본문 바로가기
KERD
논문KCI 등재

The effect of dentin desensitizers and Nd:YAG laser pre-treatment on microtensile bond strength of selfadhesive resin cement to dentin

1

조회

0

다운로드

1

인용

0

참고문헌

키워드

초록

PURPOSE. The purpose of this study is to evaluate if pre-treatment with desensitizers have a negative effect on microtensile bond strength before cementing a restoration using recently introduced self-adhesive resin cement to dentin. MATERIALS AND METHODS. Thirty-five human molars’occlusal surfaces were ground to expose dentin; and were randomly grouped as (n=5); 1) Gluma-(Glutaraldehyde/HEMA) 2) Aqua-Prep F-(Fluoride), 3) Bisblock-(Oxalate), 4) Cervitec Plus-(Clorhexidine), 5) Smart protect-(Triclosan), 6) Nd:YAG laser, 7) No treatment(control). After applying the selected agent, RelyX U200 self-adhesive resin cement was used to bond composite resin blocks to dentin. All groups were subjected to thermocycling for 1000 cycles between 5-55°C. Each bonded specimen was sectioned to microbars (6 mm × 1 mm × 1 mm) (n=20). Specimens were submitted to microtensile bond strength test at a crosshead speed of 0.5 mm/min. Kolmogorov-Smirnov, Levene’ test, Kruskal–allis One-way Analysis of Variance, and Conover’ nonparametric statistical analysis were used(P<.05). RESULTS. Gluma, Smart Protect and Nd:YAG laser treatments showed comparable microtensile bond strengths compared with the control group (P>.05). The microtensile bond strengths of Aqua-Prep F, and Cervitec Plus were similar to each other but significantly lower than the control group (P<.05). Bisblock showed the lowest microtensile bond strength among all groups (P<.001). Most groups showed adhesive failure. CONCLUSION. Within the limitation of this study, it is not recommended to use Aqua-prep F, Cervitec Plus and Bisblock on dentin when used with a self-adhesive resin cement due to the decrease they cause in bond strength. Beside, pre-treatment of dentin with Gluma, Smart protect, and Nd:YAG laser do not have a negative effect.

Abstract

PURPOSE. The purpose of this study is to evaluate if pre-treatment with desensitizers have a negative effect on microtensile bond strength before cementing a restoration using recently introduced self-adhesive resin cement to dentin. MATERIALS AND METHODS. Thirty-five human molars’occlusal surfaces were ground to expose dentin; and were randomly grouped as (n=5); 1) Gluma-(Glutaraldehyde/HEMA) 2) Aqua-Prep F-(Fluoride), 3) Bisblock-(Oxalate), 4) Cervitec Plus-(Clorhexidine), 5) Smart protect-(Triclosan), 6) Nd:YAG laser, 7) No treatment(control). After applying the selected agent, RelyX U200 self-adhesive resin cement was used to bond composite resin blocks to dentin. All groups were subjected to thermocycling for 1000 cycles between 5-55°C. Each bonded specimen was sectioned to microbars (6 mm × 1 mm × 1 mm) (n=20). Specimens were submitted to microtensile bond strength test at a crosshead speed of 0.5 mm/min. Kolmogorov-Smirnov, Levene’ test, Kruskal–allis One-way Analysis of Variance, and Conover’ nonparametric statistical analysis were used(P<.05). RESULTS. Gluma, Smart Protect and Nd:YAG laser treatments showed comparable microtensile bond strengths compared with the control group (P>.05). The microtensile bond strengths of Aqua-Prep F, and Cervitec Plus were similar to each other but significantly lower than the control group (P<.05). Bisblock showed the lowest microtensile bond strength among all groups (P<.001). Most groups showed adhesive failure. CONCLUSION. Within the limitation of this study, it is not recommended to use Aqua-prep F, Cervitec Plus and Bisblock on dentin when used with a self-adhesive resin cement due to the decrease they cause in bond strength. Beside, pre-treatment of dentin with Gluma, Smart protect, and Nd:YAG laser do not have a negative effect.

참고문헌 (49)

  1. Felton DA., "Evaluation of the desensitizing effect of Gluma Dentin Bond on teeth prepared for complete-coverage restorations", Int J Prosthodont, 4, pp.292~298 (1991)
  2. Brännström M., "The hydrodynamics of the dentine; its possible relationship to dentinal pain", Int Dent J, 22, pp.219~227 (1972)
  3. Gillam DG., "Current diagnosis of dentin hypersensitivity in the dental office: an overview", Clin Oral Investig, 17, pp.S21~S29 (2013)
  4. Miglani S., "Dentin hypersensitivity : Recent trends in management", J Conserv Dent, 13, pp.218~224 (2010)
  5. Dondi dall’Orologio G., "Dentin desensitizing effects of Gluma Alternate, HealthDent Desensitizer and Scotchbond Multi-Purpose", Am J Dent, 12, pp.103~106 (1999)
  6. Pillon FL., "Effect of a 3% potassium oxalate topical application on dentinal hypersensitivity after subgingival scaling and root planing", J Periodontol, 75, pp.1461~1464 (2004)
  7. Gaffar A., "Treating hypersensitivity with fluoride varnish", Compend Contin Educ Dent, 20, pp.27~33 (1999)
  8. Dondi dall’Orologio G., "Clinical evaluation of the role of glutardialdehyde in a one-bottle adhesive", Am J Dent, 15, pp.330~334 (2002)
  9. Orchardson R., "Managing dentin hypersensitivity", J Am Dent Assoc, 137, pp.990~998 (2006)
  10. Fardal O., "A review of the literature on use of chlorhexidine in dentistry", J Am Dent Assoc, 112, pp.863~869 (1986)
  11. Wara-aswapati N., "The effect of a new toothpaste containing potassium nitrate and triclosan on gingival health, plaque formation and dentine hypersensitivity", J Clin Periodontol, 32, pp.53~58 (2005)
  12. Kimura Y., "Treatment of dentine hypersensitivity by lasers : a review", J Clin Periodontol, 27, pp.715~721 (2000)
  13. Gholami GA., "An evaluation of the occluding effects of Er;Cr : YSGG, Nd : YAG, CO2 and diode lasers on dentinal tubules : a scan ning electron microscope in vitro study", Photomed Laser Surg, 29, pp.115~121 (2011)
  14. Matsumoto K., "Laser therapy of dentin hypersensitivity", J Oral Laser Appl, 7, pp.7~25 (2007)
  15. Behr M., "Marginal adaptation in dentin of a self-adhesive universal resin cement compared with well-tried systems", Dent Mater, 20, pp.191~197 (2004)
  16. Prieto LT., "Influence of selective acid etching on microtensile bond strength of a self-adhesive resin cement to enamel and dentin", Braz J Oral Sci, 9, pp.455~458 (2010)
  17. De Munck J., "Bonding of an auto-adhesive luting material to enamel and dentin", Dent Mater, 20, pp.963~971 (2004)
  18. Hitz T., "Are self-adhesive resin cements a valid alternative to conventional resin cements? A laboratory study of the long-term bond strength", Dent Mater, 28, pp.1183~1190 (2012)
  19. Sarr M., "Immediate bonding effectiveness of contemporary composite cements to dentin", Clin Oral Investig, 14, pp.569~577 (2010)
  20. Gerth HU., "Chemical analysis and bonding reaction of RelyX Unicem and Bifix composites--a comparative study", Dent Mater, 22, pp.934~941 (2006)
  21. Fu B., "Evidence of chemical bonding to hydroxyapatite by phosphoric acid esters", Biomaterials, 26, pp.5104~5110 (2005)
  22. Nagakane K., "Analysis of chemical interaction of 4-MET with hydroxyapatite using XPS", Dent Mater J, 25, pp.645~649 (2006)
  23. Stawarczyk B., "The effect of dentin desensitizer on shear bond strength of conventional and self-adhesive resin luting cements after aging", Oper Dent, 36, pp.492~501 (2011)
  24. Hiraishi N., "Effect of 2% chlorhexidine on dentin microtensile bond strengths and nanoleakage of luting cements", J Dent, 37, pp.440~448 (2009)
  25. International Organization for Standardiation, "ISO TR 11405. Dental material guidence on testing of adhesion to tooth structure", ~ (1994)
  26. Di Hipólito V., "Effectiveness of self-adhesive luting cements in bonding to chlorhexidine-treated dentin", Dent Mater, 28, pp.495~501 (2012)
  27. Akca T., "The effect of desensitizing treatments on the bond strength of resin composite to dentin mediated by a self-etching primer", Oper Dent, 32, pp.451~456 (2007)
  28. Sailer I., "The effects of desensitizing resin, resin sealing, and provisional cement on the bond strength of dentin luted with self-adhesive and conventional resincements", J Prosthet Dent, 107, pp.252~260 (2012)
  29. Sailer I., "In vitro study of the influence of dentin desensitizing and sealing on the shear bond strength of two universal resin cements", J Adhes Dent, 12, pp.381~392 (2010)
  30. Stawarczyk B., "Impact of Gluma Desensitizer on the tensile strength of zirconia crowns bonded to dentin : an in vitro study", Clin Oral Investig, 16, pp.201~213 (2012)
  31. Munksgaard EC., "Bond strength between dentin and restorative resins mediated by mixtures of HEMA and glutaraldehyde", J Dent Res, 63, pp.1087~1089 (1984)
  32. Qin C., "Spectroscopic investigation of the function of aqueous 2-hydroxyethylmethacrylate", glutaraldehyde solution as a dentin desensitizer, 2006, pp.114, 354~359
  33. Nakabayashi N., "Dentin adhesion of"modified"4-META", MMA-TBB resin : function of HEMA, 1992, pp.8, 259~264
  34. Arrais CA., "Effects of desensitizing agents on dentinal tubule occlusion", J Appl Oral Sci, 12, pp.144~148 (2004)
  35. Kolker JL., "Effect of desensitizing agents on dentin permeability and dentin tubule occlusion", J Adhes Dent, 4, pp.211~221 (2002)
  36. Dündar M., "Influence of fluoride-or triclosan-based desensitizing agents on adhesion of resin cements to dentin", Clin Oral Investig, 14, pp.579~586 (2010)
  37. Pashley EL., "Effects of oxalate on dentin bonding", Am J Dent, 6, pp.116~118 (1993)
  38. De Andrade e Silva SM., "Effect of oxalate desensitizer on the durability of resinbonded interfaces", Oper Dent, 35, pp.610~617 (2010)
  39. Pashley DH., "The use of oxalate to reduce dentin permeability under adhesive restorations", Am J Dent, 14, pp.89~94 (2001)
  40. Tay FR., "Integrating oxalate desensitizers with total-etch two-step adhesive", J Dent Res, 82, pp.703~707 (2003)
  41. Aranha AC., "Microtensile bond strengths of composite to dentin treated with desensitizer products", J Adhes Dent, 8, pp.85~90 (2006)
  42. Pisani-Proença J., "Influence of different surface conditioning protocols on microtensile bond strength of self-adhesive resin cements to dentin", J Prosthet Dent, 105, pp.227~235 (2011)
  43. Breschi L., "Chlorhexidine stabilizes the adhesive interface : a 2-year in vitro study", Dent Mater, 26, pp.320~325 (2010)
  44. Santos MJ., "Effect of dentin-cleaning techniques on the shear bond strength of selfadhesive resin luting cement to dentin", Oper Dent, 36, pp.512~520 (2011)
  45. Lin J., "Influence of peripheral enamel bonding and chlorhexidine pretreatment on resin bonding to dentin", J Adhes Dent, 15, pp.351~359 (2013)
  46. Al-Saud LM., "Occluding effect of Nd : YAG laser and different dentin desensitizing agents on human dentinal tubules in vitro : a scanning electron microscopy investigation", Oper Dent, 37, pp.340~355 (2012)
  47. Kumar NG., "Short-term assessment of the Nd : YAG laser with and without sodium fluoride varnish in the treatment of dentin hypersensitivity--a clinical and scanning electron microscopy study", J Periodontol, 76, pp.1140~1147 (2005)
  48. de Oliveira MT., "Influence of Diamond SonoAbrasion, Air-Abrasion and Er : YAG Laser Irradiation on Bonding of Different Adhesive Systems to Dentin", Eur J Dent, 1, pp.158~166 (2007)
  49. "RelyXTM U200. Self-Adhesive Resin Cement, Technical Data Sheet", 3M ESPE, ~

관련 논문AI추천

이 간행물의 다른 논문 (12건)