본문 바로가기
KERD
논문KCI 등재

Influence of Carbonization Conditions in Hydrogen Poor Ambient Conditions on the Growth of 3C-SiC Thin Films by Chemical Vapor Deposition with a Single-Source Precursor of Hexamethyldisilane

1

조회

0

다운로드

0

인용

0

참고문헌

키워드

주제분류공학일반

초록

This paper describes the characteristics of cubic silicon carbide (3C-SiC) films grown on a carbonized Si(100) substrate, using hexamethyldisilane (HMDS, Si2(CH3)6) as a safe organosilane single precursor in a nonflammable H2/Ar (H2 in Ar) mixture carrier gas by atmospheric pressure chemical vapor deposition (APCVD) at 1280°C. The growth process was performed under various conditions to determine the optimized growth and carbonization condition. Under the optimized condition, grown film has a single crystalline 3C-SiC with well crystallinity, small voids, low residual stress, low carrier concentration, and low RMS. Therefore, the 3C-SiC film on the carbonized Si (100) substrate is suitable to power device and MEMS fields.

Abstract

This paper describes the characteristics of cubic silicon carbide (3C-SiC) films grown on a carbonized Si(100) substrate, using hexamethyldisilane (HMDS, Si2(CH3)6) as a safe organosilane single precursor in a nonflammable H2/Ar (H2 in Ar) mixture carrier gas by atmospheric pressure chemical vapor deposition (APCVD) at 1280°C. The growth process was performed under various conditions to determine the optimized growth and carbonization condition. Under the optimized condition, grown film has a single crystalline 3C-SiC with well crystallinity, small voids, low residual stress, low carrier concentration, and low RMS. Therefore, the 3C-SiC film on the carbonized Si (100) substrate is suitable to power device and MEMS fields.

참고문헌 (19)

  1. J. B. Casady, "Status of silicon carbide as a wide-bandgap semiconductor for hightemperature applications: A review", Solid State Electron, 39, pp.1409~1422 (1996)
  2. A. Elasser, "Silicon carbide benefits and advantages for power electronics circuits and systems", Proc. IEEE, 90, pp.969~986 (2002)
  3. M. Mehregany, "Silicon carbide for microelectromechanical systems", Inter. Mater. Rev, 45, pp.85~108 (2000)
  4. M. Bhatnagar, "Comparison of 6HSiC, 3C-SiC, and Si for power devices", IEEE Trans. Electron Dev, 40, pp.645~655 (1993)
  5. A. R. Hefner, "High-power modular multilevel converters with SiC JFETs", IEEE Trans. Power Electron, 16, pp.273~280 (2010)
  6. H. Okumura, "Present status and future prospect of widegap semiconductor high-power devices", Jpn. J. Appl. Phys, 45, pp.7565~7586 (2006)
  7. S. Nishino, "Production of large-area single-crystal wafers of cubic SiC for semiconductor devices", Appl. Phys. Lett, 42, pp.460~463 (1982)
  8. N. Kubo, "Growth of SiC films using tetraethylsilane", Mater. Sci. Forum, pp.269~273 (2004)
  9. K. Takahashi, "Lowtemperature growth of 3C-SiC on Si substrate by chemical vapor deposition using hexamethyldisilane as a source material", J. Electrochem. Soc, 139, pp.3565~3571 (1992)
  10. N. Nordell, "Growth of SiC using hexamethyldisilane in a hydrogen-poor ambient", Appl. Phys. Lett, 64, pp.1647~1649 (1994)
  11. C. H. Wu, "Epitaxial growth of 3C SiC on Si(111) from hexamethyldisilane", J. Cryst. Growth, 158, pp.480~490 (1996)
  12. A. J. Steckl, "Uniform ‚-SiC thin-film growth on Si by low pressure rapid thermal chemical vapor deposition", IEEE Trans. Electron Dev, 39, pp.64~66 (1992)
  13. N. Kubo, "Epitaxial growth of 3C-SiC on Si(111) using hexamethyldisilane and tetraethylsilane", Jpn. J. App. Phys, 43, pp.7654~7660 (2004)
  14. R. J. Iwanowski, "XPS and XRD study of crystalline 3CSiC grown by sublimation method", J. Allowys Compd, 286, pp.143~147 (1999)
  15. G. Ferro, "Hexamethyldisilane", propane versus silane, Semicond. Sci. Tech, pp.2003, 18[DOI]
  16. W. L. Zhu, "Spatially resolved Raman spectroscopy evaluation of residual stresses in 3C-SiC layer deposited on Si substrates with different crystallographic orientations", Appl. Surf. Sci, 252, pp.2346~2354 (2006)
  17. A. Severino, "Structural defects in (100) 3C-SiC heteroepitaxy: Influence of the buffer layer morphology on generation and propagation of stacking faults and micro twins", Diam. Relat. Mater, 18, pp.1440~1449 (2009)
  18. J. H. Boo, "Grwoth of TiO2 thin films on Si(100) substrates using single molecular presursors by metal organic chemical capor deposition", Surf. Coat. Tech, 131, pp.88~92 (2000)
  19. C. D. Stinespring, "Surface studies relevant to silicon carbide chemical vapor deposition", J. Appl. Phys, 65, pp.1733~1742 (1989)

관련 논문AI추천

이 간행물의 다른 논문 (11건)