8 MW급 대용량 풍력발전기용 피치 감속기 진동특성에 관한 연구
A Study on the Vibration Characteristics of Pitch Gearbox for 8 MW Large Capacity Wind Turbines
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In this paper, a study on the vibration characteristics of the pitch gearbox of 8 MW large capacity wind turbines was conducted. The vibration analysis method of the pitch gearbox was proposed by combining the planetary gear train vibration model with the housing and carrier finite element model using the substructural synthesis method. We modeled the vibration excitation source for mass unbalance, gear mesh frequency, and bearing defect error action on the pitch gearbox, and performed a critical speed analysis. As a result of analyzing the critical speed of the pitch gearbox, the critical speed for the excitation source did not occur within the operation speed (84.87 rpm). In addition, as a result of applying 10 %, 20 %, …, 100 % of the largest load duration distribution (LDD) load, it was found that the bearing stiffness and the primary natural frequency were larger as the LDD load was larger. The primary natural frequency was 81.47 Hz for the lowest load among LDD data, which exceeded an operating speed of 84.87 rpm (5.09 Hz), so it was found that vibration caused by the change of LDD load did not occur in the operating speed range.
Abstract
In this paper, a study on the vibration characteristics of the pitch gearbox of 8 MW large capacity wind turbines was conducted. The vibration analysis method of the pitch gearbox was proposed by combining the planetary gear train vibration model with the housing and carrier finite element model using the substructural synthesis method. We modeled the vibration excitation source for mass unbalance, gear mesh frequency, and bearing defect error action on the pitch gearbox, and performed a critical speed analysis. As a result of analyzing the critical speed of the pitch gearbox, the critical speed for the excitation source did not occur within the operation speed (84.87 rpm). In addition, as a result of applying 10 %, 20 %, …, 100 % of the largest load duration distribution (LDD) load, it was found that the bearing stiffness and the primary natural frequency were larger as the LDD load was larger. The primary natural frequency was 81.47 Hz for the lowest load among LDD data, which exceeded an operating speed of 84.87 rpm (5.09 Hz), so it was found that vibration caused by the change of LDD load did not occur in the operating speed range.
참고문헌 (16)
- Nam. J. S., "Loading Test Results of Wind Turbine Pitch", Yaw Bearing, 2012, pp.3(1), 61~67
- 이형우, "2.5MW 풍력발전기 기어박스 치형수정", 한국생산제조학회지, 23(2), pp.109~117 (2014), 한국생산제조학회[DOI]
- Robert G. Parker, "Dynamic Response of a Planetary Gear System Using a Finite Element", Contact Mechanics Model, 2000, pp.122, 304~310
- A. Kahraman, "Dynamic Analysis of Geared Rotors by Finite Elements", Journal of Mechnical Design, 114, pp.507~514 (1992)
- L. D. Mitchell, "Proposed Solution Methodology for the Dynamically Coupled Nonlinear Geared Rotor Mechanics Equations", Journal of Vibration and Acoustics, 107, pp.112~116 (1985)
- J. Lin, "Sensitivity of Planetary Gear Natural Frequencies and Vibration Modes to Model Parameters", Journal of Sound and Vibration, 288, pp.109~128 (1999)
- G. V. Tordin, "Dynamic stability of a two-stage-gear train under the influence of variable meshing stiffness", Journal of Manufacturing Science and Engineering, 99, pp.785~791 (1977)
- F. K. Choy, "Vibration Signature and Modal Analysis of Multi-stage Gear Transmission", Journal of the Franklin Institure, 328, pp.281~298 (1991)
- F. K. Choy, "Modal Simulation of Gear Box Vibratio with Experimental Correlation", Journal of Propulsion and Power, 9, pp.301~306 (1993)
- Hiroshi Iida, "Coupled Torsional-flexural Vibration of a Shaft in a Geared System of Rotors", JSME, 23, pp.2111~2117 (1980)
- M. A. Prohl, "A General Method for Calculating Critical Speeds of Flexible Rotors", Journal of Applied Mechanics, 12, pp.142~148 (1945)
- E. A. Bossanyi, "Further load reductions with individual pitch control", Wind Energy, 8, pp.481~485 (2005)
- Choi. J. W., "A Review of Mode Syntheis Techniques and Its Application Between FE and Experimental Model", Transactions of the Korean Society of mechanical Engineers, 13, pp.799~806 (1989)
- Lee. H. Y., "An Analystical Investigation on Vibrational Characteristics of Multi-mesh Geared System Using Transfer Matrix Method", Master, pp.1999
- 김정수, "풍력발전시스템의 진동특성", 한국마린엔지니어링학회지, 35(6), pp.786~795 (2011), 한국마린엔지니어링학회
- 민영실, "2MW급 풍력발전기 사이클로이드 피치감속기 설계에 대한 연구", 한국마린엔지니어링학회지, 39(9), pp.895~902 (2015), 한국마린엔지니어링학회[DOI]