Structural and Morphological Changes of Co Nanoparticles and Au-10at.%Pd Thin Film Studied by in Situ Heating in a Transmission Electron Microscope
2
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
The microstructural changes in Co nanoparticles and an Au-10at.%Pd thin film have been investigated using an in situ heating holder with a micro-electro-mechanical system (MEMS). In Co nanoparticles, two phases (face-centered cubic and hexagonal close-packed crystal structures) were found to coexist at room temperature and microstructures at temperatures, higher than 1,000°C, were observed with a quick response time and significant stability. The actual temperature of each specimen was directly estimated from the changes in the lattice spacing (Bragg-peak separation). For the Au-10at.%Pd thin film, at a set temperature of 680°C, the actual temperature of the sample was estimated to be 1,020°C±123°C. Note that the specimen temperature should be carefully evaluated because of the undesired effects, i.e., the temperature non-uniformity due to the sample design of the MEMS chip, and distortion due to thermal expansion.
Abstract
The microstructural changes in Co nanoparticles and an Au-10at.%Pd thin film have been investigated using an in situ heating holder with a micro-electro-mechanical system (MEMS). In Co nanoparticles, two phases (face-centered cubic and hexagonal close-packed crystal structures) were found to coexist at room temperature and microstructures at temperatures, higher than 1,000°C, were observed with a quick response time and significant stability. The actual temperature of each specimen was directly estimated from the changes in the lattice spacing (Bragg-peak separation). For the Au-10at.%Pd thin film, at a set temperature of 680°C, the actual temperature of the sample was estimated to be 1,020°C±123°C. Note that the specimen temperature should be carefully evaluated because of the undesired effects, i.e., the temperature non-uniformity due to the sample design of the MEMS chip, and distortion due to thermal expansion.
참고문헌 (16)
- Allard L F, "A new MEMS-based system for ultra-high-resolution imaging at elevated temperature", Microscopy Research and Technique, 72, pp.208~215 (2009)
- Asoro M A, "In-situ transmission electron microscopy observation of sublimation in silver nanoparticles", J. ACS Nano, 7, pp.7844~7852 (2013)
- Bao Y, "Controlled crystalline structure and surface stability of cobalt nanocrystals", J. Phys. Chem. B, 109, pp.7220~7222 (2005)
- Barwick B, "4D imaging of transient structures and morphologies in ultrafast electron microsco", Science, 322, pp.1227~1231 (2008)
- Gontard L C, "Tomographic heating holder for in situ TEM: Study of Pt", C and PtPd, Microsc. Microanal, pp.2014, 20[DOI]
- Ivanov V, "Synthesis and dynamic compaction of ceramic nano powders by techniques based on electric pulsed power", Nanostructured Materials, 6, pp.287~290 (1995)
- Tae-Hoon Kim, "Temperature Calibration of a Specimen-heating Holder for Transmission Electron Microscopy", 한국현미경학회지, 45(2), pp.95~100 (2015), 한국현미경학회
- Chang Kyu Rhee, "Fabrication of Al Nano Powders by Pulsed Wire Evaporation (PWE) Method", Journal of Industrial and Engineering Chemistry, 9(1), pp.71~75 (2003), 한국공업화학회
- Matveev V V, "Cobalt nanoparticles with preferential hcp structure: a confirmation by X-ray diffraction and NMR", Chemical Physics Letters, 422, pp.402~405 (2006)
- Okamoto H, "The Au-Pd (Gold-Palladium)system", Bulletin of Alloy Phase Diagrams, 6, pp.229~235 (1985)
- Park H S, "4D ultrafast electron microscopy: imaging of atomic motions, acoustic resonances, and moire fringe dynamics", Ultramicroscopy, 110, pp.7~19 (2009)
- Saka H, "In situ heating transmission elecctron microscopy", J. MRS Bulletin, 33, pp.93~100 (2008)
- Seo W S, "Phase-and size-controlled synthesis of hexagonal and cubic CoO nanocrystals", J. Am. Chrm. Soc, 127, pp.6188~6189 (2005)
- Takeo K, "Development of a specimen heating holder with an evaporator and gas injector and its application for catalyst", Journal of Electron Microscopy, 55, pp.245~252 (2006)
- Yoo C, "The phase diagram of cobalt at high pressure and temperature: the stability of γ(fcc)-cobalt and new ε’(dhcp)-cobalt", J. Phys.: Condens. Matter, 10, pp.311~318 (1998)
- Zhang Z, "Behavior of TEM metal grids during in-situ heating experiment", Ultramicroscopy, 109, pp.766~774 (2009)