by using the results of this work.
Abstract
In this paper, a new structure of probe unit is designed and fabricated with PDMS, which is well-known elastic material, as a buffer layer for increasing overdrive force and mechanical strength. In general, PDMS is widely used as actuation material due to its elasticity and compatibility of fabrication process. In this work, PDMS layer is chosen for mechanical elasticity of the proposed probe unit. We achieved the high overdrive force by placing PDMS buffer layer under the silicon based cantilever due to its elasticity. Moreover, the relation between prove length and overdrive force was measured by experiment in this work. Therefore, the various specifications of the micro prove unit can be designed by using the results of this work.
참고문헌 (10)
- 홍표환, "절연절단법을 이용한 프로브 빔의 제작", 센서학회지, 22(1), pp.89~94 (2013), 한국센서학회
- T. Itoh, "Characteristics of low force contact process for MEMS probe cards", Sens. Actuator A-Phys, 97, pp.462~467 (2002)
- T. Itoh, "Electroplated Ni microcantilever probe with electrostatic actuation", Sens. Actuator A-Phys, 123, pp.490~496 (2005)
- Y. Zhang, "Thermally actuated microprobes for a new wafer probe card", IEEE J. Microelectromech. Syst, 8(1), pp.43~49 (1999)
- F. Wang, "MEMS vertical probe cards with ultra densely arrayed metal probes for wafer-level IC testing", IEEE J. Microelectromech. Syst, 18(4), pp.933~941 (2009)
- C. J. Kim, "Fabrication of a MEMS-based fine-pitch cantilever-type probe unit", Proc. of IEEE Conf. on Sensors, pp.530~533 (2006)
- J. C. Yang, "Fabrication of a MEMS-based fine-pitch cnatilever-type probe unit", Proc. Intern. Microprocesses and Nanotechnology Conf, pp.328~329 (2006)
- S. H. Yoon, "Analysis of circular PDMS microballoons with ultralarge deflection for MEMS design", J. Microelectromech. Syst, 19(4), pp.854~864 (2010)
- O. C. Jeong, "All PDMS pneumatic microfinger with bidirectional motion and its application", J. Microelectromech. Syst, 15(4), pp.896~903 (2006)
- A. S. Nezhad, "PDMS microcantilever-based flow sensor integration for lab-on-a-chip", IEEE Sens. J, 13(2), pp.601~609 (2013)