A 2.4 GHz Low Power Low-IF Receiver Employing OOK and FSK Dual-Mode Demodulator for IoT Applications
1
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In this paper, a 2.4 GHz low-power low-IF receiver employing a dual-mode demodulator for on-off keying (OOK) and frequency-shift keying (FSK) signals is presented for Internet of Things (IoT) applications. The switched dual-mode demodulator can demodulate both OOK and FSK signals. The proposed receiver consists of a low-noise transconductance amplifier, single-balanced current-mode passive mixer, transimpedance amplifier, variable gain amplifier, and dual-mode demodulator. The proposed receiver was designed in a 65-nm CMOS process and mainly simulated at 2.4 GHz. The receiver achieves a noise figure of 9.9 dB, a maximum conversion gain of 74 dB, and an input-referred third-order intercept point of −26.3 dBm. The active die area of the designed receiver is 0.53 mm2, and it draws a bias current of 1.8 mA from a nominal supply voltage of 1 V.
Abstract
In this paper, a 2.4 GHz low-power low-IF receiver employing a dual-mode demodulator for on-off keying (OOK) and frequency-shift keying (FSK) signals is presented for Internet of Things (IoT) applications. The switched dual-mode demodulator can demodulate both OOK and FSK signals. The proposed receiver consists of a low-noise transconductance amplifier, single-balanced current-mode passive mixer, transimpedance amplifier, variable gain amplifier, and dual-mode demodulator. The proposed receiver was designed in a 65-nm CMOS process and mainly simulated at 2.4 GHz. The receiver achieves a noise figure of 9.9 dB, a maximum conversion gain of 74 dB, and an input-referred third-order intercept point of −26.3 dBm. The active die area of the designed receiver is 0.53 mm2, and it draws a bias current of 1.8 mA from a nominal supply voltage of 1 V.
참고문헌 (13)
- O. Abdelatty, "A low power Bluetooth lowenergy transmitter with a 10.5nJ startup-energy crystal oscillator", IEEE European Solid-State Circuits Conf. (ESSCIRC),, pp.377~380 (2019)
- J. Brown, "An ultra-low-power 9.8 GHz crystal-less UWB transceiver with digital baseband integrated in 0.18μm BiCMOS", IEEE Int. Solid-State Circuits Conf. Tech. Dig, pp.442~443 (2013)
- K. Cheng, "An Ultralow-power wake-up receiver based on direct active RF detection", IEEE Trans. Circuits Syst. I, Reg. Papers, 64(7), pp.1661~1672 (2017)
- C. Bryant, "A 2.45 GHz, 50 μW wake-up receiver front-end with −88 dBm sensitivity and 250 kbps data rate", IEEE European Solid State Circuits Conf. (ESSCIRC),, pp.235~238 (2014)
- A. Karanicolas, "A 2. 7-V 900-MHz CMOS LNA and mixer", IEEE J. Solid-State Circuits, 31(12), pp.1939~1944 (1996)
- T. Kim, "360-μW 4. 1-dB NF CMOS MedRadio receiver RF front-end with current-reuse Q-boosted resistive feedback LNA for biomedical IoT applications", Int. J. Circuit Theory Appl, 48(4), pp.502~511 (2020)
- S. Joo, "A 2. 4-GHz Resistive Feedback LNA in 0. 13-um CMOS", IEEE J. Solid-State Circuits, 44(11), pp.3019~3029 (2009)
- K. Kwon, "A 40 M-1000 MHz 77. 2 dB spurious free dynamic range CMOS RF variable gain amplifier for digital TV tuner ICs", Int. J. Circuit Theory Appl., 43(7), pp.875~886 (2015)
- J. Im, "A 217μW −82 dBm IEEE 802.11 Wi-Fi LP-WUR using a 3rd-harmonic passive mixer", Proc. IEEE Radio Freq. Integr. Circuits Symp. (RFIC), pp.172~175 (2018)
- K. Kim, "A 915 MHz, 499 μW, –99 dBm, and 100 kbps BFSK direct conversion receiver", IEEE European Solid State Circuits Conf. (ESSCIRC), pp.209~212 (2019)
- A. Alghaihab, "Enhanced interference rejection Bluetooth low-energy back-channel receiver With LO frequency hopping", IEEE J. Solid-State Circuits, 54(7), pp.2019~2027 (2019)
- P. Wang, "An interference-resilient BLE-compatible wake-up receiver employing single-die multi-channel FBAR-based filtering and a 4-D wake-up signature", IEEE J. Solid-State Circuits, 56(2), pp.416~426 (2021)
- J. Im, "A 470μW −92.5 dBm OOK", FSK receiver for IEEE 802.11 WiFi LP-WUR, 2018, 302~305