기구학적 운동이 돼지 무릎 관절연골의 마찰계수 변화에 미치는 영향
Effect of Kinematic Motion on Changes in Coefficients of Friction of Porcine Knee Joint Cartilage
0
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
In this study, the frictional behaviors of articular cartilage against a Co-Cr alloy in two types of kinematic motions were compared. Cartilage pins were punched from the femoral condyles of porcine knee joints, and Co-Cr alloy disks were machined from orthopedic-grade rods and polished to a surface roughness (Ra) of 0.002. Friction tests were conducted by using a pin-on-disk–type tribotester in phosphate buffered saline (PBS) under pressures of 0.5, 1, and 2 MPa. All tests were performed in the repeat pass rotational (ROT) and the linear reciprocal (RCP) sliding motions with the same sliding distance and speed of 50 mm/s. The coefficients of friction of the cartilage against the Co-Cr alloy increased with the sliding time in both kinematic motions for all contact pressures. The maximum coefficients of friction in RCP motion were 1.08, 2.82, and 1.96 times those in ROT motion for contact pressures of 0.5,1, and 2 MPa, respectively. As the contact pressure increased, the coefficients of friction gradually increased in RCP motion, whereas they decrease and then increased in ROT motion. The interaction between the directional change of the shear stress and the orientation of collagen fiber in the superficial layer of the cartilage could affect the change in the frictional behaviors of the cartilage. A large difference in the coefficients of friction between the two kinematic motions could be interpreted as differences in the directional change of shear stress at the contact surface.
Abstract
In this study, the frictional behaviors of articular cartilage against a Co-Cr alloy in two types of kinematic motions were compared. Cartilage pins were punched from the femoral condyles of porcine knee joints, and Co-Cr alloy disks were machined from orthopedic-grade rods and polished to a surface roughness (Ra) of 0.002. Friction tests were conducted by using a pin-on-disk–type tribotester in phosphate buffered saline (PBS) under pressures of 0.5, 1, and 2 MPa. All tests were performed in the repeat pass rotational (ROT) and the linear reciprocal (RCP) sliding motions with the same sliding distance and speed of 50 mm/s. The coefficients of friction of the cartilage against the Co-Cr alloy increased with the sliding time in both kinematic motions for all contact pressures. The maximum coefficients of friction in RCP motion were 1.08, 2.82, and 1.96 times those in ROT motion for contact pressures of 0.5,1, and 2 MPa, respectively. As the contact pressure increased, the coefficients of friction gradually increased in RCP motion, whereas they decrease and then increased in ROT motion. The interaction between the directional change of the shear stress and the orientation of collagen fiber in the superficial layer of the cartilage could affect the change in the frictional behaviors of the cartilage. A large difference in the coefficients of friction between the two kinematic motions could be interpreted as differences in the directional change of shear stress at the contact surface.
참고문헌 (13)
- "All Rights Reserved by Samsung Medical Center General Radiology, 2006-2007", ~
- 이권용, "반복회전운동에서 코발트크롬합금과 미끄럼접촉하는 돼지무릎관절연골의 접촉압력이 마찰계수변화에 미치는 영향", 한국윤활학회지, 25(4), pp.231~235 (2009), 한국윤활학회
- 박성훈, "활액과 하이얼루러난이 소 연골의 마찰 특성에 작용하는 역할", 한국정밀공학회지, 25(10), pp.137~143 (2008), 한국정밀공학회
- Fukubayashi, T., "The Contact Area and Pressure Distribution Pattern of the Knee. A Study of Normal and Osteoarthrotic Knee Joint", Acta Orthop Scand, 51(6), pp.871~879 (1980)
- Yao, J. Q., "A New Technique for Measuring Contact Areas in Human Joints—the ‘3s Technique’", Proc Inst Eng, 205(2), pp.69~72 (1991)
- 윤형문, "줄기 세포를 이용한 관절 연골 손상의 치료", 대한류마티스학회지, 19(3), pp.125~131 (2012), 대한류마티스학회
- Buchwalter, J. A., "Articular cartilage : degeneration and osteoarthritis, repair, regeneration, and transplantation", Instr Course Lect, 47, pp.487~504 (1998)
- Brown, T. D., "Posttraumatic Osteoarthritis : A First Estimate of Incidence, Prevalence, and Burden of Disease", J Orthop Trauma, 20, pp.739~744 (2006)
- Northwood, E., "A Multi-directional in Vitro Investigation Into Friction, Damage and Wear of Innovative Chondroplasty Materials Against Articular Cartilage", Clinical Biomechanics, 22, pp.834~842 (2007)
- Katta, J., "The Effect of Glycosaminoglycan Depletion on the Friction and Deformation of Articular Cartilage", Proc. Inst Mech Eng, 222(1), pp.1~11 (2008)
- Pichard, J., "Investigation Into the Effect of Proteoglycan Molecules on the Tribological Properties of Cartilage Joint Tissues", Proc Inst Mech Eng, 212, pp.177~182 (1998)
- Zhang, J. L., "Friction of Articular Cartilage Under Different Pressures and Sliding Velocities", Journal of Biomechanics, 41, pp.S287~ (2008)
- Katta, J., "Effect of Nominal Stress on the Long Term Friction, Deformation and Wear of Mative and Glycosaminoglycan Deficient Articular Cartilage", Osteoarthritis and Cartilage, 17, pp.662~668 (2009)