개단 강관말뚝 내부 콘항타에 의한 지지력 증대효과 분석
Analysis of Bearing Capacity Improvement Effect of Inner Cone Penetration Equiped Open-Ended Steel Pipe Pile
0
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
본 연구에서는 콘 장비를 강관말뚝 중공에 설치함에 따른 말뚝의 거동을 분석하기 위해 축소 모형실험을 진행하였다. 콘장비를 항타하여 설치 할 경우 먼저 강관 내부에 유입되는 관내토의 높이를 수치상으로 확인 할 수 있으며, 이를 통해 플러깅을예측하여 플러깅에 따른 말뚝의 거동을 분석 할 수 있다. 또한 물리적인 항타 에너지로 지반의 강성과 강도를 증가 시켜지지력을 상승 시킬 것으로 기대된다. 강사 장치를 이용하여 상대밀도 90%의 지반을 조성하고 거칠기가 다른 두 강관말뚝을항타높이를 200mm와 500mm로 나누어 근입깊이 600mm까지 설치한 다. 그리고 콘 장비의 유무에 따라 총 8가지 케이스를나누어 말뚝의 지지력을 분석하였다. 말뚝의 항타높이, 말뚝의 거칠기, 콘 장비의 유무에 따른 세 가지 변수 중 항타높이가약 70%로 지지력에 미치는 영향이 가장 컸으며 다음으로 콘 장비의 유무가 약 40%, 말뚝의 거칠기가 약 21%로 나타났다.
Abstract
This study analyzes behavior of bearing capacity of open-ended pipe pile from laboratory experiment results. Unlike the conventional pipe piles, cone penetration is implemented into the inside of the pipe pile. During the cone penetration, cone driving energy helps densification of plugged soils and soils below the pile end. Sand pluviator was used to obtain homogeneous soil layers. Two kinds of piles with different pile outer surface roughness were prepared, and two different drop heights of pile driving were applied. Eight experimental cases varying pile outer surface roughness, pile driving energy for conventional and cone penetration implemented piles were conducted. From the experiments, ultimate load of the pile increased approximately by 70% for increased pile driving height, and it increased by 21% for rougher surface pile. When cone penetration is implemented, the ultimate load increased by 40% in average.
참고문헌 (23)
- Been, K., "Cone Penetration Test Calibration for Erksak (Beaufort Sea) Sand", Canadian Geotechnical Journal, 24, pp.601~610 (1987)
- Bellotti, R., "Design, Construction and Use of a Calibration Chamber", Proceeding of the 2nd European Symposium on Penetration Testing, Amsterdam, 2, pp.439~446 (1982)
- Paik, K. H., "Determination of bearing capacity of open- and closed-ended piles driven into sands", J. Geotech. Geoenviron. Eng, 129(1), pp.46~57 (2003)
- Brucy, F., "Behavior of Pile Plug in Sandy Soils during and after Driving", Proc. 23rd Annual Offshore Technology Conf., 1, pp.145~154 (1991)
- Kraft, L. M. Jr, "Performance of Axially Loaded Pipe Piles in Sand", Journal of Geotechnical Engineering, 117(2), pp.272~296 (1991)
- Szechy, C. H., "Tests with Tubular Piles", Acta Technica, Hungarian Academy of Science, 24, pp.181~219 (1959)
- Chapman, G. A., "Interpretation of Static Penetration Tests in Sand", Proceedings of the 10th International Conference on Soil Mechanics and Foundation Engineering, 2, pp.455~458 (1981)
- Davisson, M. T., "innovations in Foundation Construction, Soil Mechanics Division", pp.81~112 (1972), ASCE
- Davisson, M. T., "Pile Load Capacity", Proc. ASCE Conf. Design Construction and Performance of Deep Foundations (1975), ASCE, University of California
- Franke, E., "Co-report to Discussion, Session 13:large-diameter piles", 12th Int. Conf. Soil Mechanics and Foundation Engineering (1989)
- The Determination of Deformation and Shear Strength Parameters for Sands Using the Electrical Friction-Cone Penetrometer, "Holden, J. C.", Norwegian Geotechnical Institute, 55~60, pp.Report 110 (1976)
- Houlsby, G. T., "Calibration Chamber Tests of a Cone Penetrometer in Sand", Geotechnique, 38(1), pp.39~44 (1988)
- Iwasaki, K., "Cone Resistance and Liquefaction Strength of Sand", Proceedings of the 1st International Symposium on Penetration Testing, pp.785~791 (1988)
- 고준영, "개단말뚝의 폐색효과 영향인자 분석", 한국지반공학회논문집, 32(5), pp.27~36 (2016), 한국지반공학회
- Kim, Y. K., "A Comparative Study on the Allowable Bearing Capacity of Pile by Various models", Master, pp.2002
- Kindel, C. E., "Mechanism of Soil Resistance for Driven Pipe Piles", The 4th Annual Symposium of the Waterway Port, Coastal and Ocean Division of ASCE, pp.251~268 (1977)
- 오형진, "지반특성에 따른 동적콘관입 저항특성과 신뢰성평가", 석사, 토질및기초공학, pp.2010
- O’Neill, M.W., "Load Transfer for Pipe Piles in Highly Pressured Dense Sand", Journal of Geotechnical Engineering, ASCE, 117(8), pp.1208~1226 (1991)
- Paik, K. H., "Characteristics of Bearing Capacities for Open-Ended Steel Pipe Piles Driven into Cohesionless Soil", Ph.D, pp.1994
- Paikowsky, S. G., "A static evaluation of soil plug behavior with application to the pile plugging problem", D.Sc, pp.1989
- Laboratory Investigations of CPT’s in Sand, "Parkin, A.K.", NGI, ~, pp.Report 52108-9 (1980)
- Schnaid, F., "An Assessment of Chamber Size Effects in the Calibration of in Situ Tests in Sand", Geotechnique, 41(3), pp.437~445 (1991)
- 유남재, "DCPT를 이용한 노상토의 회복탄성계수의 추정에 관한 연구", 박사, 토목환경공학, pp.2008