FOG Droplet과 석탄분진 입자의 충돌 부착에 의한 비산 저감에 관한 연구
A Study for Scattering Reduction of Coal Dust by Collision and Adhesion Between Fog Droplet and Coal Dust Particles
1
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
A coal dust scattered from storage and transfer facilities of coal power plant is led to a air pollution. It is difficult to reduce some scattered coal dust by used filter system such as bag filter and electric precipitator because of being scattered in the large area. The need to cut down coal dust generation has been increased as being reinforced regulation to reduce dust from coal power plant. So this is a experimental basic study which reduces coal dust generation. This study is to reduce scattering rate of the coal dust by collision and interception between fine fog droplet and coal dust particles. The reducing rate of coal dust is evaluated by droplet size of 10㎛ sprayed. It is evaluated that capture efficiency is lower as a coal dust concentration become higher. And also it is increase as droplet size is decrase and droplet density is increase. It is resulted that coal dust coefficient to optimize the fog system design is 25μg/m3/l/hr and capture efficiency of coal dust is about 80%.
Abstract
A coal dust scattered from storage and transfer facilities of coal power plant is led to a air pollution. It is difficult to reduce some scattered coal dust by used filter system such as bag filter and electric precipitator because of being scattered in the large area. The need to cut down coal dust generation has been increased as being reinforced regulation to reduce dust from coal power plant. So this is a experimental basic study which reduces coal dust generation. This study is to reduce scattering rate of the coal dust by collision and interception between fine fog droplet and coal dust particles. The reducing rate of coal dust is evaluated by droplet size of 10㎛ sprayed. It is evaluated that capture efficiency is lower as a coal dust concentration become higher. And also it is increase as droplet size is decrase and droplet density is increase. It is resulted that coal dust coefficient to optimize the fog system design is 25μg/m3/l/hr and capture efficiency of coal dust is about 80%.
참고문헌 (8)
- C. Doursat, "Droplet evaporation on a solid surface exposed to forced convection : Experiments, simulation and dimensional analysis", International Journal of Heat and Mass Transfer, pp.1234~1245 (2017)
- Clean Power center of EPI, "Investigation Dust Properties about Generation of Coal Power Plant", KEPCO, 51~68
- R. Siddique, "Utilization of waste foundry sand(WFS)in concrete manufacturing", Resources Conservation and Recycling, 55(11), pp.885~892 (2011)
- C.C. Robert, "Fabric Filter Technology for Coal-Fired Power Plants", Journal of the Air Pollution Control Association, 32(4), pp.362~365 (1982)
- Y. Huang, "Recent Progress of Dry Electrostatic Precipitation for PM2. 5 Emission Control from Coal-fired Boilers", International Journal of Plasma Environmental Science &Technology, 9(2), pp.69~71 (2015)
- S.G. Miller, "Advanced Hybrid Particulate Collector a New Concept for Fine Particle Control", Separation of particles from gases, 256~257 (1998)
- J. G. An, "A Study on an Efficient Reduction Plan of Scattering Dust Generated at Outdoor Coal Yard", The Korean Society of Mechanical Engineers, pp.502~506 (2012)
- Z. Yunfei, "Application of Dry Fog Dust Suppression Technology in the Coal Conveyer Belt System of Thermal Power Plants", Advanced Material Research, pp.1073~1076 (2015)