플랜지 케이스의 입구온도 경계조건에 따른 케이스 내부의 열적거동에 관한 연구
A Study on the Thermal Behavior at the Case Inner According to Inlet Port Temperature Boundary Conditions of a Flange Case
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
In this study, the thermal behavior characteristics of flange case interior were analyzed by the numerical method. The boundary conditions at the inlet port of flange case were the heat flux and heat flux time. As the heat flux time at inlet of case increased, the temperature values gradually increased, and the degree of increase was very small. If the heat flux of the melted iron increases to 2,000,000W/m2, the temperature change at the case interior will occur largely, causing heat deformation. As a result, in order to reduce thermal defects at the case interior, the heat flux and heat flux time of the melted iron should be set within 500,000W/m2 and 5 seconds, respectively.
Abstract
In this study, the thermal behavior characteristics of flange case interior were analyzed by the numerical method. The boundary conditions at the inlet port of flange case were the heat flux and heat flux time. As the heat flux time at inlet of case increased, the temperature values gradually increased, and the degree of increase was very small. If the heat flux of the melted iron increases to 2,000,000W/m2, the temperature change at the case interior will occur largely, causing heat deformation. As a result, in order to reduce thermal defects at the case interior, the heat flux and heat flux time of the melted iron should be set within 500,000W/m2 and 5 seconds, respectively.
참고문헌 (9)
- 고동국, "용탕조건에 따른 상용 차량용 어댑터 하우징의 열적특성에 관한 연구", 한국기계기술학회지, 20(6), pp.745~750 (2018), 한국기계기술학회[DOI]
- 고동국, "탄소복합재 브레이크 디스크의 통풍구 형상에 따른 유동특성에 관한 해석적 연구", 한국자동차공학회 논문집, 23(2), pp.191~198 (2015), 한국자동차공학회[DOI]
- T. R. Vijayaram, "Num-erical simulation of casting solidification in permanent metallic molds", Journal of Materials Processing Technology, 178, pp.29~33 (2006)
- S. V. Shepel, "Numerical simulation of filling and solidification of permanent mold casings", Applied Therm-al Engineering, 22, pp.229~248 (2002)
- O. Richmond, "Theory of Thermal Stress and Air-Gap Formation during the Early Stages of Solidification in a Rectangular Mold", Journal of Mechanical Physics and Solids, 19, pp.273~284 (1971)
- 박창선, "차량의 연료압력 레귤레이터 성형해석", 한국생산제조학회지, 20(2), pp.151~156 (2011), 한국생산제조학회
- 고동국, "타이어 몰드 표면에서의 열유속 및 열전달 시간에 따른 몰드의 온도분포에 관한 수치해석 연구", 한국기계기술학회지, 18(6), pp.893~898 (2016), 한국기계기술학회[DOI]
- ANSYS Co, "ANSYS Fluent User's Guide 16.0", ~
- "KS D 2331:2009, Aluminium alloy ingots for die casting", Korean Agency for Technology and Standards, ~ (2015)