Examining engineering performance of midwater trawl with different horizontal spread ratio, floatage, and weight parameters: A case study of model net for Antarctic krill fisheries
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
It is necessary to investigate the effectiveness of the midwater trawl in reducing fuel consumption and increasing catch performance for the development and improvement of the Antarctic krill fisheries. A 1/ 35 scale trawl model for Antarctic krill fisheries was designed based on modified Tauti's law and tested in a flume tank, and the effects of flow velocity, horizontal spread ratio, sinking force, and the ratio of buoyancy to fishing line weight on its engineering performance were analyzed in this study. The results indicated that the lower flow velocity and the ratio of buoyancy to fishing line weight conducted to the greater hydrodynamic forces and geometrical performances. The higher horizontal spread ratio and sinking force were found to have exhibited the greater drag force, net mouth opening, wing-end spread, bridle angle, net mouth area, swept area, and volume covered by trawl net. It was revealed that the engineering performance of the midwater trawl (minimal ratio between drag and swept area) was efficient when the horizontal spread ratio was at 0.55 (corresponding to the trawl horizontal opening of 64.65 m in full-scale), the sinking force was at 97.96 g (600 kg of full-scale), and the ratio of buoyancy to fishing line weight was at 4.2 and 2.6 compared to those actually used during Antarctic krill fishing. In addition, the study demonstrated that the modification of the horizontal spread ratio, sinking force, and the ratio of buoyancy to fishing line weight can be one alternative to improve the geometrical shape performance of the midwater trawl net that could improve catchability of the trawl net.
Abstract
It is necessary to investigate the effectiveness of the midwater trawl in reducing fuel consumption and increasing catch performance for the development and improvement of the Antarctic krill fisheries. A 1/ 35 scale trawl model for Antarctic krill fisheries was designed based on modified Tauti's law and tested in a flume tank, and the effects of flow velocity, horizontal spread ratio, sinking force, and the ratio of buoyancy to fishing line weight on its engineering performance were analyzed in this study. The results indicated that the lower flow velocity and the ratio of buoyancy to fishing line weight conducted to the greater hydrodynamic forces and geometrical performances. The higher horizontal spread ratio and sinking force were found to have exhibited the greater drag force, net mouth opening, wing-end spread, bridle angle, net mouth area, swept area, and volume covered by trawl net. It was revealed that the engineering performance of the midwater trawl (minimal ratio between drag and swept area) was efficient when the horizontal spread ratio was at 0.55 (corresponding to the trawl horizontal opening of 64.65 m in full-scale), the sinking force was at 97.96 g (600 kg of full-scale), and the ratio of buoyancy to fishing line weight was at 4.2 and 2.6 compared to those actually used during Antarctic krill fishing. In addition, the study demonstrated that the modification of the horizontal spread ratio, sinking force, and the ratio of buoyancy to fishing line weight can be one alternative to improve the geometrical shape performance of the midwater trawl net that could improve catchability of the trawl net.
참고문헌 (50)
- Balash, C., "The effect of mesh orientation on netting drag and its application to innovative prawn trawl design", Fish. Res, 164, pp.206~213 (2015)
- Balash, C., "Prawn trawl drag due to material properties an investigation of the potential for drag reduction", Proceedings of the 2nd International Symposium on Fishing Vessel Energy Efficiency E-Fishing, pp.9~ (2012)
- Balash, C., "Prawn Trawl Shape Due to Flexural Rigidity and Hydrodynamic Forces", 박사, pp.2012
- Bdioui, M., "Adaptation et essai d’un chalut pelagique a tres grandes mailles a quatre faces egales pour une puissance de 650", bull. de l'inst. Nat.Scien. et tech. Mer. Salammbo, 36(1-11) (2009)
- Bdioui, M., "Conception, confection et essai dun chalut pelagique a cordes paralleles pour une puissance de 500 chevaux vapeur", Bull. Inst. Natn. Scien. Tech. Mer de Salammbo, 43, pp.9~20 (2016)
- Cashiona, T., "Reconstructing global marine fishing gear use: catches and landed values by gear type and sector", Fish. Res, 206, pp.57~64 (2018)
- Dickson, W., "A study relating models to commercial trawls", Mar. Res. Dep. Agric. Fish. Scotl, 1, pp.1~48 (1961)
- Eayrs, S., "A New Approach to Fishing Power Analysis and its Application in the Northern Prawn Fishery", pp.36~ (2003), Fisheries Research Development Corporation Project
- Feng, C., "Structure improvement design and performance experiment of Antarctic krill trawl net", Trans. Chin. Soc. Agric. Eng, 33(7), pp.75~81 (2017)
- Feng, C. L., "Performance optimization of a trawl for Antarctic krill", J. Fish. Sci. China, 24(1), pp.1~2 (2012)
- Fiorentini, L., "Comparison between model testing and full-scale trials of new trawl design for Italian bottom fisheries", Fish. Sci, 70, pp.349~359 (2004)
- Fridman, "Published by arrangement with the Food and Agriculture Organization of the United Nations by Fishing News" (1986), Farnham
- Higo, N., "Fundamental studies on the fishing efficiencies of trawling nets Mem", Fac. Fish. Kagoshima Univ, 20(2), pp.1~137 (1970)
- Hu, Fuxiang, "Estimation of the drag of midwater trawl net", J. Tokyo Univ. Fish, 78, pp.19~25 (1991)
- Hu, Fuxiang, "Dynamic analysis of midwater trawl system by a two-dimensional lumped mass method", Fish. Sci, 61(2), pp.229~233 (1995)
- Hu, F., "Effects of drag coefficient of netting for dynamic similarity on model testing of trawl nets", Fish. Sci, 67, pp.84~89 (2001)
- Itaya, K., "Effect of towing speed and net mouth size on catch efficiency in framed midwater trawls", Fish. Sci, 73, pp.1007~1016 (2007)
- Juza, T., "The influence of the trawl mouth opening size and net colour on catch efficiency during sampling of early fish stages", Fish. Res, 105, pp.125~133 (2010)
- Lee, J., "Development of a low-energy midwater trawl with different combinations of trawl nets and trawl doors through model experiments", Fish. Sci, 84, pp.323~334 (2018)
- Li, L. Z., "Performance analysis of the four-panel mid-water trawl for Antarctic krill fishery", J. Fish. Sci. China, 24(4), pp.893~901 (2017)
- MacLennan, D., "The drag of four panel demersal trawls", Fish. Res, 1, pp.23~33 (1981)
- Nguyen, T. X., "Computer simulation and flume tank testing of scale engineering models: how well do these techniques predict full-scale at-sea performance of bottom trawls?", Fish. Res, 161, pp.217~225 (2015)
- Nicol, S., "Biology and Ecology of Antarctic Krill", pp.387~421 (2016), Springer International Publishing
- Njomoue, P. A., "Predictive models for codend size selectivity for the arioma bondi silver-rag driftfish (Ariommatidae) in the Cameroonian bottom trawl fisheries: effects of mesh size on the size selection", Int. J. Fish. Aquat. Res, 5(4), pp.13~22 (2020)
- Park, H. H., "A method for estimating the gear shape of a mid-water trawl", Ocean. Eng, 34(3), pp.470~478 (2007)
- Park, H. H., "The geometry gear shape of a bottom trawl", Ocean. Eng, 89, pp.53~61 (2014)
- Priour, D., "Numerical optimization of trawls design to improve their energy efficiency", Fish. Res, 98(3), pp.40~50 (2009)
- A Net Drag Formula for Pelagic Nets, "Reid, J.Aenea", Scottish Fisheries Research, ~, pp.Report number 7 (1977)
- Ruangpan, S., "Model experiments on the physical characteristics of the Thai shrimp trawl gear", Mem. Kagoshima Univ Res, 3, pp.56~73 (1983)
- Sala, A., "Maritime Industry, Ocean Engineering and Coastal Resources", pp.961~964 (2008), Taylor & Francis Group
- Satyanarayana, A. V. V., "Preliminary studies on the characteristics of otter trawls-horizontal opening and towing resistance", Indian J. Fish, 9(2), pp.133~144 (1962)
- Somerton, D. A., "The effect of speed through the water on foot rope contact of a survey trawl", Fish. Res, 53, pp.17~24 (2001)
- Somerton, D. A., "Whole-gear efficiency of a benthic survey trawl for flatfish", Fish. Bull, 105, pp.278~291 (2007)
- Sterling, D., "Engineering and catching performance of five netting materials in commercial prawn-trawl systems", Fish. Res, 193, pp.17~24 (2017)
- Tang, H., "Flume tank evaluation on the effect of liners on the physical performance of the Antarctic krill trawl. Front", Front. Mar. Sci, 8, pp.829615~ (2022)[DOI]
- Thierry, N. N. B., "Effect of mesh size, twine material and trawl gear accessories on the bottom trawls hydrodynamic performance", Int. J. Fish. Aquat. Res, 4, pp.1~9 (2019)
- Thierry, B. N. N., "Hydrodynamic performance of bottom trawls with different materials, mesh sizes, and twine thicknesses", Fish. Res, 221, pp.105403~ (2020)
- Thierry, B. N. N., "Comparative study on the full-scale prediction performance of four trawl nets used in the coastal bottom trawl fishery by flume tank experimental investigation", Appl. Ocean Res, 95, pp.102022~ (2020)
- Thierry, N. N. B., "Comparison between physical model testing and numerical simulation using two-way fluid-structure interaction approach of new trawl design for coastal bottom trawl net", Ocean Eng, 233(2021), pp.109112~ (2021)[DOI]
- Thierry, N. N. B., "Identifying the turbulent flow developing inside and around the bottom trawl by Electromagnetic Current Velocity Meter approach in the flume tank", J. Hydrodyn, 33, pp.636~656 (2021)[DOI]
- Thierry, B. N. N., "Experimental and numerical investigations of the hydrodynamic characteristics, twine deformation, and flow field around the netting structure composed of two types of twine materials for midwater trawls", J. Ocean Univ. China, 20, pp.1215~1235 (2021)[DOI]
- Thierry, B. N. N., "Unsteady turbulent flow developing inside and around different parts of fluttering trawl net in flume tank", J. Fluid Struct, 108(2-3), pp.103451~ (2022)[DOI]
- Wan, R., "Hydrodynamic performance of a newly-designed Antarctic krill trawl using numerical simulation and physical modeling methods", Ocean Eng, 179, pp.173~179 (2019)
- Wan, R., "Effects of otter board and cable length on hydrodynamic performance of Antarctic krill trawl system", Ocean Eng, 236, pp.109408~ (2021)
- Weinberg, K. L., "Change in the performance of a Bering Sea survey trawl due to varied trawl speed", Alaska Fish. Res. Bull, 10(1), pp.42~49 (2003)
- Wileman, D., "Estimation of the Drag of Trawls of Known Geometry, The Danish Institute of Fisheries Technology and Aquaculture", ~ (1988)
- Xu, L. X., "Fishing Gear Theory and Design" (2004), China Agriculture Press
- Xu, P. X., "Comparative analysis on the performance of Japan and South Korea Antarctic krill mid-water trawls with small mesh sizes", J. Fish. Sci. China, 22(4), pp.837~846 (2015)
- You, X., "Effect of wingtip flow on hydrodynamic characteristics of cambered otter board", Ocean Eng, 222, pp.108611~ (2021)
- Zhou, Y. Q., "Study on Drag Characteristics of Trawl Nets and a Method for the Calculation Trawl Net Drag", Selected Papers Presented to the Marine Fishing Academic Seminar. the Chinese Society of Fisheries, pp.82~92 (1982)
