PDMS 기판상에 금속층의 안정적 증착 및 패터닝
The stable e-beam deposition of metal layer and patterning on the PDMS substrate
0
조회
0
다운로드
1
인용
0
참고문헌
초록
Abstract
In this paper, we proposed the fabrication process of the stable e-beam evaporation and the patterning of metals layer on the polydimethylsiloxane (PDMS) substrate. The metal layer was deposited under the various deposition rate, and its effect to the electrical and mechanical properties (e.g.: adhesion-strength of metal layer) was investigated. The influence of surface roughness to the adhesion-strength was also examined via the tape test. Here, we varied the roughness by changing the reactive ion etching (RIE) duration. The electrode patterning was performed through the conventional photolithography and chemical etching process after e-beam deposition of 200 Ti and 1000 Au. As a result, the adhesion strength of metal layer on the PDMS surface was greatly improved by the oxygen plasma treatment. The e-beam evaporation on the PDMS surface is known to create the wavy topography. Here, we found that such wavy patterns do not effect to the electrical and mechanical properties. In conclusion, the metal patterns with minimum 20m line width was produced well via the our fabrication process, and its electrical conductance was almost similar to the that of metal patterns on the silicon or glass substrates.
참고문헌 (12)
- N. Pavei, "Homer II-man-machine interface to internet for blind and visually impaired people", 26(5), pp.438~443 (2003)
- S. M. Lawrence, "Fabrication and characteristics of an implantable, polymer-based, intrafascicular electrode", 131, pp.9~26 (2003)
- T. Schanzea, "Implantation and testing of subretinal film electrodes in domestic pigs", in press
- K. Lee, "Polyimide based neural implants with stiffness improvement", 102(1), pp.67~72 (2004)
- Y. Matsubara, "Application of on-chip cell cultures for the detection of allergic response Biosens. Bioelectron.", (7), pp.741~747 (2004)
- J. Y. Baek, "A pneumatically controllable flexible and polymeric microfluidic valve fabricated via in situ development J. Micromech. Microeng.", (5), pp.1015~1020 (2005)
- 고용득, "SF6와 SF6-N2 가스를 이용한 텅스텐 박막의 플라즈마 식각에 관한 연구", 8(3), pp.291~297 (1999)
- N. Bowden, "Spontaneous formation of ordered structures in thin films of metals supported on an elastomeric polymer", 393(6681), pp.146~149 (1998)
- G. C. Martin,T. T. Su,I. H. Loh,E. Balizer,S. T. Kowel,and P. Kornreich, "The metallization of silicone polymers in the rubbery and the glassy state", 53(1), pp.797~799 (1982)
- S. Wagner, "Electronic skin: architecture and components", 25(2-3), pp.326~334 (2004)
- G. Y. Ahn, "Magnetoresistance and surface properties with deposition condition for La-Sr-Mn-O thin films Phys. Stat. Sol. B", (7), pp.1561~1564 (2004)
- 정귀상, "측온저항체 온도센서용 Pt-Co 합금박막의 증착과 특성에 관한 연구", 7(1), pp.45~50 (1998)