면진용 배관 벨로우즈이음의 구조해석에 관한 연구
A Study on Structural Analysis of Piping Bellows Joints for Seismic Isolation
2
조회
0
다운로드
3
인용
0
참고문헌
키워드
초록
In this study, the structural analysis for bellows joint of high-performance that can enhance the performance of seismic isolation piping was performed. Bellows joint is that the corrugated flexible piping is connected at the both sides of elbow. An one axis of the bellows joint fixed, and the other end of the axis changes the position from 0° to 315° for the radius displacement of 500 mm. Results obtained are as follows for this case in analysing of the maximum stress and plastic strain of the bellows joint. As the location of the base isolation displacement get farther from the fixed pipe, the bellows joint is pulled, and the maximum stress and plastic deformation is increased. And so the maximum stress occurs near the bellows at both ends of the elbow. Displacement in the 135° position, a maximum stress of 837 MPa and a plastic strain of 3.00%was the highest.
Abstract
In this study, the structural analysis for bellows joint of high-performance that can enhance the performance of seismic isolation piping was performed. Bellows joint is that the corrugated flexible piping is connected at the both sides of elbow. An one axis of the bellows joint fixed, and the other end of the axis changes the position from 0° to 315° for the radius displacement of 500 mm. Results obtained are as follows for this case in analysing of the maximum stress and plastic strain of the bellows joint. As the location of the base isolation displacement get farther from the fixed pipe, the bellows joint is pulled, and the maximum stress and plastic deformation is increased. And so the maximum stress occurs near the bellows at both ends of the elbow. Displacement in the 135° position, a maximum stress of 837 MPa and a plastic strain of 3.00%was the highest.
참고문헌 (6)
- M. K. Kim, "A research status of seismic isolation system for nuclear power plants", Proceedings of the Earthquake Engineering Society of Korea 2011 Fall Annual Conference, pp.359~379 (2011)
- K. T. Hwang, "Design of seismic base isolation on 5 store RC building", Proceedings of the Earthquake Engineering Society of Korea 2012 Spring Annual Conference, pp.229~232 (2012)
- 나완용, "자동차용 벨로우즈의 구조해석에 관한 연구", 한국생산제조시스템학회지, 13(6), pp.102~ (2004), 한국생산제조시스템학회
- D. Y. Chi, "Stress analysis of 3-pin FTL penetration pipe", Journal of the Korean Society of Mechanical Technology, 6(2), pp.65~72 (2004)
- 조재웅, "자동차 완충기의 구조해석에 관한 연구", 한국기계기술학회지, 14(2), pp.31~40 (2012), 한국기계기술학회[DOI]
- 최해규, "접착된 이중외팔보 모델의 파단에 관한 구조해석", 한국기계기술학회지, 14(4), pp.41~47 (2012), 한국기계기술학회