원형 공기 충돌분류에 의한 평판에서의 열전달 특성에 대한 실험적 연구
Experimental Investigation of Heat Transfer Characteristics on a Flat Surface by Circular Air Jet Impingement
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
An experimental investigation is performed to study the effect of jet to plate spacing and low Reynolds number on the local heat transfer distribution to normally impinging submerged circular air jet on a smooth and flat surface. A single jet from a straight circular nozzle of length to diameter ratio() of 83 is tested. Reynolds number based on nozzle exit condition is varied between 500 and 8,000 and jet to plate spacing between 0.5 and 8 nozzle diameter. The local het transfer characteristics are obtained using thermal images from infrared thermal imaging technique. It was observed that at lower Reynolds numbers, the effect of jet to plate distances covered during the study on the stagnation point Nusselt numbers is minimal. At all jet to plate distances, the stagnation point Nusselt numbers decrease monotonically with the maximum occurring at a z/d of 0.5 as opposed to the stagnation point Nusselt numbers at high Reynolds numbers which occur around a z/d of 6.
Abstract
An experimental investigation is performed to study the effect of jet to plate spacing and low Reynolds number on the local heat transfer distribution to normally impinging submerged circular air jet on a smooth and flat surface. A single jet from a straight circular nozzle of length to diameter ratio() of 83 is tested. Reynolds number based on nozzle exit condition is varied between 500 and 8,000 and jet to plate spacing between 0.5 and 8 nozzle diameter. The local het transfer characteristics are obtained using thermal images from infrared thermal imaging technique. It was observed that at lower Reynolds numbers, the effect of jet to plate distances covered during the study on the stagnation point Nusselt numbers is minimal. At all jet to plate distances, the stagnation point Nusselt numbers decrease monotonically with the maximum occurring at a z/d of 0.5 as opposed to the stagnation point Nusselt numbers at high Reynolds numbers which occur around a z/d of 6.
참고문헌 (13)
- 김은영, "평판에서의 충돌 자유 수분류 열전달에 관한 실험적 연구", 한국기계기술학회지, 19(1), pp.63~70 (2017), 한국기계기술학회[DOI]
- 김은영, "평판 상에서 경사 분류열 부근의 유동에 대한 실험적 연구", 한국기계기술학회지, 13(2), pp.39~44 (2011), 한국기계기술학회
- Impingement heat transfer from turbulent air jets to flat plates, "Livingood JNB", NASA, ~, pp.NASA TM X-2778 (1970)
- Martin H, "Heat and mass transfer between impinging gas jets and solid surface", Adv. Heat Transfer, (13), pp.1~60 (1977)
- Jambunathan K, "A review of heat transfer data for single circular jet impingement", Int. J. Heat Fluid Flow, (13), pp.106~115 (1992)
- Viskanta R, "Heat Transfer to impinging isothermal gas and flame jets", Exp. Thermal Fluid Sci, (6), pp.111~134 (1993)
- Gardon R., "Heat Transfer between a flat plate and jets of air Impinging on it", Int. Develop Heat Transfer ASME, pp.454~460 (1962)
- Gardon R., "The role of turbulence in determining the heat transfer characteristics of impinging jets", Int. J. Heat Mass Transfer, (8), pp.1261~1272 (1965)
- Lytle D., "Air Jet impinging heat transfer at low nozzle plate spacings", Int. J. Heat Mass Transfer, (37), pp.1687~1697 (1994)
- Huang L., "Heat transfer of an impinging jet on a flat surface", Int. J. Heat Mass Transfer, (37), pp.1915~1923 (1994)
- Lee D. H., "The effect of nozzle diameter on impinging jet heat transfer and fluid flow", J. Heat Transfer, (126), pp.554~557 (2004)
- Katti V., "Experimental study and theoretical analysis of local heat distribution between smooth flat surface and impinging air jet from a circular straight pipe nozzle", Int. J. Heat Mass Transfer, (51), pp.4480~4495 (2008)
- Moffat R. J., "Describing the uncertainties in experimental results", Exp. Thermal Fluid Sci, (1), pp.3~17 (1988)