로크웰 경도 측정 시 각도오차분석 및 측정불확도 산출에 관한 연구
A Study on Angular Error Analysis and Measurement Uncertainty Calculation in Rockwell Hardness Measurement
5
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
This study was evaluated based on the items of KS B 6389. The study on the calculation of angular error and measurement uncertainty of HRc hardness measurement using statistical techniques using Rockwell measurement specimens with different hardness values was analyzed, and the results were derived according to the change in the angle of the indenter part of the hardness tester and the specimen. As a result of the experiment, the test statistic P values for angle changes such as 0°, 1°, and 2° were all 0.000 using the HRc 30 and 40 measurement specimens, so it was confirmed through the experiment that a significant difference occurred between them. In addition, the extended uncertainty value was calculated as 0.612 at the 95.45% confidence level, and the fact that the hardness test value came out smaller than the existing test value as the inclination angle increased was verified through experiments.
Abstract
This study was evaluated based on the items of KS B 6389. The study on the calculation of angular error and measurement uncertainty of HRc hardness measurement using statistical techniques using Rockwell measurement specimens with different hardness values was analyzed, and the results were derived according to the change in the angle of the indenter part of the hardness tester and the specimen. As a result of the experiment, the test statistic P values for angle changes such as 0°, 1°, and 2° were all 0.000 using the HRc 30 and 40 measurement specimens, so it was confirmed through the experiment that a significant difference occurred between them. In addition, the extended uncertainty value was calculated as 0.612 at the 95.45% confidence level, and the fact that the hardness test value came out smaller than the existing test value as the inclination angle increased was verified through experiments.
참고문헌 (6)
- 방건웅, "시험시간 관련인자가 로크웰 경도측정에 미치는 영향", 폴리머, 29(6), pp.536~542 (2005), 한국고분자학회
- 김선경, "플라스틱 공학에서 제조 기술의 현황과 혁신 방안", Design & Manufacturing, 15(2), pp.1~10 (2021), 한국금형공학회[DOI]
- Jung, H. S, "Mold Opening Stroke according to Injection Speed", ICMTE, pp.254~ (2011)
- Jung, H. S, "An Experimental Study on the Measurement Performance of Injection molding machine", Journalof the KSMTE, pp.134~135 (2011)
- 정현석, "토글식 사출성형기의 타이바 연신율 평가", 한국생산제조학회지, 21(4), pp.672~676 (2012), 한국생산제조학회[DOI]
- 최병기, "금속분말 사출성형 제품의 공정능력분석에 관한 연구", 한국생산제조학회지, 19(1), pp.57~64 (2010), 한국생산제조학회