초고강도강판 드로잉 성형에서 가변 블랭크 홀딩력에 의한 스프링백 경향
Springback tendency with the variable blank holding force in the drawing process of the UHSS
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
The production of the automotive parts with the ultra high strength steel usually involves large amount of springback as well as fracture during the cold stamping process. Variable blank holding force(VBHF) can be used as one of the effective process parameters to reduce the springback amount with achieving better condition of formability. In this paper, VBHF with respect to the punch stroke is applied to the stamping process of the front side rear lower member for reducing the springback amount. From the analyses with constant blank holding force(CBHF), 24 kinds of VBHF conditions are utilized to investigate the springback tendency. It is noted that springback can be effectively reduced when BHF is increased near the bottom dead center because VBHF provides the tensile force to the blank with an adequate level of deformation without fracture
Abstract
The production of the automotive parts with the ultra high strength steel usually involves large amount of springback as well as fracture during the cold stamping process. Variable blank holding force(VBHF) can be used as one of the effective process parameters to reduce the springback amount with achieving better condition of formability. In this paper, VBHF with respect to the punch stroke is applied to the stamping process of the front side rear lower member for reducing the springback amount. From the analyses with constant blank holding force(CBHF), 24 kinds of VBHF conditions are utilized to investigate the springback tendency. It is noted that springback can be effectively reduced when BHF is increased near the bottom dead center because VBHF provides the tensile force to the blank with an adequate level of deformation without fracture
참고문헌 (10)
- Lin, Z. Q., "A new strategy to optimize variable blank holder force towards improving the forming limits of aluminum sheet metal forming", J. Mater. Process. Technol, 183, pp.339~346 (2007)
- Yossifon, S., "On the acceptable blank holder force range in the deep-drawing process", J. Mater. Process. Technol., 33, pp.175~194 (1992)
- Jeong, H.G., "Numerical study on the improvement of formability of automobile panel by blank holding force control", M. S., pp.2015
- Choi, H.S., "A numerical study on formability improvement by adjusting blank holding force", J. D&M Eng, 10(1), pp.31~35 (2016)
- Yoshida, F., "A model of large-strain cyclic plasticity describing the Bauschinger effect and workhardening stagnation", Int. J. Plasticity, 18(5), pp.661~686 (2002)
- Chung, K., "Part C Benchmark Problems and Results", Proc. NUMISHEET2011, pp.171~175 (2011), The Korean Society of Technology of Plasticity
- Auto Form, "Auto Form-user interface R7 software manual", ~ (2017)
- Hill, R., "A theory of the yielding and plastic flow of anisotropic metals", Proc. R. Soc. London, Ser. A, 193(1033), pp.281~297 (1948)
- ESI Group, "PAM-STAMPTM user's manual", ~ (2015)
- Kwak, J.H., "Evaluation of springback and forming characteristics of ultra high strength steel subjected to blank holding force control", M. S., pp.2017