본문 바로가기
KERD
논문KCI 등재

석회 종류와 배합비 별 문화재 보수용 석회 모르타르의 초기거동특성과 수축특성 연구

Initial Behavior and Shrinkage Properties of Lime Mortars for Restoration of Cultural Heritage According to the Mixing Ratio

1

조회

0

다운로드

4

인용

0

참고문헌

키워드

주제분류자연과학일반

초록

본 연구는 문화재 보수에 사용되는 소괴 소석회, 분말 소석회, 시판 소석회를 대상으로 배합비에 따른 석회 모르타르의 유동성, 응결시간 및 수축율을 비교하였다. 유동성 시험 결과, 문화재 조적용 석회 모르타르의 최적 배합수 비율은 소괴 소석회 8∼10%, 분말 소석회 10∼ 18%, 시판 소석회 17∼40%의 범위로 나타났다. 응결시간과 수축율 분석 결과, 문화재수리표준 품셈에 기술된 전돌벽쌓기(습식) 대비 종결시간비는 시판 소석회(0.4) < 분말 소석회(5.6) < 소괴 소석회(5.7)의 순으로, 수축율비는 소괴 소석회(1.1) < 분말 소석회(1.2) < 시판 소석회(3.0)의 순으로 나타났다. 물리⋅화학적 특성 분석 결과, 소석회의 입자크기가 커질수록 최적 배합수 함량은 낮아졌고 응결시간은 지연되며 수축율은 감소하였다. 이와 같은 결과는 향후 건축문화재의 수리⋅복원 현장에 사용되는 석회 모르타르의 초기거동과 수축특성을 예측하는데 기여할 것으로 판단된다.

Abstract

This study investigated the initial behavior (flowability and setting properties) and shrinkage characteristics of lime mortar, based on the mixing ratio of hydrated lime (lump, powder) and commercial lime, which is primarily used for repairing and restoring cultural assets. The flowability showed that the optimum mixing water contents of the masonry lime mortar were 8–10% for the lump hydrated lime, 10–18% for the powdered hydrated lime, and 17–40% for the commercial hydrated lime. The results of the setting and shrinkage analysis showed that the average final setting time ratio compared to the standard of cultural asset repair was in the increasing order of commercial hydrated lime(0.4)〈 powder hydrated lime(5.6)〈 lump hydrated lime(5.7). Moreover, the average shrinkage ratio was ordered as lump hydrated lime(1.1)〈 powder hydrated lime(1.2)〈 commercial hydrated lime(3.0). The analysis of the physical and chemical characteristics of hydrated lime showed that the optimum mixing water content was reduced as the particle size of the lime increased, thus delaying the setting time and decreasing the length change rate (shrinkage). These results are expected to contribute to the prediction of the initial behavior and shrinkage characteristics of mortars using handmade and commercial lime during repair and restoration work on cultural, heritage buildings.

참고문헌 (22)

  1. 강소영, "미얀마 바간지역 사원 벽체 보수에 사용되는 석회 플라스터의 광물학적 및 물리적 특성", 광물과 암석, 31(4), pp.267~275 (2018), 한국광물학회
  2. cube specimens), , 2016
  3. Carran, D., "The effect of calcination time upon the slaking properties of quicklime", RILEM bookseries-Historic mortars, 7, pp.283~295 (2012)
  4. Elert, K., "Lime mortars for the conservation of historic buildings", Studies in Conservation, 47, pp.62~75 (2002)
  5. 황혜주, "석회를 활용한 전통 흙건축 기술에 관한 기초 연구", KIEAE Journal, 10(2), pp.3~8 (2010), 한국생태환경건축학회
  6. 강성훈, "소화에 사용되는 물의 양이 건축 문화재 보존용 수제 소석회의 물리 및 화학적 특성에 미치는 영향", 대한건축학회논문집 구조계, 35(2), pp.21~28 (2019), 대한건축학회
  7. 강성훈, "고성능 감수제가 혼입된 기경성 석회 모르타르의 탄산화 반응 및 강도발현 특성", 대한건축학회논문집 구조계, 35(7), pp.179~186 (2019), 대한건축학회
  8. 김은경, "남한산성 외성 여장 사춤재와 현대 사춤재의 비교 연구", 고문화, (92), pp.61~77 (2018), 한국대학박물관협회[DOI]
  9. Kim, J. H., "Introduction of hydraulic lime mortar as eco-friendly architecture material", Ceramist, 9(3) (2006)
  10. Myung Dong cathedral church mortar 1th report, "Kim, T.N.", ~ (2002)
  11. Mortar and brick analysis of Yongsan seminary and Winhyoro cathedral church, "Kim, T.N.", ~ (2004)
  12. Lanas, J., "Dolomitic limes : evolution of the slaking process under different conditions", Thermochimica Acta, 423, pp.1~12 (2004)
  13. 노상균, "시멘트 입도계수(CFM)가 콘크리트의 기초적 특성에 미치는 영향", 한국건축시공학회지, 12(3), pp.284~290 (2012), 한국건축시공학회[DOI]
  14. 박철우, "친환경 건축재료로서 전통 유회(油灰)의 물성에 관한 실험적 연구", 대한건축학회논문집 구조계, 28(07), pp.107~115 (2012), 대한건축학회[DOI]
  15. Ministry of Land, Infrastructure and Transport, "Building structure standards", ~ (2017)
  16. Cultural Heritage Administration, "Cultural property repair standard product count", ~ (2019)
  17. KS, "KS F 2424 Standard test method for length change of mortar and concrete", ~ (2015)
  18. KS, "KS L 5105 Testing method for compressive strength of hydraulic cement mortars", ~ (2017)
  19. KS, "KS L 5111 Flow table for use in tests of hydraulic cement", ~ (2017)
  20. KS, "KS L 5220 Dry ready mixed cement mortar", ~ (2018)
  21. KS, "KS L ISO 679 Methods of testing cements - Determination of strength", ~ (2016)
  22. KS, "KS L ISO 9597 Determination of setting time and soundness of cements", ~ (2014)

관련 논문AI추천

이 간행물의 다른 논문 (12건)