Multi-support excitation shaking table test of a base-isolated steel cable-stayed bridge
1
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
A series of tests was conducted for full-scale single-pylon asymmetric cable-stayed bridges using a system of multiple shaking tables. The 2-span bridge length was 28 m, and the pylon height was 10.2 m. 4 different base conditions were considered: the fixed condition, RB (rubber bearings), LRB (lead rubber bearings), and HDRB (high damping rubber bearings). Based on investigation of the seismic response, the accelerations and displacements in the axial direction of the isolated bridge were increased compared to non-isolated case. However, the strain of the pylon was decreased, because the major mode of the structure was changed to translation for the axial direction due to the dynamic mass. The response of the cable bridge could differ from the desired response according to the locations and characteristics of the seismic isolator. Therefore, caution is required in the design and prediction in regard to the location and behavior of the seismic isolator.
Abstract
A series of tests was conducted for full-scale single-pylon asymmetric cable-stayed bridges using a system of multiple shaking tables. The 2-span bridge length was 28 m, and the pylon height was 10.2 m. 4 different base conditions were considered: the fixed condition, RB (rubber bearings), LRB (lead rubber bearings), and HDRB (high damping rubber bearings). Based on investigation of the seismic response, the accelerations and displacements in the axial direction of the isolated bridge were increased compared to non-isolated case. However, the strain of the pylon was decreased, because the major mode of the structure was changed to translation for the axial direction due to the dynamic mass. The response of the cable bridge could differ from the desired response according to the locations and characteristics of the seismic isolator. Therefore, caution is required in the design and prediction in regard to the location and behavior of the seismic isolator.
참고문헌 (11)
- Ali HEM, "Seismic Passive Control of Cable-Stayed Bridges", Shock and Vibration, 2(4), pp.259~272 (1995)
- Soneji BB, "Passive hybrid systems for earthquake protection of cable-stayed bridge", Engineering Structures, 29(1), pp.57~70 (2007)
- Ali HEM, "Seismic energy dissipation for cablestayed bridges using passive devices", Earthquake Engineering and Structural Dynamics, 23(8), pp.877~893 (1994)
- Soneji BB, "Effectiveness of seismic isolation for cablestayed bridges", International Journal of Structural Stability and Dynamics, 6(1), pp.77~96 (2006)
- Godden WG, "Dynamic model studies of Ruck-A-Chucky Bridge", Journal of Structural Division. ASCE, 104(12), pp.1827~1844 (1978)
- Garevski MA, "Dynamic characteristics and seismic behavior of Jindo bridge South Korea", Structural Engineering Review, 1, pp.141~149 (1987)
- Wang J, "A brief introduction to the shaking-table test of Liede Bridge" (2006), Proceedings 4th PRC-US Workshop on Seismic Analysis and Design of Special Bridges: Advancing Bridge Technologies in Research, Design, Construction and Preservation
- Yang CY, "Shake Table Test of Cable-Stayed Bridge Subjected to Non-Uniform Excitation", Procedia Engineering, 14, pp.931~938 (2001)
- Shoji G, "Seismic response of a PC cable-stayed bridge subjected to a long-period ground motion", 14th WCEE (2008)
- Yang C, "Wave Propagation Effect on Seismic Response of Cable-stayed Bridge: A Multiple Shake Tables Test", 15th WCEE (2012)
- Zong Z, "Seismic response study on a multi-span cable-stayed bridge scale model under multi-support excitations", Part I : shaking table tests, Journal of Zhejiang University SCIENCE A, 15(5), pp.351~363 (2008)