임플란트 주위염 치료용 diode laser의 파장 및 조사시간에 따른 온도 변화와 살균효과 분석
Analysis of temperature changes and sterilization effect of diode laser for the treatment of peri-implantitis by wavelength and irradiation time
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
목적:본 연구에서는 새로 개발된 다이오드 레이저 제품을 이용하여 레이저 파워에 따른 온도변화와 박테리아 멸균 비교 실험을 통하여 기존 제품과의 임플란트 주위염치료에 대한 효과를 비교 실험하였다. 연구 재료 및 방법: 808 nm Diode laser와 810 nm Diode laser를 사용하여 디스크에 레이저를 60초간 조사하였으며, 출력은 1 - 2.5 W로 설정하였다. 온도측정 모듈과 온도측정 프로그램을 이용하여 disc 표면온도변화를 측정하였다. 또한, SLA, RBM이 코팅된 disc에 bacteria 도포 후, 808 nm Diode laser를 30초간 조사하였으며, 출력은 0.5 - 3 W로 설정하였다. 결과: 808 nm, 810 nm 두 장치 모두 출력이 증가함에 따라 온도 상승폭은 증가하였다. 모든 조건에서 810 nm laser를 조사하였을 때 초기온도상승속도, 하강속도 및 전후의 온도변화량은 808 nm laser 보다 높았다. 레이저 조사 후 티타늄 디스크 표면의 변화는 두 레이저 모두에서 관찰되지 않았다. Bacteria가 도포된 디스크에 808 nm laser를 조사한 결과, 출력이 증가 함에 따라 살균효과가 증가하는 것을 확인하였다. 결론: Diode laser를 임상에 적용하는 경우, 동일한 출력에서 온도의 변동폭이 적고 최대 상승온도가 낮은 808 nm laser 가 환자에 안전할 것으로 사료된다. 하지만 실제로 임상에 적용하기 위해서는 보다 다양한 안전성평가를 실시하여 장비에 대한 신뢰성을 확보하여야 할 것이다.
Abstract
Purpose: We compared the effects of newly developed diode laser (Bison 808 nm Diode laser) on the treatment of peri-implantitis with conventional products (Picasso 810 nm Diode laser) by comparing the surface temperature of titanium disc and bacterial sterilization according to laser power. Materials and Methods: The titanium disc was irradiated for 60 seconds and 1 - 2.5 W using diode laser 808 nm and 810 nm. The surface temperature of the titanium disc was measured using a temperature measurement module and a temperature measurement program. In addition, in order to investigate the sterilizing effect according to the laser power, 808 nm laser was irradiated after application of bacteria to sandblasted large-grit acid-etched (SLA) and resorbable blast media (RBM) coated titanium discs. The irradiated disks were examined with scanning electron microscopy. Results: Both 808 nm and 810 nm lasers increased disk surface temperature as the power increased. When the 810 nm was irradiated under all conditions, the initial temperature rise rate, the descending rate, and the temperature change before and after was higher than that of 808 nm. Disk surface changes were not observed on both lasers at all conditions. Bacteria were irradiated with 808 nm, and the bactericidal effect was increased as the power increased. Conclusion: When applying these diode lasers to the treatment of peri-implantitis, 808 nm which have a bactericidal effect with less temperature fluctuation in the same power conditions would be considered safer. However, in order to apply a laser treatment in the dental clinical field, various safety and reliability should be secured.
참고문헌 (24)
- Ishikawa I, "Application of lasers in periodontics:true innovation or myth?", Periodontol 2000, 50, pp.90~126 (2009)
- Dörtbudak O, "Lethal photosensitization for decontamination of implant surfaces in the treatment of periimplantitis", Clin Oral Implants Res, 12, pp.104~108 (2001)
- Schwarz F, "Clinical evaluation of an Er:YAG laser for nonsurgical treatment of periimplantitis:a pilot study", Clin Oral Implants Res, 16, pp.44~52 (2005)
- Atieh MA, "The frequency of peri-implant diseases: a systematic review and meta-analysis", J Periodontol, 84, pp.1586~1598 (2013)
- Lindhe J, "Peri-implant diseases:Consensus Report of the Sixth European Workshop on Periodontology", J Clin Periodontol, 35, pp.282~285 (2008)
- Froum SJ, "A proposed classification for peri-implantitis", Int J Periodontics Restorative Dent, 32, pp.533~540 (2012)
- Esposito M, "Interventions for replacing missing teeth: treatment of peri implantitis", Cochrane Database Syst Rev, 16(2), pp.CD004970~ (2008)[DOI]
- Ntrouka VI, "The effect of chemotherapeutic agents on contaminated titanium surfaces: a systematic review", Clin Oral Implants Res, 22, pp.681~690 (2011)
- Kotsovilis S, "Therapy of peri-implantitis: a systematic review", J Clin Periodontol, 35, pp.621~629 (2008)
- Tosun E, "Comparative evaluation of antimicrobial effects of Er:YAG, diode, and CO2 lasers on titanium discs:and experimental study", J Oral Maxillofac Surg, 70, pp.1064~1069 (2012)
- Stubinger S, "Surface alterations of polished and sandblasted and acid-etched titanium implants after Er:YAG, carbon dioxide, and diode laser irradiation", Int J Oral Maxillofac Implants, 25, pp.104~111 (2010)
- Park JH, "Effects of laser irradiation on machined and anodized titanium disks", Int J Oral Maxillofac Implants, 27, pp.265~272 (2012)
- Kreisler M, "Effect of simulated CO2 and GaAlAs laser surface decontamination on temperature changes in Ti-Plasma sprayed dental implants", Lasers Surg Med, 30, pp.233~239 (2002)
- Kim JH, "Ribotyping of Porphyromonas Gingivalis isolated from rapidly progressive periodontitis patients", J Korean Acad Periodontol, 29, pp.963~977 (1999)
- 김세연, "Porphyromonas gingivalis 가 일부 구강미생물의 형광 발현에 미치는 영향", 대한구강보건학회지, 41(1), pp.22~27 (2017), 대한예방치과·구강보건학회
- Peck SY, "The frequency of detecting Prevotella intermedia and Prevotella nigrescens in Korean adult periodontitis patients", J Korean Acad Periodontol, 30, pp.419~427 (2000)
- Romanos GE, "Effects of diode and Nd:YAG laser irradiation of titanium discs: a scanning electron microscope examination", J Periodontol, 71, pp.810~815 (2000)
- Slater SC, "Cloning and expression in Escherichia coli of the Alcaligenes eutrophus H16 poly-beta-hydroxybutyrate biosynthetic pathway", J Bacteriol, 170, pp.4431~4436 (1988)
- McDaniel TK, "A cloned pathogenicity island from enteropathogenic Escherichia coli confers the attaching and effacing phenotype on E. coli K 12", Mol Microbiol, 23, pp.399~407 (1997)
- Cooper GM, "The cell: a molecular approach", pp.43~73 (2007), Sinauer Associates, Inc
- 이경중, "임플란트주위염 처치에서 레이저의 이용: 문헌고찰", 구강회복응용과학지, 31(4), pp.340~348 (2015), 대한턱관절교합학회[DOI]
- Kreisler M, "Bactericidal effect of the Er: YAG laser on dental implant surfaces:an in vitro study", J Periodontol, 73, pp.1292~1298 (2002)
- Koo PM, "The diagnosis and treatment of peri-implantitis", J Dent Implant Res, 34, pp.76~80 (2015)
- Oh WS, "Microbiology of Peri-implantitis", J Dent Implant Res, 32, pp.1~6 (2013)