리드용 와이어 압연 시 장력이 와이어 단면 형상 변형에 미치는 영향 분석
Analysis of the Effect of Tension on the Deformation of Wire Cross - Section During Reed Wire Rolling
1
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
In this paper, we investigated the change of sectional shape according to the tension when the reed wire was rolled. When rolling is performed, the tension acting on the reed wire acts in the opposite direction of the rolling progress and prevents twisting or bending phenomenon. The shape of the cross section was changed according to the tension acting on the reed wire, and the reed wire was rolled by continuously rolling the flat rolled wire and the tension was applied to the reed wire to control the simulation. As a result of the experiment, it was confirmed that the dimensions of the thickness and width after rolling can be adjusted through the tension acting on the lead wire. It was also confirmed that as the tension increased, the length of the lead wire increased and the residual stress increased.
Abstract
In this paper, we investigated the change of sectional shape according to the tension when the reed wire was rolled. When rolling is performed, the tension acting on the reed wire acts in the opposite direction of the rolling progress and prevents twisting or bending phenomenon. The shape of the cross section was changed according to the tension acting on the reed wire, and the reed wire was rolled by continuously rolling the flat rolled wire and the tension was applied to the reed wire to control the simulation. As a result of the experiment, it was confirmed that the dimensions of the thickness and width after rolling can be adjusted through the tension acting on the lead wire. It was also confirmed that as the tension increased, the length of the lead wire increased and the residual stress increased.
참고문헌 (8)
- 이재현, "유한요소법을 이용한 보강롤 구동 4단 냉간압연기에서의 압연하중 및 스트립 두께 예측", 한국기계가공학회지, 8(4), pp.129~135 (2009), 한국기계가공학회
- 변상민, "다단 후판압연에서 평면형상 및 실수율 고찰을 위한 수치적, 실험적 연구", 대한기계학회논문집 A, 37(9), pp.1117~1125 (2013), 대한기계학회
- S. M. Yoon, "Roll Pass Design System for Round Bars to Design Rolling Equipment", Transactions of Materials Processing, 9(2), pp.112~119 (2000)
- 오익수, "고정밀 4롤 이형압연기 개발", 한국기계기술학회지, 18(1), pp.128~134 (2016), 한국기계기술학회[DOI]
- 오익수, "고정밀 이형압연 자동 제조장치 개발", 한국기계기술학회지, 18(2), pp.306~315 (2016), 한국기계기술학회[DOI]
- Nam-Joo Baek, "Mathematical Model of Rolling Force Estimation in Strip Cold Mill", Journal of the Korean Society for Precision Engineering, 7(4), pp.140~148 (1991)
- 이상호, "6단 압연롤 크라운을 고려한 동극박 냉간 압연 패스스케줄 설계", 한국정밀공학회지, 25(11), pp.66~72 (2008), 한국정밀공학회
- 박창형, "리드용 와이어의 Von Mises 응력 최소화를 위한 최적설계", 한국기계가공학회지, 16(4), pp.119~126 (2017), 한국기계가공학회[DOI]