선체설계와 의장설계간의 정보인터페이스 기법 연구
Establishment of Information Interface Technology between Hull and Outfitting Designs
1
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Ship design engineering refers to the development and design of shipbuilding architectures in a drawing which reflects all relevant manufacturing processes. This paper provides analysis methods for model-information interfaces between hull structure design and outfitting design, and a technical application for manufacturing phases reflecting the pipe support pad and angle item automatically. The existing information procedure of pipe support pad and angle system processes information using drawing without model specification. Outfitting design team directly distributes drawings to the shop floor then manual-based marking and installation work are conducted refer to the distributed drawings. As a result, this process has become time consuming and causes problems in the productivity and quality improvement due to the rework caused by omitted or incorrect marking. The pipe support pad and angle marking is a method that automatically updates model information to hull structure design using sets of data that analyse the generated model in outfitting design processes. Therefore, this approach provides an efficient solution through design references without manual activities such as a reflection of hull structure design, cutting process, numerical control work, and dimension measurement and marking. The conversion of a method from the existing procedure based on manual marking to the reflective and automatic approach would have enabled to proceed installation work without manual activities for the measurement. Therefore, this research study proposes an efficient approach using pre-data analysis of model information interfaces between design and manufacturing phases to improve productivity during construction for shipbuilding.
Abstract
Ship design engineering refers to the development and design of shipbuilding architectures in a drawing which reflects all relevant manufacturing processes. This paper provides analysis methods for model-information interfaces between hull structure design and outfitting design, and a technical application for manufacturing phases reflecting the pipe support pad and angle item automatically. The existing information procedure of pipe support pad and angle system processes information using drawing without model specification. Outfitting design team directly distributes drawings to the shop floor then manual-based marking and installation work are conducted refer to the distributed drawings. As a result, this process has become time consuming and causes problems in the productivity and quality improvement due to the rework caused by omitted or incorrect marking. The pipe support pad and angle marking is a method that automatically updates model information to hull structure design using sets of data that analyse the generated model in outfitting design processes. Therefore, this approach provides an efficient solution through design references without manual activities such as a reflection of hull structure design, cutting process, numerical control work, and dimension measurement and marking. The conversion of a method from the existing procedure based on manual marking to the reflective and automatic approach would have enabled to proceed installation work without manual activities for the measurement. Therefore, this research study proposes an efficient approach using pre-data analysis of model information interfaces between design and manufacturing phases to improve productivity during construction for shipbuilding.
참고문헌 (7)
- Kim, H.C., "Hole plan @ DSME based on tribon mx", Aveva Marine Korea User Group Meeting 2004 (2004)
- Park, J.H., "Shipbuilding IT Status and Prospects", Electronics and Telecommunications Trends, 25(4), pp.19~26 (2010)
- Development of the E, "R Insulation Modeling Automation System Using Structural Hull Model Information", Park, H.Y., 2008, pp.112~117
- 노명일, "선체 구조와의 연관성을 고려한 신속 배관 모델링 방법", 대한조선학회 논문집, 43(2), pp.258~267 (2006), 대한조선학회
- 유원선, "The implementation of the integrated design process in the hole-plan system", International Journal of Naval Architecture and Ocean Engineering, 4(4), pp.353~361 (2012), 대한조선학회
- Suh, H. W., "Development of IT based Concurrent Collaboration System", Bulletin of the Society of Naval Architects of Korea, 41(3), pp.27~36 (2004)
- Development of a Automatic Welding System for Various Marks on the Hull of Vessels, "Yoon, H.S.", Special Issued of the Society of Naval Architects of Korea, 90~95 (2008)