자기연마를 이용한 난삭재 Tungsten Carbide Bar의 마이크로 초정밀가공 특성
Characteristics of Ultra-Precision Micro Finishing for Difficult-To-Cut Tungsten Carbide Bar Material Magnetic Abrasive Finishing
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Magnetic abrasive finishing (MAF) process is a surface improvement method, which the magnetic field of permanent magnet or electromagnet is used to control the abrasive particles during the finishing process. The magnetic abrasive tools are filled between the N-pole and S-pole of Nd-Fe-B type permanent magnets. Tungsten carbide bar (WC) is a high hardness material and its compressive strength is much higher than the other materials. Therefore, due to its superior mechanical properties, it has been widely used in cutting or machining process. Because the smooth surface of tungsten carbide is required in cutting tools, thus the magnetic abrasive finishing process was applied for achieving its surface accuracy and dimensional accuracy. The results showed that the surface roughness of tungsten carbide bar was improved from Ra: 0.23㎛ to Ra: 0.02㎛ in 120 sec by magnetic abrasive finishing process.
Abstract
Magnetic abrasive finishing (MAF) process is a surface improvement method, which the magnetic field of permanent magnet or electromagnet is used to control the abrasive particles during the finishing process. The magnetic abrasive tools are filled between the N-pole and S-pole of Nd-Fe-B type permanent magnets. Tungsten carbide bar (WC) is a high hardness material and its compressive strength is much higher than the other materials. Therefore, due to its superior mechanical properties, it has been widely used in cutting or machining process. Because the smooth surface of tungsten carbide is required in cutting tools, thus the magnetic abrasive finishing process was applied for achieving its surface accuracy and dimensional accuracy. The results showed that the surface roughness of tungsten carbide bar was improved from Ra: 0.23㎛ to Ra: 0.02㎛ in 120 sec by magnetic abrasive finishing process.
참고문헌 (7)
- H. N. Kim, "Ultra Finishing by Magnet Abrasive Grinding for Internal-face of STS304 Pipe", Korean Society Of Precision Engineering, 10, pp.947~952 (2001)
- S. D. Mun, "A Study on the Magnetic Abrasive Finishing Process of STS 304 Bar", The Korean Society of Manufacturing Technology Engineers, 5, pp.499~503 (2008)
- L. Heng, "Review Of Superfinishing By The Magnetic Abrasive Finishing Process", High Speed Machining, 3(1), pp.42~55 (2017)
- L. Heng, "Development of a New Ultra-High- Precision Magnetic Abrasive Finishing for Wire Material Using a Rotating Magnetic Field", Materials, 12(2), pp.1~13 (2019)
- 이성호, "자기연마가공에서 자성입자와 연마재의 크기에 따른 표면개선 효과", 대한기계학회논문집 A, 38(9), pp.1013~1018 (2014), 대한기계학회
- 문상돈, "탄소섬유강화 복합재료의 자기연마 가공에 대한 표면특성", 대한금속·재료학회지, 49(7), pp.522~529 (2011), 대한금속·재료학회
- G. C. Verma, "Experimental investigatigations into internal magnetic abrasive finishing of pipes", Int J Adv Manuf Technol, 88, pp.1657~1668 (2017)