휨을 받는 압축강도 80 MPa 수준의 고강도 콘크리트 부재의 구조거동 실험 연구
An Experimental Study on Structural Behavior of High-strength Concrete Members with Compressive Strength of 80 MPa Subjected to Flexure
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
본 연구에서는 휨을 받는 압축강도 80 MPa 수준의 고강도 콘크리트 부재의 구조거동 실험 연구를 수행하였다. 실험변수는 보통(SD 400) 및 고강도(SD 600)철근, 0.98~1.58%의 종방향 철근비, 200×250, 200×300 mm의 단면크기를 고려하였다. 9개의 보 부재를 제작하여 휨 실험을 수행하였으며 극한휨강도, 하중-처짐 관계, 균열 형태, 파괴형상 및 연성을 파악하였다. 실험결과는 철근비가 증가함에 따라 휨강도는 증가하고 연성은 감소한다. 또한, 철근비가 증가함에 따라 균열의 개수가 증가하며 균열폭은 감소하는 경향을 나타내었다. 철근의 강도 등급에 따른 하중-균열폭 관계는 뚜렷한 차이를 나타내지 않는다. 콘크리트 비선형거동 해석을 수행하였으며, 극한하중 예측값과 측정값을 비교하였다. 고강도 콘크리트의 휨거동 예측 결과는 실험부재의 휨강도를 전반적으로 과소평가하고 있다.
Abstract
This paper concerns the structural behavior of high-strength concrete beams with compressive strength of 80 MPa subjected to flexure. Main test variables were nominal yielding strength of longitudinal rebar including normal strength rebar(SD 400) and high strength rebar(SD 600), reinforcement ratio from 0.98 to 1.58% and beam section size with 200×250, 200×300 mm. The nine beams were cast and tested under flexure. The study investigated ultimate flexural strength, load-deflection relationship, crack patterns, failure patterns and ductility of the test beams. Test results indicate that when rebar ratio increased flexural strength increased and ductility decreased. In addition, the number of cracks increased and the crack width decreased as the reinforcement ratio increased. The yield strength of rebar did not affect significantly load-crack width relationship. Nonlinear analysis of test beams was performed and then test results and analytical results of ultimate load were compared. Analytical results of high-strength concrete beams overall underestimated flexural strength of test beams.
참고문헌 (25)
- "AASHTO LRFD Bridge Design Specification" (2004), American Association of State Highway and Transportations Officials
- Alexander, A. N., "Effect of Size On Flexural Behavior of High-Strength Concrete Beams", ACI Structural Journal, 94(1), pp.59~67 (1997)
- Ashour, S. A., "Effect of Compressive Strength and Tensile Reinforcement Ratio on Flexural Behavior of High-Strength Concrete Beams", Engineering Structures, 22(5), pp.413~423 (2000)
- Bentz, "Reinforced Concrete Sectional Analysis, Response-2000, Response version 1.0.5", ~ (2000)
- Bentz, E. C., "Sectional Analysis of Reinforced Concrete", PhD, Department of Civil Engineering, pp.2000
- 조현우, "ECC와 고장력 철근으로 보강된 철근콘크리트 보의 휨 실험", 콘크리트학회 논문집, 23(4), pp.503~509 (2011), 한국콘크리트학회
- 홍건호, "고강도콘크리트와 고강도철근을 사용한 RC 보의 휨성능 평가", 대한건축학회논문집 구조계, 27(06), pp.49~56 (2011), 대한건축학회
- 장일영, "On the Ductility of High-Strength Concrete Beams", International Journal of Concrete Structures and Materials, 2(2), pp.115~122 (2008), 한국콘크리트학회
- 장석준, "고강도 철근과 변형경화형 시멘트복합체를 사용한 보의 균열거동 및 휨 성능", 콘크리트학회 논문집, 27(1), pp.37~44 (2015), 한국콘크리트학회[DOI]
- Kaminska, M. E., "High-Strength Concrete and Steel Interaction in RC Members", Cement and Concrete Composites, 24(2), pp.281~295 (2002)
- Kang, S. H., "An Experimental Study on the Flexural Behavior of High Strength Concrete Members with High Tension Bar", Journal of Korean Society of Civil Engineers, 15(1), pp.107~117 (1995)
- Korea Concrete Institute, "Design Code for Concrete Structural", ~ (2012)
- Lambott, H., "Deflection and Cracking of High-Strength Concrete Beams and Slabs", High-Strength Concrete, Second International Symposium, SP121, pp.109~128 (1990), American Concrete Institute
- Lee J. H., "Analytical Study on Ductility Index of Reinforced Concrete Flexural Members", Journal of The Korean Society of Civel Engineers, 14(3), pp.391~402 (1994)
- Mansur, A. A., "Flexural Behavior of High-Strength Concrete Beams", ACI Structural Journal, 94(6), pp.663~674 (1997)
- Mast, R. F., "Flexural Strength Design of Concrete Beams Reinforced with High-Strength Steel Bars", ACI Structural Journal, 105(5), pp.570~577 (2008)
- 문도영, "고강도철근으로 보강된 고강도 콘크리트보의 휨거동 고찰", 한국방재학회논문집, 13(6), pp.107~113 (2013), 한국방재학회
- Pam, H. J., "Flexural Strength and Ductility of Reinforced Normal-and High-Strength Concrete Beams", Proceeding of the ICE-Structures and Buildings, 146(4), pp.381~389 (2001)
- Popovics, S., "A Numerical Approach to the Complete Stress- Strain Curve of Concrete", Cement and Concrete Research, 3(5), pp.583~599 (1973)
- Rashid, M. A., "Reinforced High-Strength Concrete Beams in Flexure", ACI Structural Journal, 102(3), pp.462~471 (2005)
- Optimized Sections for High-Strength Concrete Bridge Girders, "Russell, H. G.", FHWA, U.S. Department of Transportation, 156~, pp.Report No. FHWA-RD-95-180 (1997)
- Russell, H. G., "High-Performance Concrete-From Buildings to Bridges", Concrete International, 19(8), pp.62~63 (1997)
- Sarkar, S., "High Strength Concrete: an Investigation of the Flexural Behavior of High Strength RC Beams", Structural Engineer, 75(7), pp.115~121 (1997)
- 김무한, "적산온도 방법에 의한 강도예측모델 개발 및 건설생산현장에서의 강도관리에 관한 연구", 콘크리트학회 논문집, 15(1), pp.87~94 (2003), 한국콘크리트학회
- Wu, Z., "Behavior of High-Strength Concrete Members Under Pure Flexure and Axial-Flexural Loadings", PhD, Civil, Construction, and Environmental Engineering, pp.2006