층상계 하이니켈 양극재의 잔류 리튬 생성 및 저감 메커니즘 연구
A Mechanism Study on Formation and Reduction of Residual Li of High Nickel Cathode for Lithium-ion Batteries
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
High nickel layered oxide cathodes are gaining increasing attention for lithium-ion batteries due to their higher energy density and lower cost compared to LiCoO2. However, they suffer from the formation of residual lithium on the surface in the form of LiOH and Li2CO3 on exposure to ambient air. The residual lithium causes notorious issues, such as slurry gelation during electrode preparation and gas evolution during cell cycling. In this review, we investigate the residual lithium issues through its impact on cathode slurry instability based on deformed polyvinylidene fluoride (PVdF) as well as its formation and reduction mechanism in terms of inherently off-stoichiometric synthesis of high nickel cathodes. Additionally, new analysis method with anhydrous methanol was introduced to exclude Li+/H+ exchange effect during sample preparation with distilled water. We hope that this review would contribute to encouraging the academic efforts to consider practical aspects and mitigation in global high-energy-density lithium-ion battery manufacturers.
Abstract
High nickel layered oxide cathodes are gaining increasing attention for lithium-ion batteries due to their higher energy density and lower cost compared to LiCoO2. However, they suffer from the formation of residual lithium on the surface in the form of LiOH and Li2CO3 on exposure to ambient air. The residual lithium causes notorious issues, such as slurry gelation during electrode preparation and gas evolution during cell cycling. In this review, we investigate the residual lithium issues through its impact on cathode slurry instability based on deformed polyvinylidene fluoride (PVdF) as well as its formation and reduction mechanism in terms of inherently off-stoichiometric synthesis of high nickel cathodes. Additionally, new analysis method with anhydrous methanol was introduced to exclude Li+/H+ exchange effect during sample preparation with distilled water. We hope that this review would contribute to encouraging the academic efforts to consider practical aspects and mitigation in global high-energy-density lithium-ion battery manufacturers.
참고문헌 (17)
- Lee H., "Ordered LiNi0.5Mn1.5O4 Cathode in Bis(fluorosulfonyl)imide-Based Ionic Liquid Electrolyte:Importance of the Cathode–Electrolyte Interphase", Chem. Mater., 33, pp.1238~1248 (2021)
- Yoon, E., "Passivation Failure of Al Current Collector in LiPF6-Based Electrolytes for Lithium-Ion Batteries", Adv. Funct. Mater., 32, pp.2200026~ (2022)
- Chang, J. H., "Direct Realization of Complete Conversion and Agglomeration Dynamics of SnO2 Nanoparticles in Liquid Electrolyte", ACS Omega, 2, pp.6329~6336 (2017)
- Lee, H. J., "Li-ion conductivity in Li2OHCl1−xBrx solid electrolytes: grains, grain boundaries and interfaces", J. Mater. Chem. A, 10, pp.11574~11586 (2022)
- Kim, H. -s., "Interphasial Engineering via Individual Moiety Functionalized Organosilane Single-Molecule for Extreme Quick Rechargeable SiO", NCM811 Lithium-Ion Batteries, 2021, pp.13, 44348~44357
- Kim, Y., "Wet-CO2 Pretreatment Process for Reducing Residual Lithium in High-Nickel Layered Oxides for Lithium-Ion Batteries", ACS Appl. Mater. Interfaces, 13, pp.27096~27105 (2021)
- Kim, Y., "Unraveling the Intricacies of Residual Lithium in High-Ni Cathodes for Lithium-Ion Batteries", Chem. Mater., 33, pp.1238~1248 (2021)
- Bianchini, M., "There and Back Again—The Journey of LiNiO2 as a Cathode Active Material", Angew. Chem. Int. Ed, 58, pp.10434~10458 (2019)
- Kim, Y., "Rational Design of Coating Ions via Advantageous Surface Reconstruction in High-Nickel Layered Oxide Cathodes for Lithium-Ion Batteries", Adv. Energy Mater., 11, pp.2101112~ (2021)
- Seong, W. M., "Impact of Residual Lithium on the Adoption of High-Nickel Layered Oxide Cathodes for Lithium-Ion Batteries", Chem. Mater., 32, pp.9479~9489 (2020)
- Choi, J., "Effect of Na2SO4 Coating layer on Nickel-Rich Li(NixCoyMnz)O2Cathode Materials for Lithium-Ion Batteries", Adv. Mater. Interfaces, 3, pp.1600784~ (2016)
- Kanamori, J., "Theory of the Magnetic Properties of Ferrous and Cobaltous Oxides", I, Prog. Theor. Phys., 17, pp.177~196 (1957)
- MnO3, "Phys. Rev.", 1955, 564~573
- Anderson, P. W., "Antiferromagnetism. Theory of Superexchange Interaction", Chem. Mater., 33, pp.1238~1248 (1950)
- Chen, H., "Effects of cationic substitution on structural defects in layered cathode materials LiNiO2", J. Mater. Chem. A, 2, pp.7988~7996 (2014)
- Doo, S. W., "Hydrophobic Ni-Rich Layered Oxides as Cathode Materials for Lithium-Ion Batteries", ACS Appl. Energy Mater., 2, pp.6246~6253 (2019)
- Pritzl, D., "Washing of Nickel-Rich Cathode Materials for Lithium-Ion Batteries: Towards a Mechanistic Understanding", J. Electrochem. Soc., 166, pp.A4056~A4066 (2019)[DOI]