Experimental investigation of combustion hot-gas ventilated supercavitation
2
조회
0
다운로드
3
인용
0
참고문헌
키워드
초록
Most of experimental and numerical studies on ventilated supercavitation have been focused on injection of room temperature air. However, in this work, the effect of combustion hot-gas over 1200 K on characteristics of the supercavity was investigated. Experiment was conducted at a cavitation tunnel using a methane-oxygen combustor designed and manufactured in-house. The results reveal that the high-temperature gas has the effect on reducing fluctuation of the supercavity compared with room temperature gas; variation of the supercavity length is reduced by up to 60% at a certain condition. In this experiment, the development process of the supercavity was strictly observed using two high-speed cameras from the side and top of the test section. Throughout analysis of high-speed shadow images, a reverse flow inside the supercavity was observed and this physical mechanism was conceptually explained. Furthermore, the results show that the temperature variation inside the supercavity depends on the ventilation gas rate, whereas the pressure remains constant after reaching the minimum cavitation number and creating a transparent supercavity. In addition, it was observed that the water-gas interface of the supercavity becomes unstable as the temperature of the injection gas increases and wiggles on the cavity surface become more severe.
Abstract
Most of experimental and numerical studies on ventilated supercavitation have been focused on injection of room temperature air. However, in this work, the effect of combustion hot-gas over 1200 K on characteristics of the supercavity was investigated. Experiment was conducted at a cavitation tunnel using a methane-oxygen combustor designed and manufactured in-house. The results reveal that the high-temperature gas has the effect on reducing fluctuation of the supercavity compared with room temperature gas; variation of the supercavity length is reduced by up to 60% at a certain condition. In this experiment, the development process of the supercavity was strictly observed using two high-speed cameras from the side and top of the test section. Throughout analysis of high-speed shadow images, a reverse flow inside the supercavity was observed and this physical mechanism was conceptually explained. Furthermore, the results show that the temperature variation inside the supercavity depends on the ventilation gas rate, whereas the pressure remains constant after reaching the minimum cavitation number and creating a transparent supercavity. In addition, it was observed that the water-gas interface of the supercavity becomes unstable as the temperature of the injection gas increases and wiggles on the cavity surface become more severe.
참고문헌 (14)
- 안병권, "An experimental investigation of artificial supercavitation generated by air injection behind disk-shaped cavitators", International Journal of Naval Architecture and Ocean Engineering, 9(2), pp.227~237 (2017), 대한조선학회
- Cao, L., "Numerical investigations of pressure distribution inside a ventilated supercavity", J. Fluid Eng, 139(2), pp.1~ (2017)[DOI]
- Chen, T., "Numerical study of cavitating flows in wide range of water temperatures with special emphasis on two typical cavitation dynamics", Int. J. Heat Mass Tran, 101, pp.886~900 (2016)[DOI]
- Dular, M., "Thermodynamic effects during growth and collapse of a single cavitation bubble", J. Fluid Mech, 736, pp.44~66 (2013)[DOI]
- Holl, J. W., "Thermodynamic effects on developed cavitation", J. Fluid Eng, pp.507~513 (1975)[DOI]
- Jiang, Y., "Experimental investigation of ventilated supercavitation with gas jet cavitator", Phys. Fluids, 30, pp.012103~ (2018)[DOI]
- Jiang, Y., "Experimental investigation of drag characteristics of ventilated supercavitating vehicles with different body shapes", Phys. Fluids, 31 (2019)[DOI]
- Phan, T. H., "Numerical analysis of an unsteady natural cavitating flow around an axisymmetric projectile under various free-stream temperature conditions", Int. J. Heat Mass Tran, 164, pp.120484~ (2021)[DOI]
- Spurk, J. H., "On the gas loss from ventilated supercavities", Acta Mech, 155, pp.125~135 (2002)[DOI]
- Spurk, J. H., "Effect of gas temperature on the gas loss from ventilated cavities", Acta Mech, 172, pp.75~81 (2004)[DOI]
- Shao, S., "A comparative study of natural and ventilated supercavitation across two closed-wall water tunnel facilities", Exp. Therm. Fluid Sci, 88, pp.519~529 (2017)[DOI]
- Wang, Y., "Numerical investigation of drag reduction by heat-enhanced cavitation", Appl. Therm. Eng, 75, pp.193~202 (2015)[DOI]
- Wu, Y., "On the internal flow of a ventilated supercavity", J. Fluid Mech, 862, pp.1135~1165 (2019)[DOI]
- Zhao, J., "Numerical simulation study on high temperature ventilated cavitating flow considering the compressibility of gases", Adv. Mater. Res, 569, pp.395~399 (2012)[DOI]