The Observation of Intermetallic Compound Microstructure Under Sn Whisker in Lead-free Finish
2
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
Sn whiskers can grow from the pure Sn and high Sn-based finish and cause the electrical shorts and failures. Even with the wealth of information on whiskers, we have neither the clear understanding of whisker growth nor methods for its prevention. In this study, the whisker grain roots which connected with intermetallic layer were analyzed by high-resolution transmission electron microscopy (HR-TEM). In the Sn-Cu plated leadframe (LF) that was stored at ambient condition for 540 days, filament-shaped whiskers were grown on the Sn-plated surface and η´-Cu6Sn5 precipitates were widely distributed along the grain boundaries at the Sn matrix. The measured of the lattice fringes at the η´-Cu6Sn5 was 4.71Å at the coarse grain and 2.91Å at the fine grain. The Cu3Sn which generates the tensile stresses was not observed. The formation of Cu6Sn5 precipitates and intermetallic layer were strongly related to whisker growth, but, the whisker growth tendency does not closely relate with the geometric morphology of irregularly grown intermetallic compound (IMC).
Abstract
Sn whiskers can grow from the pure Sn and high Sn-based finish and cause the electrical shorts and failures. Even with the wealth of information on whiskers, we have neither the clear understanding of whisker growth nor methods for its prevention. In this study, the whisker grain roots which connected with intermetallic layer were analyzed by high-resolution transmission electron microscopy (HR-TEM). In the Sn-Cu plated leadframe (LF) that was stored at ambient condition for 540 days, filament-shaped whiskers were grown on the Sn-plated surface and η´-Cu6Sn5 precipitates were widely distributed along the grain boundaries at the Sn matrix. The measured of the lattice fringes at the η´-Cu6Sn5 was 4.71Å at the coarse grain and 2.91Å at the fine grain. The Cu3Sn which generates the tensile stresses was not observed. The formation of Cu6Sn5 precipitates and intermetallic layer were strongly related to whisker growth, but, the whisker growth tendency does not closely relate with the geometric morphology of irregularly grown intermetallic compound (IMC).
참고문헌 (15)
- K.N. Tu, "Spontaneous whisker growth on lead-free solder finishes", Mater. Sci. Eng. A, 409, pp.31~139 (2005)
- I. Sakamoto, "Whisker test methods of JEITA whisker growth mechanism for test methods", IEEE Trans. Elect. Packag. Manuf., 28, pp.10~16 (2005)
- K.N. Tu, "Interdiffusion and reaction in bimetallic Cu-Sn thin films", Acta Metall., 21, pp.347~354 (1973)
- K. Fujiwara, "Interfacial reaction in bimetallic Sn", Cu thin films, 1980, pp.70, 153~161
- R. Chopra, "Low temperature compound formation in Cu", Sn thin film couples, 1982, pp.94, 279~288
- Boguslavsky, "Recrystallization principles applied to whisker growth in tin", In Proc. APEX Conf. (2003)
- G.T.T. Sheng, "Tin whiskers studied by focused ion beam imaging and transmission electron microscopy", J. Appl. Phys., 92, pp.64~69 (2002)
- K.S. Kim, "Behavior of tin whisker formation and growth on lead-free solder plating", Thin Solid Films, 504, pp.350~354 (2006)
- N. Kuwano, "Application of a focused ion beam mill to the characterisation of a microstructure in tin plating on a Fe 42wt% Ni substrate", J. Electron. Microsc., 53, pp.541~544 (2004)
- T. Kakeshita, "Grain size effect of electro-plated tin coatings on whisker growth", J. Mater. Sci., 17, pp.2560~2566 (1982)
- B. Z. Lee, "Spontaneous growth mechanism of tin whiskers", Acta Mater., 46, pp.3701~3714 (1998)
- M. Dittes, "Tin whisker formation in thermal cycling conditions" (2003), IEEE
- K.-W. Moon, "Observed correlation of Sn oxide film to Sn whisker growth in Sn-Cu electrodeposit for Pb-free solders", J. Electron. Mater., 34, pp.L31~L33 (2005)
- A.K. Larsson, "The Superstructure of Domain-Twinned η´-Cu6Sn5", Acta Cryst., 50, pp.636~643 (1994)
- C.W. Hwang, "Interfacial microstructure between Sn-3Ag-xBi Alloy and Cu Substrate with or without Electrolytic Ni Plating", J. Electron. Mater, 32, pp.52~62 (2003)