본문 바로가기
KERD
논문KCI 등재

이상 유동 환경이 증기 발생기 세관과 지지대의 프레팅 마모에 미치는 영향에 대한 연구

The Influence of Two Phase Flow on Fretting Wear between Steam Generator Tube and Supporting Bar

1

조회

0

다운로드

0

인용

0

참고문헌

키워드

주제분류기계공학

초록

Tubes in nuclear steam generators are held up by supports because the tubes are long and slender. Fluid flows of high-pressure and high-temperature in the tubes cause oscillating motions between tubes and supports. This is called as FIV (flow induced vibration), which causes fretting wear in contact parts of tube-support. The fretting wear of tube-support can threaten the safety of nuclear power plant. The tube and support materials were Inconel 690 and STS 409. The wear tests were conducted in various environments, which are in water without flow, in flowing water and in flowing water with air. The results showed that the flow of water influenced on the wear-life of tube. The wear-life of tube decreased in water flow as compared with wear-life in stationary water.

Abstract

Tubes in nuclear steam generators are held up by supports because the tubes are long and slender. Fluid flows of high-pressure and high-temperature in the tubes cause oscillating motions between tubes and supports. This is called as FIV (flow induced vibration), which causes fretting wear in contact parts of tube-support. The fretting wear of tube-support can threaten the safety of nuclear power plant. The tube and support materials were Inconel 690 and STS 409. The wear tests were conducted in various environments, which are in water without flow, in flowing water and in flowing water with air. The results showed that the flow of water influenced on the wear-life of tube. The wear-life of tube decreased in water flow as compared with wear-life in stationary water.

참고문헌 (5)

  1. C.E Taylor, "Vibration Damping in Multispan Heat Exchanger Tubes", Journal of Pressure Vessel Technolohy, 120, pp.283~289 (1988)
  2. P.L.Ko, "Correlation of Support Impact Force and Fretting-Wear for a Heat Exchanger Tube", Journal of Pressure Vessel Technology, 106, pp.69~77 (1984)
  3. D.G.Kim, "Expeirmental Investigation on Sliding and Fretting Wear of Steam Generator Tube Matrials", Wear, 250, pp.673~673 (2001)
  4. S.H.Jeong, "Wear Transitions of Tube-Support Materials for a Nuclear Steam Generator Through Sliding Wear Test and Fretting Wear Test", Key Engineering Materials, pp.321~323 (2006)
  5. S.H.Jeong, "Wear Transitions of Tube-Support Components for Nuclear Steam Generator under Fretting Conditions", Key Engineering Materials, 326, pp.1253~1266 (2006)

관련 논문AI추천

이 간행물의 다른 논문 (17건)