현장타설말뚝 선단부의 위치에 따른 극한지지력 변화
Changes in Ultimate Bearing Capacity according to the Position of the End of the Drilled Shaft
1
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
본 연구는 현장타설말뚝의 합리적인 적정설계를 알아보기 위하여 수행하였다. 즉, 현장타설말뚝의 지지층 변경에 따른 극한지지력변화를 알아보기 위하여 현장타설말뚝에 대해 실시된 양방향 말뚝재하시험을 이용하여 역해석을 수행하였다. 역해석된자료를 바탕으로 두부재하하중에 대한 수치해석을 진행하여 대상 지반에서의 극한지지력을 Davisson 판정법으로 평가하였다. 말뚝 단부가 풍화암층 상단에 안착된 1개의 경우와 풍화토 내 서로 다른 위치에 근입된 3개의 경우에 대한 수치해석 결과, 모든 경우에서 충분한 극한지지력을 확보하는 것으로 나타났다. 즉 말뚝의 단부가 풍화암 근입이 아닌 풍화암층 상단에 안착된경우와 풍화토 내에 근입된 현장타설말뚝도 충분한 지지력을 가지고 있어 현장타설말뚝의 지지층으로 활용할 수 있음을 알수 있다.
Abstract
This study was conducted to find out the rational and appropriate design of drilled shaft. In other words, in order to find out the variation of ultimate bearing capacity according to the change in the support layer of drilled shaft, back analysis was performed using the bi-directional pile load test performed on drilled shaft. Based on the back-analyzed data, numerical analysis of the pile head load was performed, and the ultimate bearing capacity in the target ground was evaluated using the Davisson method. As a result of numerical analysis of one case where the end of the pile was seated on the top of the weathered rock layer, and three cases where the end of the pile was embedded at different locations in the weathered soil, it was found that sufficient ultimate bearing capacity was secured in all cases. In other words, the case where the end of the pile is seated on the top of the weathered rock layer, not embedded the weathered rock, and the drilled shaft embedded into the weathered soil also have sufficient bearing capacity, so it can be used as a support layer for drilled shaft.
참고문헌 (20)
- Abaqus, "User’s Manual", ~ (2018)
- Ahmadi, M. M., "Side Resistance of Drilled Shaftsin Sandy Soils", 11th international congress on civil engineering, pp.1~7 (2018)
- Busan Port (North Port) Redevelopment Project Connection Bridge (Phase 1) Construction, Design report, "Busan Port Authority", ~ (2018)
- Analyisis and Design of Drilled Shaft Foundations Socketed into Rock, "Cater, J. R.", Geotechnical Engineering Group, Cornell Univ, ~, pp.Report No. EPRL. EL-5918 (1988)
- Choi, Y. K., "Suggestions for Improvement of Domestic Pile Foundation Design Routine - At a Viewpoint of Pile Bearing Capacity", Journal of the Korean Society of Civil Engineers, 19(III-3), pp.467~477 (1999)
- Chun, B. S., "A Case Study on Evaluation of Bearing Capacity for Axially Loaded Drilled Shafts in Weathered Rock", proceedings of the Korean Society of Civil Engineers, pp.4422~4425 (2006)
- Davisson, M. T., "High Capacity of Piles", Proceedings of Lecture Series on Innovation in Foundation Construction, pp.81~112 (1973)
- Drilled Shafts: Construction Procedures and Design Methods, "FHWA", Federal Highway Administration, ~, pp.FHWA Publication No. FHWA-IF-99-025 (1999)
- 홍원표, "대구경 현장타설말뚝의 주면 마찰력 평가", 한국지반공학회논문집, 21(1), pp.93~104 (2005), 한국지반공학회
- 정성준, "Calibration of resistance factors of load and resistance factor design for drilled shafts embedded in weathered rock", 박사, 건설환경공학, pp.2010
- Kim, D. Y., "Evaluation of Side Friction for Drilled Shafts Embedded in Weathered Rocks", proceedings of the Korean Society of Civil Engineers, pp.3338~3341 (2003)
- Korean Geotechnical Society, "Explanation of Foundation Design Standards for Structures", CIR, ~ (2018)
- Korean Society of Civil Engineers, "Highway Bridge Design Criteria", pp.41~ (2008), Kimoondang
- Kulhawy, F. H., "Drilled Shaft Side Resistance on Clay Soil to Rock", Proceedings of the Conference on Design and Performance of Deep Foundations:Piles and Piers on Soil and Soft Rock, 38, pp.172~183 (1993), ASCE
- 권오성, "풍화된 암반에 근입된 현장타설말뚝의 하중전이기구", 한국지반공학회논문집, 21(5), pp.187~ (2005), 한국지반공학회
- Ministry of Land, Infrastructure and Transport, "Korean Highway Bridge Design Code (Limit State Design)", ~ (2016)
- 서용석, "국내에 분포하는 암반의 물리·역학적 특성 분석", 지질공학, 26(4), pp.593~600 (2016), 대한지질공학회
- 설훈일, "말뚝-지반 상호작용을 고려한 수정된 하중전이함수법 제안", 대한토목학회 논문집C, 28(6), pp.359~366 (2008), 대한토목학회
- Hoonil Seol, "Load transfer analysis of rock-socketed drilled shafts by considering coupled soil resistance", 박사, Civil Engineering, pp.2008
- Zhang, L., "Estimationg the Mean Trace Length of Rock Discountinuities", International Journal of Rock Mechanics and Rock Engineering, 31(4), pp.217~235 (1988)