수종 저 침습 고정성 국소의치의 수직하중에 대한 저항
Fracture Resistance of Low Invasive Fixed Partial Dentures
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
본 연구의 목적은 4 종류의 저 침습 고정성 국소의치의 수직하중에 대한 저항을 연구하여 임상 활용에 도움을 주기 위함이다. 상악 우측 제 1 대구치 결손을 가정하여 상악 제 2 대구치와 제 2 소구치를 지대치로 하는 고정성 국소의치 금속 다이를 제작하고 4 종류의 저 침습 고정성 국소의치 (Resin bonded FPD, Two Key Bridge, Human Bridge without occlusal rest, Human Bridge with occlusal rest)를 제작하였다. 만능 시험기를 이용하여 수직하중을 가하여 실패 시의 최대 하중을 기록하고 실패 유형을 기록하였다. 평균 최대 하중은 Resin bonded FPD 군이 7,295 N, Two Key Bridge 군이 4,729 N, Human Bridge without occlusal rest 군이 2,190 N, Human Bridge with occlusal rest 군이 3,073 N 이었다. Resin bonded FPD, Two Key Bridge, Human Bridge 군 사이에는 통계학적 유의차가 있었으나 occlusal rest 의 유무에 따른 Human bridge 군 사이에서는 통계학적 유의차가 없었다. 보철물 실패양상은 Resin bonded FPD와 Two Key Bridge는 양측 지대치의 유지부 한쪽이 탈락되는 경우가 양측 모두 탈락되는 경우보다 많았으며 Human Bridge 군은 모두 지대치 양측의 유지부가 함께 탈락되는 경우가 한쪽이 탈락된 경우보다 더 많았다. 본 연구에서 저 침습 고정성 국소의치의 수직 하중에 대한 저항은 Human Bridge 군이 resin bonded FPD 군이나 Two key Bridge 군에 비하여 낮은 것으로 나타났다. 따라서 임상에 적용할 때에는 이와 같은 파절 저항을 고려하여 수복 위치의 최대 교합을 참고하는 것은 물론이고 각종 수복물의 탈락에 대한 저항, 그리고 치질의 삭제량, 환자의 협조도 등을 고려하여 각각의 환자에 적합한 수복물을 선택해야 할 것이다.
Abstract
This study aims at contributing to the restorative dentistry by examining results in the vertical load test of four different low invasive fixed partial dentures. Based on a hypothesis on the right upper first molar is missing, three units of FPDs were made for the second premolar and the second molar abutment. that is, twelve metal dies and FPDs were made for resin bonded FPD and Two Key Bridges and Human Bridge without occlusal rest and Human Bridge with occlusal rest. By using universal test machine, the numerical maximum value were recorded during the vertical load test of each FPDs after the bonding process treated by Maxcem which is resin cement. The failure process and its result of prosthesis were also observed. The maximum load was 7,295 N, 4,729 N, 2,190 N, 3,073 N from groups of resin bonded FPD, Two Key Bridge, Human Bridge without occlusal rest and Human Bridge with occlusal rest respectively. There was a statistical significance among the groups of resin bonded FPD, Two Key Bridge and Human Brides. However, there was no significant difference between Human Bridge without occlusal rest and Human Bridge with occlusal rest. Regarding the failure of prosthesis, the groups of Resin Bonded FPD and Two Key Bridge showed that one of the abutment teeth in the both side of retention part was highly failed earlier than the other one (83.2% and 66.6% respectively). While, Human Bridge without occlusal rest and Human Bridge with occlusal rest showed high percentage of failure in the abutment teeth in the both side of retention part at the same time (91.6% and 58.3% respectively). This study demonstrates that the group of Human Bridges has low resistance to the vertical loads of low invasive FPDs in comparison with the groups of resin bonded FPD and Two Key Bridge. Nevertheless, the maximum occlusal load of the restorative position, resistance to diverse restoration failure, amount of tooth reduction and patients’ cooperation should be considered when they are applied in the clinic in order to choose an appropriate restoration for each patient.
참고문헌 (27)
- 이종원, "Bio-pin？을 이용한 고정성 보철물의 탈락저항강도의 비교연구", 대한치과보철학회지, 43(2), pp.176~190 (2005), 대한치과보철학회
- Lee CH, "Effect of various resin cements to the shear bond strength in the adhesion bridge", J Kor Acad Prosthodont, 34(4), pp.791~799 (1996)
- Barrack G, "Recent advances in etched cast restorations", J Prsthet Dent, 52, pp.619~ (1984)
- Goerig AC, "Management of the endodontically treated tooth. Part I. Concept for restorative design", J Prosthet Dent, 49, pp.340~345 (1983)
- Buonocore MG, "A simple method of increasing the adhesion of acrylic resin filling materials to enamel surface", J Dent Res, 34, pp.849~853 (1955)
- Rochette AL, "Attachment of splint to enamel of lower anterior teeth", J Prosthet Dent, 30, pp.418~423 (1973)
- Moon PC, "Acid-ehched bridge bond strength utilizing a new retention method", J Dent Res, 62, pp.296~ (1983)
- Moon PC, "Bond strength of the lost salt procedure:A new retention method for resin bonded fixed prosthesis", J Prosthet Dent, 57, pp.435~439 (1987)
- Livaditis GJ, "Ethched castings: An improved retentive mechanism for resin-bonded retainer", J Prosthet Dent, 47, pp.52~58 (1982)
- Laufer BZ, "SiOx-C coating: A composite to metal bonding mechanism", J Prosthet Dent, 60, pp.320~327 (1986)
- Imbery TA, "Evaluation of tin plating system for a high-noble alloy", Int J Prosthodont, 6, pp.55~59 (1993)
- Tanaka T, "Surface treatment of non precious alloys for adhesion fixed partial denture", J Prosthet Dent, 55, pp.456~462 (1986)
- Kohlis S, "The effact of three different treatment on the tensile strength of resin bond to nickel-chromium-beryllium alloy", J Prosthet Dent, 63, pp.4~8 (1990)
- Briggs P, "The single unit, single retainer,cantilever resin bonded bridge", Br Dent J, 181, pp.373~379 (1996)
- Hussey DL, "Performance of 400 adhesive bridge fitted in restorative dentistry department", J Dent, 19, pp.221~225 (1991)
- Choi KS, "Artificial teeth for dental department", Korean patent 20-1999-0024381, ~ (1996)
- Kwon OD, "Dental prosthesis and it's manufacturing", Korean patent 10-2006-0001540, ~ (2006)
- 도레미, "Dislodgement resistance of modified resin-bonded fixed partial dentures utilizing tooth undercuts: an in vitro study", The Journal of Advanced of Prosthodontics, 1(2), pp.85~90 (2009), 대한치과보철학회
- Thompson VP, "Resinbonded retainers. Part Ⅰ:Resin bond to electrolytically etched non precious alloys", J Dent Res, 50, pp.771~779 (1983)
- Jung KT, "An experiment study on the bond strength of adhesive resin to sueexssively recast alloys for resin bonded restorations", J Kor Acad Prosthodont, 28, pp.53~76 (1990)
- Osama AM, "Bond strengths of three chemical adhesive cement adhered to nickel chormium alloy for direct bonded retainer", J. Prosthet Dent, 63, pp.137~ (1990)
- Williams VD, "The effact of retainer design on the retention of filled resin in acid etched fixed partial dentures", Prosthet Dent, 48, pp.417~ (1982)
- Shimizu H, "Retainer design for posterior resin bonded fixed partial dentures: A technical report", Quintessence Int, 35, pp.653~654 (2004)
- Chow TW, "Tooth preparation designed for posterior resin bonded fixed partial dentures:a clinical report", J Prosthet Dent, 88, pp.561~564 (2002)
- Omar El-Mowafy, "Retention of posterior resin bonded fixed partial denture with modified design: an in vitro study", Int J Prosthodont, 13, pp.425~431 (2000)
- O'Brien WJ, "Dental materials and their selection", pp.217~229, Quintessence books
- Field WD, "Variable affecting measurement of vertical occlusal force", J Dent Res, 65, pp.135~138 (1986)