초음파 센서의 1차 정합층 두께에 따른 가스탱크 미세누설 수신특성
Gas Tank Microleakage Reception Characteristics According to Thickness of the First Matching Layer of Ultrasonic Sensor
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Ultrasonic sensors show various reception characteristics based on the density of the measurement medium; hence, they are used in various fields to benefit from the characteristics of ultrasonic signals. In this study, the reception characteristics according to the thickness of the first matching layer are compared and analyzed for application to gas tank microleak detection. Accordingly, three types of sensors are manufactured with varying thicknesses of the first matching layer, namely 4.8 mm, 5.1 mm, and 5.5 mm; further, a direct measurement method is used wherein the sensor is attached to the inside of the chamber. Experiments are conducted to observe the phase change due to microleakage, which is the most linear in the sensor with the 4.8 mm thick first matching layer. This is assumed to be the result of stable signal transmission and reception with little phase deviations over time because the first matching layer is closest to the ultrasonic wavelength. The other sensors show nonlinear results with increasing thickness of the first matching layer. Through this study, it is found that appropriately selecting the thickness of the first matching layer of the ultrasonic sensor can greatly influence sensor reliability.
Abstract
Ultrasonic sensors show various reception characteristics based on the density of the measurement medium; hence, they are used in various fields to benefit from the characteristics of ultrasonic signals. In this study, the reception characteristics according to the thickness of the first matching layer are compared and analyzed for application to gas tank microleak detection. Accordingly, three types of sensors are manufactured with varying thicknesses of the first matching layer, namely 4.8 mm, 5.1 mm, and 5.5 mm; further, a direct measurement method is used wherein the sensor is attached to the inside of the chamber. Experiments are conducted to observe the phase change due to microleakage, which is the most linear in the sensor with the 4.8 mm thick first matching layer. This is assumed to be the result of stable signal transmission and reception with little phase deviations over time because the first matching layer is closest to the ultrasonic wavelength. The other sensors show nonlinear results with increasing thickness of the first matching layer. Through this study, it is found that appropriately selecting the thickness of the first matching layer of the ultrasonic sensor can greatly influence sensor reliability.
참고문헌 (16)
- F MA, "Experimental study on thermal efficiency and emission characteristics of a lean burn hydrogen enriched natural gas engine", International Journal of Hydrogen Energy, 32(18), pp.5067~5075 (2007), Elsevier BV[DOI]
- 김진영, "천연가스 전소엔진과 가솔린엔진의 성능과 배출가스 특성 비교", 한국자동차공학회 논문집, 11(2), pp.16~21 (2003), 한국자동차공학회
- Yakup Hames, "Analysis of the control strategies for fuel saving in the hydrogen fuel cell vehicles", International Journal of Hydrogen Energy, 43(23), pp.10810~10821 (2018), Elsevier BV[DOI]
- Injection system for tri-fuel engines with control of power by simultaneous use of CNG and ethanol or gasoline, "Veiga, M. R.", ~, pp.Soc. Automot. Eng. Tec. Pap., 2010-36-0195 (2010)
- Yanchao Li, "Explosion hazard evaluation of renewable hydrogen", ammonia, Energy, pp.2018, 159[DOI]
- Michael J. Vellekoop, "Acoustic wave sensors and their technology", Ultrasonics, 36(1-5), pp.7~14 (1998), Elsevier BV[DOI]
- 최재엽, "비파괴 검사용 고주파 초음파 트랜스듀서 제작", 동력시스템공학회지, 24(3), pp.36~42 (2020), 한국동력기계공학회[DOI]
- Ziyi Guo, "Development of a Piezoelectric Transducer-Based Integrated Structural Health Monitoring System for Impact Monitoring and Impedance Measurement", Applied Sciences, 10(6), pp.2062~ (2020), MDPI AG[DOI]
- Tao Wang, "Gas Leak Location Detection Based on Data Fusion with Time Difference of Arrival and Energy Decay Using an Ultrasonic Sensor Array", Sensors, 18(9), pp.2985~ (2018), MDPI AG[DOI]
- Cheek, J. D. N., "Fundamentals and Applications of Ultrasonic Waves", pp.1~2 (2017), CRC press
- 이종엽, "Effect of the Electrode Type on the Dielectric and Piezoelectric Properties of Piezoelectric PMN-PZT Single Crystals", 한국세라믹학회지, 52(1), pp.77~82 (2015), 한국세라믹학회[DOI]
- Mostafa Fatemi, "Ultrasound-Stimulated Vibro-Acoustic Spectrography", Science, 280(5360), pp.82~85 (1998), American Association for the Advancement of Science (AAAS)[DOI]
- Tone, M., "Piezoelectric ultrasonic transducers having acoustic impedance-matching layer, Panasonic Corp., US Patent No. 4,523,122", ~ (1985)
- Peder C. Pedersen, "Impedance‐matching properties of an inhomogeneous matching layer with continuously changing acoustic impedance", The Journal of the Acoustical Society of America, 72(2), pp.327~336 (1982), Acoustical Society of America (ASA)[DOI]
- T.E.G. Alvarez-Arenas, "Acoustic impedance matching of piezoelectric transducers to the air", IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control, 51(5), pp.624~633 (2004), Institute of Electrical and Electronics Engineers (IEEE)[DOI]
- Kwonse Kim, "The application of ultrasonic waves and envelope energies in a closed chamber based on an air", methane mixture, 2019, pp.91, 92~102[DOI]