탄소섬유의 게이지 계수 측정 및 센서 응용
Measurement of a gauge factor of a carbon fiber and its application to sensors
1
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In this paper we report on the electrical properties of carbon fiber which is an attractive material for strain gauges and can also be applied to resonating micro sensors. The carbon fibers used in this research was manufactured from polyactylonitrile (PAN). The fabricated carbon fibers had about 10 μm in length and several centimeters in length. We employed a micro structure to measure electrical properties of the carbon fiber. The measured electrical resistivity of the carbon fibers were about 3×10−3 Ω·cm. A gauge factor of the carbon fiber is also observed with the same system and it was about 400, depending on the structure of the carbon fiber. For the sensor applications of the carbon fiber, it is selectively placed between the gap of Al electrodes using a dielectrophoresis method. When the carbon fiber is resonated by a piezoelectric ceramic, resistance change at a variety of resonance mode was observed through an electrical system.
Abstract
In this paper we report on the electrical properties of carbon fiber which is an attractive material for strain gauges and can also be applied to resonating micro sensors. The carbon fibers used in this research was manufactured from polyactylonitrile (PAN). The fabricated carbon fibers had about 10 μm in length and several centimeters in length. We employed a micro structure to measure electrical properties of the carbon fiber. The measured electrical resistivity of the carbon fibers were about 3×10−3 Ω·cm. A gauge factor of the carbon fiber is also observed with the same system and it was about 400, depending on the structure of the carbon fiber. For the sensor applications of the carbon fiber, it is selectively placed between the gap of Al electrodes using a dielectrophoresis method. When the carbon fiber is resonated by a piezoelectric ceramic, resistance change at a variety of resonance mode was observed through an electrical system.
참고문헌 (7)
- J, W. Dally, "Handbook of experimental mechanics-chapter 2. Strain gauges", pp.41~78 (1987), Prentice- Hall Englewood Cliffs
- S. Keil, "The thermal output of a strain gauge", Reports in Applied Measurement, 4(1), pp.15~17 (1988)
- V. V. Grishenko, "An influence of linear sizes of the polysilicon piezoresistor units sensitivity", Electron Devices and Materials (EDM) 2000, Siberian Russian Student Workshops on, pp.141~148 (2000)
- W. K. Schomburg, "The design of metal strain gauges on diaphragms", J. Micromech. Microeng, 14, pp.1101~1108 (2004)
- Ö. Vallin, "High-temperature piezoresistive gauge fabricated on commercially available silicon-oninsulator wafers", J. Micromech. Microeng, 10, pp.196~199 (2000)
- C. S. Park, "Fabrication and characterization of a pressure sensor using a pitch-based carbon fiber", Microelectronic Engineering, 84, pp.1316~1319 (2007)
- J. W. Song, "Pressure sensing of air flow using multi-walled carbon nanotubes", J. Kor. Sensors Society, 16(5), pp.377~383 (2007)