MMO(Ti/Ru) 코팅된 타이타늄의 고분자 전해질 연료전지 양극환경에서의 전기화학적 거동
Electrochemical Characteristics of MMO(Ti/Ru)-Coated Titanium in a Cathode Environment of Polymer Electrolyte Membrane Fuel Cell
1
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
In this research, mixed metal oxide (TiO2, RuO2) coating was applied to grade 1 titanium as a bipolar plate for polymer electrolyte membrane fuel cell (PEMFC). Electrochemical experiments were carried out in an aqueous solution of pH 3 (H2SO4 + 0.1 ppm HF, 80 oC) determined by DoE. The air was bubbled to simulate a cathode environment. Potentiodynamic polarization test revealed that corrosion current densities of the titanium substrate and MMO-coated specimen were 0.180 μA/cm2 and 4.381 μA/cm2, respectively. There was no active peak. After potentiostatic experiment, current densities of the titanium substrate and the MMO-coated specimen were 0.19 μA/cm2 and 1.05 μA/cm2, respectively. As a result of observing the surface before and after the potentiostatic experiment, cracked dried clay structures were observed without corrosion damage. Both the titanium substrate and the MMO-coated specimen could not satisfy the interfacial contact resistance suggested by the DoE. Thus, further research is needed before they could be applied as bipolar plates.
Abstract
In this research, mixed metal oxide (TiO2, RuO2) coating was applied to grade 1 titanium as a bipolar plate for polymer electrolyte membrane fuel cell (PEMFC). Electrochemical experiments were carried out in an aqueous solution of pH 3 (H2SO4 + 0.1 ppm HF, 80 oC) determined by DoE. The air was bubbled to simulate a cathode environment. Potentiodynamic polarization test revealed that corrosion current densities of the titanium substrate and MMO-coated specimen were 0.180 μA/cm2 and 4.381 μA/cm2, respectively. There was no active peak. After potentiostatic experiment, current densities of the titanium substrate and the MMO-coated specimen were 0.19 μA/cm2 and 1.05 μA/cm2, respectively. As a result of observing the surface before and after the potentiostatic experiment, cracked dried clay structures were observed without corrosion damage. Both the titanium substrate and the MMO-coated specimen could not satisfy the interfacial contact resistance suggested by the DoE. Thus, further research is needed before they could be applied as bipolar plates.
참고문헌 (23)
- Yun Wang, "Materials, technological status, and fundamentals of PEM fuel cells – A review", Materials Today, 32, pp.178~203 (2020), Elsevier BV[DOI]
- 신동호, "고분자 전해질 연료전지 양극 작동 환경에서 실험 시간 및 작동 전압 변수에 따른 316L 스테인리스강의 전기화학적 특성과 손상 거동", CORROSION SCIENCE AND TECHNOLOGY, 20(6), pp.451~465 (2021), 한국부식방식학회[DOI]
- 이재봉, "Corrosion characteristics and interfacial contact resistances of TiN and CrN coatings deposited by PVD on 316L stainless steel for polymer electrolyte membrane fuel cell bipolar plates", CORROSION SCIENCE AND TECHNOLOGY, 12(4), pp.171~178 (2013), 한국부식방식학회
- Tabbi Wilberforce, "Bipolar Plate Materials", Encyclopedia of Smart Materials, 2, pp.273~278 (2022), Elsevier[DOI]
- Tabbi Wilberforce, "Technical evaluation of proton exchange membrane (PEM) fuel cell performance – A review of the effects of bipolar plates coating", Renewable and Sustainable Energy Reviews, 113, pp.109286~ (2019), Elsevier BV[DOI]
- Biddyut Paul, "PEM unitised reversible", regenerative hydrogen fuel cell systems: State of the art and technical challenges, 2017, pp.79, 585~599[DOI]
- Y. Wang, "An investigation on metallic bipolar plate corrosion in simulated cathode and cathode environments of PEM fuel cells using potentialpH diagrams", International Journal of Electrochemical Science, 1, pp.447~ (2006)[DOI]
- H. Tawfik, "Metal bipolar plates for PEM fuel cell—A review", Journal of Power Sources, 163(2), pp.755~767 (2007), Elsevier BV[DOI]
- W.R. Jacob, "Impressed-current Anodes", Shreir's Corrosion, 4, pp.2781~2800 (2010), Elsevier[DOI]
- Weiyi Wu, "Recent development of mixed metal oxide anodes for electrochemical oxidation of organic pollutants in water", Applied Catalysis A: General, 480, pp.58~78 (2014), Elsevier BV[DOI]
- D. Y. Chang, "Preparation and Characterization of Insoluble cathodes for Electrodeposition of Ni-W Alloys in Ammoniacal Citrate Bath", Journal of Surface Science and Engineering, 32, pp.686~ (1999)[DOI]
- H Wang, "Stainless steel as bipolar plate material for polymer electrolyte membrane fuel cells", Journal of Power Sources, 115(2), pp.243~251 (2003), Elsevier BV[DOI]
- Mi-Kyung Han, "Massive Transformation in Titanium-Silver Alloys and Its Effect on Their Mechanical Properties and Corrosion Behavior", Materials, 7(9), pp.6194~6206 (2014), MDPI AG[DOI]
- Mi-Kyung Han, "Effect of Indium Content on the Microstructure, Mechanical Properties and Corrosion Behavior of Titanium Alloys", Metals, 5(2), pp.850~862 (2015), MDPI AG[DOI]
- K.T. Jacob, "Phase Diagram for the System RuO2-TiO2 in Air", Journal of Phase Equilibria and Diffusion, 29(2), pp.136~140 (2008), Springer Science and Business Media LLC[DOI]
- W. A. Gerrard, "Microstructural investigations on mixed RuO2-TiO2 coatings", Journal of Applied Electrochemistry, 8(5), pp.417~425 (1978), Springer Science and Business Media LLC[DOI]
- Hong Hanh Pham, "Nanosized IrxRu1−xO2 electrocatalysts for oxygen evolution reaction in proton exchange membrane water electrolyzer", Advances in Natural Sciences: Nanoscience and Nanotechnology, 6(2), pp.025015~ (2015), IOP Publishing[DOI]
- Mona Goudarzi, "The Effect of Layer Number on the Nanostructural Ternary Mixed Oxide Containing Ti, Ru and Ir on Titanium", Advanced Materials Research, 829, pp.638~642 (2013), Trans Tech Publications, Ltd.[DOI]
- C.L.P.S. Zanta, "Electrochemical behaviour of olefins: oxidation at ruthenium–titanium dioxide and iridium–titanium dioxide coated electrodes", Journal of Applied Electrochemistry, 30(4), pp.467~474 (2000), Springer Science and Business Media LLC[DOI]
- Laurence D. Burke, "The electrochemical behaviour of RuO2-based mixed-oxide anodes in base", Journal of Electroanalytical Chemistry and Interfacial Electrochemistry, 109(1-3), pp.199~212 (1980), Elsevier BV[DOI]
- César Augusto D. Rodrigues, "Effect of titanium nitride (TiN) on the corrosion behavior of a supermartensitic stainless steel", Materials and Corrosion, 70(1), pp.28~36 (2018), Wiley[DOI]
- Jun Bi, "Development and evaluation of nitride coated titanium bipolar plates for PEM fuel cells", International Journal of Hydrogen Energy, 46(1), pp.1144~1154 (2021), Elsevier BV[DOI]
- Mona Goudarzi, "A study on ternary mixed oxide coatings containing Ti, Ru, Ir by sol–gel method on titanium", Journal of Sol-Gel Science and Technology, 73(2), pp.332~340 (2014), Springer Science and Business Media LLC[DOI]