철근 콘크리트 특수 모멘트 골조 건물의 내진 성능 평가
Seismic Performance Evaluation of a RC Special Moment Frame Building
0
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
연구에서는 확률과 신뢰성을 바탕으로 개발된 FEMA-355F의 내진성능 평가기법을 적용하여 철근 콘크리트 모멘트 골조 건물의 내진성능을 평가하였다. 철골 구조물을 대상으로 개발된 FEMA의 성능평가 방식을 다른 구조 시스템에 적용할 때 각 시스템에 적합한 성능값을 결정해야하며, 요구값과 성능값 계산 시 수반되는 불확실성을 반영하는 계수들을 새로이 구해야 한다. 이를 수행하기 위해 예제 건물을 IBC 2003에 따라 설계한 후, 성능평가에 필요한 변수들을 결정하기 위해 건물의 위치에 적합한 지반 운동을 이용하여 비탄성 동적 해석을 수행하였다. 해석결과에 따르면 계산된 성능값의 분포는 요구값에 비해 상대적으로 작았으며, 이 결과는 본 연구에서 결정된 성능값이 합리적임을 나타낸다. 구해진 신뢰도는 부분 및 전체 붕괴 모두에 대해 목표치를 초과하였으므로 예제 건물은 목표 성능을 만족하는 것으로 나타났다.
Abstract
this study the probability and the reliability-based seismic performance evaluation procedure proposed in the FEMA-355F was applied to a reinforced concrete moment frame building. For the FEMA procedure, which was originally developed for steel moment frame structures, to be applied to other structural systems, the capacity should be re-defined and the factors reflecting the uncertainties related to capacity and demand need to be determined. To perform the evaluation procedure a prototype building was designed per IBC 2003, and inelastic dynamic analyses were conducted applying site-specific ground motions to determine the parameters for performance evaluation. According to the analysis results, distribution of the determined capacities turned out to be relatively smaller than that of the demands, which showed that the defined capacity was reasonable. It was also shown that the prototype building satisfied the target performance since the determined confidence levels exceeded the objectives for both local and global collapses.
참고문헌 (20)
- FEMA 355F, "State of the Art Report on Performance Prediction and Evaluation of Steel Moment-Frame Buildings" (2000), Federal Emergency Management Agency
- Yun, S.-Y, "Seismic performance evaluation for steel moment frames", 128(4), pp.534~545 (2002)
- Lee, K, "Seismic performance evaluation of pre-Northridge steel frame buildings with brittle connections", 128(4), pp.546~555 (2002)
- Lee, K, "Performance evaluation of new steel frame buildings for seismic loads", 31(3), pp.653~670 (2002)
- IBC, "International Building Code", pp.756~ (2003), International Code Council
- ACI 318 Committee, "Building Code Requirements for Structural Concrete (ACI 318-02) and Commentary (ACI 318R-02) American Concrete Institute", pp.443~ (2002), Farmington Hills
- 김태완, "철근 콘크리트 특수 모멘트 골조 건물의 비탄성 동적 요구값", 9(5), pp.11~19 (2005)
- Prakash, "DRAIN-2DX base program description and user guide - version 1.10" (1993), Univ
- Foutch, D.A, "Element 10: A stiffness and strength degrading element developed for the SAC steel program" (2003), distributed with DRAIN-2DX by the National Information Service for Earthquake Engineering
- Somerville, P, "Development of Ground Motion Time Histories for Phase 2 of the FEMA", SAC Steel Project, 1997, ~[DOI]
- Jalayer, F, "A Technical framework for probability-based demand and capacity factor design (DCFD) seismic formats" (2003), Pacific Earthquake Engineering Center
- Cornell, C.A, "Probabilistic basis for 2000 SAC Federal Emergency Management Agency steel moment frame guidelines", 128(4), pp.526~533 (2002)
- Vamvatsikos, D, "Incremental Dynamic Analysis", 31, pp.491~514 (2001)
- Kim, T.-W, "Performance Assessment of Reinforced Concrete Structural Walls for Seismic Loads", (634) (2004), Civil and Environmental Eng
- Ghobarah, A, "Response- Based Damage Assessment of Structures", 28, pp.79~104 (1999)
- Park, Y.J, "Mechanistic Seismic Damage Model for Reinforced Concrete", 111(4), pp.722~739 (1985)
- Yamada, "Seismic Damage Assessment of RC Structures using Different Hysteretic Models Memoirs of the Faculty of Engineering", izu, pp.1~19 (1993)
- Elenas, A, "Correlation Study between Seismic Acceleration Parameters and Damage Indices of Structures", 23, pp.698~704 (2001)
- Goel, R.K, "Vibration properties of buildings determined from recorded earthquake motions" (1997), University of California
- Nowak, A.S, "Reliablility-based calibration for structural concrete, phase 1" (2001), University of Michigan