수열합성을 이용한 ZnO 마이크로 구조의 성장 및 전사
Fabrication of Vertically Oriented ZnO Micro-crystals array embedded in Polymeric matrix for Flexible Device
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
최근, 유연하며 몸에 부착 가능한 소자들에 대한 관심이 늘어나고 있다. 이런 관심을 뒷받침 하여 이와 관련된다양한 연구들이 진행되고 있는데, 기존 딱딱한 성질을 가진 소자에 사용되던 무기물 기반의 재료의 경우 유연 소자로 만들기에 여러 가지 제약이 있어 유연하게 제작할 수 있는 유기물 반도체나 탄소 나노튜브 필름 등을 이용한 소자들이 주로연구되고 개발되어 왔다. 하지만 이런 재료들을 이용한 소자의 경우 유기물 분자와 분자 사이 또는 탄소 나노튜브와 나노튜브 사이에서 전하들이 산란되는 등 재료 자체의 한계로 인해 기존의 재료를 사용한 소자들보다 전기적 성능이 떨어지는단점을 가지고 있다. 이런 단점들을 해결하기 위하여 이 연구에서는 수직 정렬된 반도체 결정 어레이를 투명 유연한 폴리머와 결합하는 방법을 이용, 고품질 나노/마이크로 반도체 결정을 유연한 기판으로 전사 시킬 수 있는 방법을 제시한다. 위와 같은 구조는 재료에 가해지는 힘을 완화 시켜줄 수 있으며, 이로 인해 큰 변형에도 재료의 손상이 없는 소자 제작이 가능하다. 이런 구조를 구현하기 위해 위치 및 크기가 정교하게 제어된 ZnO 나노막대 단결정을 저온에서 용액공정을 통하여합성시킨다. 이후 성장시킨 ZnO 단결정 어레이와 polydimethylsiloxane (PDMS) 폴리머를 결합시킨 후 단단한 기판에서기계적으로 박리시켜 ZnO/폴리머 복합체를 분리해 낸다. 추가적으로 전사된 ZnO의 결정성을 확인하기 위하여 photoluminescent 분석을 진행하였으며, ZnO/폴리머 복합체를 이용한 외부 힘에 반응하는 압력 센서를 제작하였다.
Abstract
Recently, there has been substantial interest in flexible and wearable devices whose properties and performances are close to conventional devices on hard substrates. Despite the advancement on flexible devices with organic semiconductors or carbon nanotube films, their performances are limited by the carrier scattering at the molecular to molecular or nanotube-to-nanotube junctions. Here in this study, we demonstrate on the vertical semiconductor crystal array embedded in flexible polymer matrix. Such structures can relieve the strain effectively, thereby accommodating large flexural deformation. To achieve such structure, we first established a low-temperature solution-phase synthesis of single crystalline 3D architectures consisting of epitaxially grown ZnO constituent crystals by position and growth direction controlled growth strategy. The ZnO vertical crystal array was integrated into a piece of polydimethylsiloxane (PDMS) substrate, which was then mechanically detached from the hard substrate to achieve the freestanding ZnO-polymer composite. In addition, the characteristics of transferred ZnO were confirmed by additional structural and photoluminescent measurements. The ZnO vertical crystal array embedded in PDMS was further employed as pressure sensor that exhibited an active response to the external pressure, by piezoelectric effect of ZnO crystal.
참고문헌 (37)
- Y. J. Ma, "Elastomers with Ionic Liquid-Filled Cavities as Strain Isolating Substrates for Wearable Electronics", Small, 13(9) (2017)
- A. Koh, "A soft, wearable microfluidic device for the capture, storage, and colorimetric sensing of sweat", Sci. Transl. Med, 8(366) (2016)
- J. A. Rogers, "WEARABLE ELECTRONICS Nanomesh onskin electronics", Nat. Nanotechnol, 12(9), pp.839~ (2017)
- X. F. Wang, "Collapse of liquidoverfilled strain-isolation substrates in wearable electronics", Int. J. Solids. Struct, 117, pp.137~ (2017)
- X. Jin, "Stability of MOSFET-Based Electronic Components in Wearable and Implantable Systems", IEEE T. Electron. Dev, 64(8), pp.3443~ (2017)
- J. Kim, "Miniaturized Battery-Free Wireless Systems for Wearable Pulse Oximetry", Adv. Funct. Mater, 27(1) (2017)
- Y. P. Zang, "Flexible suspended gate organic thin-film transistors for ultra-sensitive pressure detection", Nature Communications, 6 (2015)
- S. K. Gupta, "Flexible organic semiconductor thin films", J. Mater. Chem. C, 3(33), pp.8468~ (2015)
- T. Sasaki, "Solvent-Free Printing of Flexible Organic Thin Film Transistors by Ultrasonic Welding", Adv. Electron. Mater, 2(3) (2016)
- S. J. Kim, "Instantaneous Pulsed-Light Cross-Linking of a Polymer Gate Dielectric for Flexible Organic Thin-Film Transistors", Acs. Appl. Mater. Inter, 9(13), pp.11721~ (2017)
- B. W. Zhu, "Microstructured Graphene Arrays for Highly Sensitive Flexible Tactile Sensors", Small, 10(18), pp.3625~ (2014)
- Y. G. Sun, "Inorganic semiconductors for flexible electronics", Adv. Mater, 19(15), pp.1897~ (2007)
- S. M. Niu, "Enhanced Performance of Flexible ZnO Nanowire Based Room-Temperature Oxygen Sensors by Piezotronic Effect", Adv. Mater, 25(27), pp.3701~ (2013)
- L. D. Li, "ZnO Quantum Dot Decorated Zn2SnO4 Nanowire Heterojunction Photodetectors with Drastic Performance Enhancement and Flexible Ultraviolet Image Sensors", Acs. Nano, 11(4), pp.4067~ (2017)
- M. Y. Tsai, "Flexible MoS2 Field-Effect Transistors for Gate-Tunable Piezoresistive Strain Sensors", Acs. Appl. Mater. Inter, 7(23), pp.12850~ (2015)
- S. W. Jung, "Time-resolved and time-integrated photoluminescence in ZnO epilayers grown on Al2O3(0001) by metalorganic vapor phase epitaxy", Appl. Phys. Lett, 80(11), pp.1924~ (2002)
- S. S. Hong, "Timeresolved photoluminescence of the size-controlled ZnO nanorods", Appl. Phys. Lett, 83(20), pp.4157~ (2003)
- W. I. Park, "ZnO nanoneedles grown vertically on Si substrates by non-catalytic vapor-phase epitaxy", Adv. Mater, 14(24), pp.1841~ (2002)
- S. H. Jung, "A sonochemical method for fabricating aligned ZnO nanorods", Adv. Mater, 19(5), pp.749~ (2007)
- Q. Yang, "Enhancing Light Emission of ZnO Microwire-Based Diodes by Piezo-Phototronic Effect", Nano. Lett, 11(9), pp.4012~ (2011)
- Q. Yang, "Enhancing Sensitivity of a Single ZnO Micro-", Nanowire Photodetector by Piezo-phototronic Effect, 2010, pp.4(10), 6285~
- G. A. Zhu, "Flexible High-Output Nanogenerator Based on Lateral ZnO Nanowire Array", Nano. Lett, 10(8), pp.3151~ (2010)
- M. X. Chen, "Tuning Light Emission of a Pressure-Sensitive Silicon", ZnO Nanowires Heterostructure Matrix through Piezo-phototronic Effects, 2016, pp.10(6), 6074~
- R. R. Bao, "Flexible and Controllable Piezo-Phototronic Pressure Mapping Sensor Matrix by ZnO NW", p-Polymer LED Array, 2015, pp.25(19), 2884~
- H. J. Cho, "Facile synthetic method of catalyst-loaded ZnO nanofibers composite sensor arrays using bio-inspired protein cages for pattern recognition of exhaled breath", Sensor. Actuat. BChem, 243, pp.166~ (2017)
- J. Y. Park, "An approach to fabricating chemical sensors based on ZnO nanorod arrays", Nanotechnology, 19(10) (2008)
- H. Zhang, "Performance Boosting of Flexible ZnO UV Sensors with Rational Designed Absorbing Antireflection Layer and Humectant Encapsulation", Acs. Appl. Mater. Inter, 8(1), pp.381~ (2016)
- M. Thepnurat, "Realization of Interlinked ZnO Tetrapod Networks for UV Sensor and Room-Temperature Gas Sensor", Acs. Appl. Mater. Inter, 7(43), pp.24177~ (2015)
- C. F. Wang, "Enhanced emission intensity of vertical aligned flexible ZnO nanowire", p-polymer hybridized LED array by piezo-phototronic effect, 2015, pp.14, 364~
- S. Maiti, "Three dimensional ZnO nanostructures realized through a polymer mediated aqueous chemical route: candidate for transparent flexible electronics", Crystengcomm, 14(23), pp.8244~ (2012)
- 문대화, "저온수열합성방법에 의해 성장한 ZnO 나노로드의 전구체 몰농도 변화에 따른 특성 연구", 마이크로전자 및 패키징학회지, 20(1), pp.33~37 (2013), 한국마이크로전자및패키징학회[DOI]
- 장주일, "저온 수열 합성법에 의해 (1-102) 사파이어 기판상에 성장된 무분극 ZnO Layer 에 관한 연구", 마이크로전자 및 패키징학회지, 21(4), pp.45~49 (2014), 한국마이크로전자및패키징학회[DOI]
- J. M. Lee, "Strong interactive growth behaviours in solution-phase synthesis of three-dimensional metal oxide nanostructures", Nature Communications, 6 (2015)
- D. W. Yang, "Three-dimensionally-architectured GaN light emitting crystals", Crystengcomm, 19(15), pp.2007~ (2017)
- W. W. Lee, "Morphology-Controlled Three-Dimensional Nanoarchitectures Produced by Exploiting Vertical and In-Plane Crystallographic Orientations in Hydrothermal ZnO Crystals", Cryst. Growth. Des, 11(11), pp.4927~ (2011)
- W. W. Lee, "Three-dimensional epitaxy of single crystalline semiconductors by polarity-selective multistage growth", Crystengcomm, 18(42), pp.8262~ (2016)
- W. W. Lee, "Surface Polarity-Dependent Cathodoluminescence in Hydrothermally Grown ZnO Hexagonal Rods", J. Phys. Chem. C, 116(1), pp.456~ (2012)