기계 하중에 따른 PV모듈 변형 분석
An analysis of the deformation of PV module under different mechanical loads
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Recently, PV module that the most important part of the photovoltaic system is more widened to lower manufacturing costs for module. However, the broad PV module results to the serious mechanical damage coming from installation circumstances such as snow, wind etc of snow and finally lead to the dramatic degradation of the electrical behavior of PV module. In this paper, 3 kinds of PV modules that consist of the different thickness and area of front glass and the diverse cross sectional structures of the frame are prepared for this experiment. The drooped length and electrical outputs of the PV modules are measured by means of applying 600Pa mechanical load to the PV modules from 1200Pa to 5400Pa base on the mechanical load test procedure of K SC IEC 61215 standard. The simulation data are obtained by the simulation tool as ANSYS and those are validate by comparing with the those experimental results figure out relations between the deformation and the constituent part of PV module.
Abstract
Recently, PV module that the most important part of the photovoltaic system is more widened to lower manufacturing costs for module. However, the broad PV module results to the serious mechanical damage coming from installation circumstances such as snow, wind etc of snow and finally lead to the dramatic degradation of the electrical behavior of PV module. In this paper, 3 kinds of PV modules that consist of the different thickness and area of front glass and the diverse cross sectional structures of the frame are prepared for this experiment. The drooped length and electrical outputs of the PV modules are measured by means of applying 600Pa mechanical load to the PV modules from 1200Pa to 5400Pa base on the mechanical load test procedure of K SC IEC 61215 standard. The simulation data are obtained by the simulation tool as ANSYS and those are validate by comparing with the those experimental results figure out relations between the deformation and the constituent part of PV module.
참고문헌 (9)
- Liu-De Chih, "Assessing the reliability and degradation of ribbon in photovoltaic module", 37th PVSC(2011) IEEE (2011)
- Zemen, "Photovoltaic module performance and degradation as compared in distinct climatic regions", 38th PVSC (2012), IEEE
- Marcus Assmus, "Measurement and simulation of vibrations of PV-modules induced by dynamic mechanical loads", Progress in Photovoltaics (2011)
- Sarah Kajari-Schroder, "Spatial and orientational distribution of cracks in crystalline photovoltaic modules generated by mechanical load tests", Solar Energy Materials & Solar Cells (2011)
- M. Kontges, "The risk of power loss in crystalline silicon based photovoltaic modules due to micro-cracks", Solar Energy Materials & Solar Cells (2011)
- 송영훈, "결정질 Si 셀의 미소 균열 패턴에 따른 PV모듈의 전기적 특성 연구", 석사, 전기공학과, pp.2012
- Y. Zemen, "The impact of yield strength of the interconnector on the internal stress of the solar cell within a module", 25th EU PVSEC (2010)
- "Quantifying the risk of power loss in PV modules due to micro cracks", ~
- 이상순, "실리콘 솔라시스템 구조해석을 위한 유한요소법" (2010), 홍릉과학출판사