3개의 스위치를 이용한 벅-부스트 컨버터 설계
A Design of Three Switch Buck-Boost Converter
2
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In this paper, a buck-boost converter using three DTMOS(Dynamic Threshold Voltage MOSFET) switching devices is presented. The efficiency of the proposed converter is higher than that of conventional buck-boost converter. DTMOS with low on-resistance is designed to decrease conduction loss. The threshold voltage of DTMOS drops as the gate voltage increases, resulting in a much higher current handling capability than standard MOSFET. In order to improve the power efficiency at the high current level, the proposed converter is controlled with PWM(pulse width modulation) method. The converter has maximum output current 300mA, input voltage 3.3V, output voltage from 700mV to 12V, 1.2MHz oscillation frequency, and maximum efficiency 90%. Moreover, the LDO(low drop-out) is designed to increase the converting efficiency at the standby mode below 1mA.
Abstract
In this paper, a buck-boost converter using three DTMOS(Dynamic Threshold Voltage MOSFET) switching devices is presented. The efficiency of the proposed converter is higher than that of conventional buck-boost converter. DTMOS with low on-resistance is designed to decrease conduction loss. The threshold voltage of DTMOS drops as the gate voltage increases, resulting in a much higher current handling capability than standard MOSFET. In order to improve the power efficiency at the high current level, the proposed converter is controlled with PWM(pulse width modulation) method. The converter has maximum output current 300mA, input voltage 3.3V, output voltage from 700mV to 12V, 1.2MHz oscillation frequency, and maximum efficiency 90%. Moreover, the LDO(low drop-out) is designed to increase the converting efficiency at the standby mode below 1mA.
참고문헌 (11)
- 김희준, "스위치 모드 파워 서플라이" (1993), 성인당
- Sanjaya Maniktala, "Switching Power Supplies A to Z", pp.61~234 (2006), Newnes
- B. Arbetter, "DC-DC Converter Design for Battery-Operated Systems", IEEE Power Electronics Specialists Conference (1995)
- Chris Toumazou, "Trade-Offs in analog Circuit Design", pp.139~204 (2004), Springer
- Fariborz Assaderaghi, "A Dynamic Threshold Voltage MOSFET(DTMOS)for Very-Low Voltage Operation", IEEE Electron device letters, 15(12), pp.510~512 (1994)
- K.Mark Smith,Jr., "A Comparison of Voltage-Mode Soft-Switching Methods for PWM Converters", IEEE Trans.Power Electronics, 12(2), pp.376~386 (1997)
- Atsuo Fukui, "Design Consideration for a 2 MHz Synchronous Buck Converter in CMOS", ISPSD 2004, 71~74 (2004)
- A.Djemouai, "New CMOS Integrated Pulse Width Modulator for Voltage Conversion Applications", ICECS 2000, 1, pp.116~119 (2000)
- Lu Chen, "Design and Test of a Synchronous PWM Switching Regulator System", IEEE APCCAS 2000, pp.517~520 (2000)
- Baker, "CMOS Circuit Design and layout" (2005), Wiley
- Technical Review of Low Dropout Voltage Regulator Operation and Performance, "Bang.S.Lee", Texas instruments application report, 1~25 (1999)