Push-out bond strength and intratubular biomineralization of a hydraulic root-end filling material premixed with dimethyl sulfoxide as a vehicle
2
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Objectives: This study was designed to evaluate the parameters of bonding performance to root dentin, including push-out bond strength and dentinal tubular biomineralization, of a hydraulic bioceramic root-end filling material premixed with dimethyl sulfoxide (Endocem MTA Premixed) in comparison to a conventional powder-liquid–type cement (ProRoot MTA). Materials and Methods: The root canal of a single-rooted premolar was filled with either ProRoot MTA or Endocem MTA Premixed (n = 15). A slice of dentin was obtained from each root. Using the sliced specimen, the push-out bond strength was measured, and the failure pattern was observed under a stereomicroscope. The apical segment was divided into halves; the split surface was observed under a scanning electron microscope, and intratubular biomineralization was examined by observing the precipitates formed in the dentinal tubule. Then, the chemical characteristics of the precipitates were evaluated with energy-dispersive X-ray spectroscopic (EDS) analysis. The data were analyzed using the Student’s t-test followed by the Mann-Whitney U test (p < 0.05). Results: No significant difference was found between the 2 tested groups in push-out bond strength, and cohesive failure was the predominant failure type. In both groups, flake-shaped precipitates were observed along dentinal tubules. The EDS analysis indicated that the mass percentage of calcium and phosphorus in the precipitate was similar to that found in hydroxyapatite. Conclusions: Regarding bonding to root dentin, Endocem MTA Premixed may have potential for use as an acceptable root-end filling material.
Abstract
Objectives: This study was designed to evaluate the parameters of bonding performance to root dentin, including push-out bond strength and dentinal tubular biomineralization, of a hydraulic bioceramic root-end filling material premixed with dimethyl sulfoxide (Endocem MTA Premixed) in comparison to a conventional powder-liquid–type cement (ProRoot MTA). Materials and Methods: The root canal of a single-rooted premolar was filled with either ProRoot MTA or Endocem MTA Premixed (n = 15). A slice of dentin was obtained from each root. Using the sliced specimen, the push-out bond strength was measured, and the failure pattern was observed under a stereomicroscope. The apical segment was divided into halves; the split surface was observed under a scanning electron microscope, and intratubular biomineralization was examined by observing the precipitates formed in the dentinal tubule. Then, the chemical characteristics of the precipitates were evaluated with energy-dispersive X-ray spectroscopic (EDS) analysis. The data were analyzed using the Student’s t-test followed by the Mann-Whitney U test (p < 0.05). Results: No significant difference was found between the 2 tested groups in push-out bond strength, and cohesive failure was the predominant failure type. In both groups, flake-shaped precipitates were observed along dentinal tubules. The EDS analysis indicated that the mass percentage of calcium and phosphorus in the precipitate was similar to that found in hydroxyapatite. Conclusions: Regarding bonding to root dentin, Endocem MTA Premixed may have potential for use as an acceptable root-end filling material.
참고문헌 (24)
- Payal Saxena, "Biocompatibility update", Restorative Dentistry and Endodontics, 38(3), pp.119~127 (2013), 대한치과보존학회[DOI]
- Bernabé PF, "Sealing ability of MTA used as a root end filling material : effect of the sonic and ultrasonic condensation", Braz Dent J, 24, pp.107~110 (2013)
- Torabinejad M, "Physical and chemical properties of a new root-end filling material", J Endod, 21, pp.349~353 (1995)
- Alsubait SA, "Comparative evaluation of push-out bond strength of ProRoot MTA, bioaggregate and Biodentine", J Contemp Dent Pract, 15, pp.336~340 (2014)
- Nagas E, "Effect of several intracanal medicaments on the push-out bond strength of ProRoot MTA and Biodentine", Int Endod J, 49, pp.184~188 (2016)
- Buldur B, "The effect of different chelating agents on the push-out bond strength of ProRoot MTA and EndoSequence root repair material", Eur Oral Res, 53, pp.88~93 (2019)
- Saghiri MA, "Push-out bond strength of mineral trioxide aggregate in the presence of alkaline pH", J Endod, 36, pp.1856~1859 (2010)
- Vivan RR, "Push-out bond strength of root-end filling materials", Braz Dent J, 27, pp.332~335 (2016)
- Shokouhinejad N, "Push-out bond strength of two root-end filling materials in root-end cavities prepared by Er,Cr:YSGG laser or ultrasonic technique", Aust Endod J, 38, pp.113~117 (2012)
- Ashofteh Yazdi K, "Effect of blood exposure on push-out bond strength of four calcium silicate based cements", Iran Endod J, 12, pp.196~200 (2017)
- Tuncel B, "Effect of endodontic chelating solutions on the bond strength of endodontic sealers", Braz Oral Res, 29 (2015)
- Araújo CC, "Root filling bond strength using reciprocating file-matched single-cones with different sealers", Braz Oral Res, 30 (2016)
- Prado MC, "Do intracanal medications used in regenerative endodontics affect the bond strength of powder-to-liquid and ready-to-use cervical sealing materials?", J Conserv Dent, 24, pp.464~469 (2021)
- Al-Hiyasat AS, "Push-out bond strength of calcium silicate-based cements in the presence or absence of a smear layer", Int J Dent, 2022, pp.7724384~ (2022)
- Salem Milani A, "Mixing with propylene glycol enhances the bond strength of mineral trioxide aggregate to dentin", J Endod, 39, pp.1452~1455 (2013)
- Retana-Lobo C, "Push-out bond strength, characterization, and ion release of premixed and powderliquid bioceramic sealers with or without gutta-percha", Scanning, 2021, pp.6617930~ (2021)
- Salim Al-Ani AA, "Effect of various dimethyl sulfoxide concentrations on the durability of dentin bonding and hybrid layer quality", Dent Mater J, 37, pp.501~505 (2018)
- Tjäderhane L, "The effect of dimethyl sulfoxide(DMSO)on dentin bonding and nanoleakage of etch-and-rinse adhesives", Dent Mater, 29, pp.1055~1062 (2013)
- Lindblad RM, "The effect of chlorhexidine and dimethyl sulfoxide on long-term sealing ability of two calcium silicate cements in root canal", Dent Mater, 37, pp.328~335 (2021)
- Reyes-Carmona JF, "Biomineralization ability and interaction of mineral trioxide aggregate and white Portland cement with dentin in a phosphate-containing fluid", J Endod, 35, pp.731~736 (2009)
- Yoo YJ, "Intratubular biomineralization in a root canal filled with calcium-enriched material over 8 years", Materials(Basel), 10, pp.1388~ (2017)
- Reyes-Carmona JF, "A phosphate-buffered saline intracanal dressing improves the biomineralization ability of mineral trioxide aggregate apical plugs", J Endod, 36, pp.1648~1652 (2010)
- Yoo YJ, "Dynamic intratubular biomineralization following root canal obturation with pozzolan-based mineral trioxide aggregate sealer cement", Scanning, 38, pp.50~56 (2016)
- Reyes-Carmona JF, "The biomineralization ability of mineral trioxide aggregate and Portland cement on dentin enhances the push-out strength", J Endod, 36, pp.286~291 (2010)