FRP 선체구조용 접착제의 접착강도 평가
Strength Evaluation for Adhesive Bonds of Adhesive with FRP Ship Body Structure
2
조회
0
다운로드
6
인용
0
참고문헌
키워드
초록
Recently, the applied frequency of composite materials was increased from the viewpoint of lightweight, high strength and low cost when a leisure boat and a fishing boatwere built. However, studies on the mechanical properties of composite material with ship are rare. Specially,a leisure boat and fishing boat with FRP had been built by hand lay-up method. However, the vacuum infusion method is rising recently for ship building. The manufactured these FRP plates were combined by using the adhesive. Therefore, in this study Cleavage peel strength, Shear strength and fatigue limit of adhesive bonds by tensileloading were estimated. From test results, the strengths of FRP specimens made by the vacuum infusion method are higher than that of the hand lay-up method.
Abstract
Recently, the applied frequency of composite materials was increased from the viewpoint of lightweight, high strength and low cost when a leisure boat and a fishing boatwere built. However, studies on the mechanical properties of composite material with ship are rare. Specially,a leisure boat and fishing boat with FRP had been built by hand lay-up method. However, the vacuum infusion method is rising recently for ship building. The manufactured these FRP plates were combined by using the adhesive. Therefore, in this study Cleavage peel strength, Shear strength and fatigue limit of adhesive bonds by tensileloading were estimated. From test results, the strengths of FRP specimens made by the vacuum infusion method are higher than that of the hand lay-up method.
참고문헌 (13)
- 강병윤, "BMS 인증기준에 따른 구조용 CFRP 개발", 한국해양공학회지, 23(2), pp.92~97 (2009), 한국해양공학회
- 국토해양부, "강화플라스틱(FRP선)의 구조기준", 국토해양부고시 제 2009-919호, ~ (2009)
- 문창권, "흡습에 의한 FRP의 내구성에 관한 연구", 한국해양공학회지, 11(2), pp.48~56 (1997)
- 박종헌, "세일링요트 개발을 위한 20세기초 전통 어선의 선형연구", 한국해양공학회지, 18(4), pp.71~76 (2004), 한국해양공학회
- 정우철, "연안용 소형 고속 레저선 선형개발", 한국해양공학회지, 18(1), pp.80~84 (2004), 한국해양공학회
- 정진욱, "진공적층 시뮬레이션을 이용한 FRP 선체 적층 전략 연구", 한국해양공학회지, 23(2), pp.98~103 (2009), 한국해양공학회
- "ASTM D 3807", ~ (2008)
- "ASTM D 3163", ~ (2008)
- "ASTM D 3166", ~ (2008)
- Fuhimura,Y, "Hand Ley-Up Method of MP-FRP Joint", New Materials and New Processing, The 109th ISIJ Meeting, pp.S768~ (1986)
- "ISO 12215", ~ (2008)
- Song,X, "Vacuum Assisted Resin Transfer Molding (VARTM): Model Development and Verification", 박사, pp.2003