양생온도에 따른 90 MPa 수준의 고강도 철근 콘크리트 보의 휨거동
Flexural Behavior of High-strength Concrete Beams of 90 MPa According to Curing Temperature
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
본 연구에서는 양생조건이 다른 압축강도 90 MPa 수준의 고강도 콘크리트 부재의 휨거동 실험을 수행하였다. 실험변수는 정상 및 저온 양생 조건, 인장 철근량 및 콘크리트 압축강도 수준 등을 고려하였다. 8개의 보 부재를 제작하여 휨 실험을 수행하였으며 균열 간격, 하중-처짐 관계, 하중-변형률 관계 및 연성지수를 파악하였다. 실험결과는 철근량이 증가함에 따라 균열 개수는 증가하고 균열간격은 감소하는 경향을 나타내며, 콘크리트 강도가 높을수록 균열개수가 줄어들기는 하지만 그 효과는 철근량보다는 상당히 작은 것을 알 수 있었다. 설계기준에서 제안된 평균 균열 간격 식과 비교한 결과, 실험결과가 제안식의 결과보다 약간 크게 나타났으나, 제안식은 콘크리트 강도 및 양생조건을 반영하지 못하는 문제점이 있다. 정상 양생된 부재들의 연성지수는 3.36~6.74이며, 저온 양생된 부재들의 연성지수는 1.51~2.82으로 나타나, 저온 양생된 부재들의 거동은 정상 양생된 부재들에 비해서 연성도지수가 저감됨을 확인하였으며, 본 연구와 기존 연구의 연성지수를 비교한 결과, 고강도 콘크리트 부재의 연성지수는 선행연구의 보통강도 콘크리트의 연성지수 보다 크게 나타났으나, 더 구체적인 결과를 파악하기 위해서는 추가연구가 필요하다고 판단된다.
Abstract
In this study, the flexural behavior of high strength concrete members with different curing condition of 90 MPa of compressive strength was investigated. Experimental parameters included normal and low temperature curing conditions, tensile steel amount and concrete compressive strength. 8 beam members were fabricated and flexural tests were carried out. Crack spacing, load-deflection relation, load-strain relation and ductility index were determined. Experimental results show that as the amount of rebar increases, the number of cracks increases and the crack spacing decreases. The higher the concrete strength, the smaller the number of cracks, but the effect is significantly smaller than the amount of rebar. As a result of comparison with the proposed average crack spacing in the design criteria, the experimental results are slightly larger than the results of the proposed formula, but the proposed formula does not reflect the concrete strength and curing conditions. The ductility index of normal temperature cured members was 3.36∼6.74 and the ductility index of low temperature cured members was 1.51∼2.82. The behavior of low temperature cured members was found to be lower than that of normal temperature cured members. As a result of comparing the ductility index with the existing studies similar to the experimental members, the ductility index of the high strength concrete member was larger than the ductility index of the ordinary strength concrete of the previous study. Further research is needed to understand more specific results.
참고문헌 (16)
- "AASHTO LRFD Bridge Design Specification" (2004), American Association of State Highway and Transportations Officials
- Building Code Requirements for Structural Concrete (ACI 318-02), "ACI Committee 318", American Concrete Institute, 318~ (2002)
- Comité Euro-Internationale du Béton, "CEB-FIP Model Code- Design Code; Comité Euro-International du Béton, CEB Bulletin d’ Information", pp.124~125 (1978), Thomas Telford
- Federal highway administration, "Material property characterization of ultra-high performance concrete", pp.23~49 (2006)
- 홍건호, "고강도콘크리트와 고강도철근을 사용한 RC 보의 휨성능 평가", 대한건축학회논문집 구조계, 27(06), pp.49~56 (2011), 대한건축학회
- 장일영, "On the Ductility of High-Strength Concrete Beams", International Journal of Concrete Structures and Materials, 2(2), pp.115~122 (2008), 한국콘크리트학회
- Korea Concrete Institute, "Design Code for Concrete Structurure" (2012), Gimundang
- Mansur, A. A., "Flexural Behavior of High-Strength Concrete Beams", ACI Structural Journal, 94(6), pp.663~674 (1997)
- 문재성, "혼화재 치환율을 고려한 성숙도 기반의 콘크리트 압축강도 평가 모델", 한국구조물진단유지관리공학회 논문집, 18(6), pp.82~89 (2014), 한국구조물진단유지관리공학회
- Pam, H. J., "Flexural Strength and Ductility of Reinforced Normal-and High-Strength Concrete Beams", Proceeding of the ICE-Structures and Buildings, 146(4), pp.381~389 (2001)
- Rashid, M. A., "Reinforced High-Strength Concrete Beams in Flexure", ACI Structural Journal, 102(3), pp.462~471 (2005)
- Russell, H. G., "High-Performance Concrete-From Buildings to Bridges", Concrete International, 19(8), pp.62~63 (1997)
- Optimized Sections for High-Strength Concrete Bridge Girders, "Russell, H. G.", FHWA, U.S. Department of Transportation, 156~, pp.Report No. FHWA-RD-95-180 (1997)
- Sarkar, S., "High Strength Concrete: an Investigation of the Flexural Behavior of High StrengthRC Beams", Structural Engineer, 75(7), pp.115~121 (1997)
- Wu, Z., "Behavior of High-Strength Concrete Members Under Pure Flexure and Axial-Flexural Loadings", PhD, Construction, and Environmental Engineering, pp.2006
- 양근혁, "Comparison of Strength–Maturity Models Accounting for Hydration Heat in Massive Walls", International Journal of Concrete Structures and Materials, 10(1), pp.47~60 (2016), 한국콘크리트학회[DOI]