수치해석을 이용한 코그메틱용 스프레이 미립화를 위한 부품설계 및 금형 설계에 과한 연구
A study about design of main parts and injection molds for atomization of cosmetic spray using finite element method
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
This paper presented characterization of spray velocity and angle of spray nozzle systems for cosmetic products. Diameter and length of nozzle orifice were chosen as shape factors of the spray system. Spray orifice of the spray pattern is a factor influencing the quality of the product. Fluid analysis was conducted by using "Fluent" to obtain spray angle and velocity. RSM (Response Surface Method) was used to approximate the relationship between these 2 factors and spray characteristics. To evaluate the proposed method, experimental work with existing was conducted and good agreement between simulation and experimental results.
Abstract
This paper presented characterization of spray velocity and angle of spray nozzle systems for cosmetic products. Diameter and length of nozzle orifice were chosen as shape factors of the spray system. Spray orifice of the spray pattern is a factor influencing the quality of the product. Fluid analysis was conducted by using "Fluent" to obtain spray angle and velocity. RSM (Response Surface Method) was used to approximate the relationship between these 2 factors and spray characteristics. To evaluate the proposed method, experimental work with existing was conducted and good agreement between simulation and experimental results.
참고문헌 (10)
- Heung Shin Jeon, "Liquid Atomization", pp.1~12 (2009)
- Thomas Hörmann, "DOE-Based CFD Optimization of Pharmaceutical Mixing Process", J Pharm Innov, 7, pp.181~194 (2012)
- Evelyn Edith Gutiérrez-oppe, "Comparison between the design of experiments and simulation in the three-phase distillation in a sieve tray column for glycerine dehydration", Chemical Engineering Research and Design, 91(7), pp.1186~1202 (2013)
- D. R. Gunasegaram, "Identification of critical factors affecting shrinkage porosity in permanent mold casting using numerical simulations based on design of experiments", Journal of Materials Processing Technology, 209(3), pp.1209~1219
- FLUENT Inc., "Fluent 6 User's Guide" (2011), Fluent Inc
- Wimmer, E., "Viscous flow through the swirl chamber of a pressure-swirl atomizer", International Journal of Multiphase Flow, 53, pp.100~113 (2013)
- Lee, E. J., "Measuring air core characteristics of a pressure-swirl atomizer via a transparent acrylic nozzle at various Reynolds numbers", Experimental Thermal and Fluid Science, 34(8), pp.1475~1483 (2010)
- S. Hashemi, "Effect of temperature on weldline integrity of injection moulded short glass fibre and glass bead filled ABS hybrids", Polymer Testing, 29, pp.327~336 (2010)
- Babur Ozcelik, "Investigation the effects of obstacle geometries and injection molding parameters on weld line strength using experimental and finite element methods in plastic injection molding", International Communications in Heat and Mass Transfer, 39, pp.275~281 (2012)
- S.O. Ogadhoh, "On Microstructure At The Weldline In Injection Moulded Particulate Composites", Scripta Materialia, 37(8), pp.1143~1149 (1997)