유공압 부품이 내장된 인쇄회로기판을 활용한 내시경 수술용 기복기의 개발
Development of the Insufflator for Endoscopic Surgery using the Fluidic System in Printed Circuit Board
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
The insufflators in endoscopic surgery supply carbon dioxide to make the air-filled cavity in the abdomen. It contains many kinds of pneumatic and electronic parts and they are connected with the air tubes and electrical wires. The printed circuit boards (PCB) perform wiring, holding and cooling tasks in electronic systems. In this study,the PCB is used as the air channel for insufflators to decrease the cost, volume, and the malfunction according to aging of the device. Three layers of PCB made of FR4 are combined with prepreg as adhesive which has the internal airway channel according to the design. By mounting the pressure sensors and valves, the PCB based fluidic system is implemented. After calibration of flow sensor, the flow rate of the gas also can be measured. The climate test, temperature test, and biocompatibility test showed this idea can be used in insufflators for laparoscopic surgery.
Abstract
The insufflators in endoscopic surgery supply carbon dioxide to make the air-filled cavity in the abdomen. It contains many kinds of pneumatic and electronic parts and they are connected with the air tubes and electrical wires. The printed circuit boards (PCB) perform wiring, holding and cooling tasks in electronic systems. In this study,the PCB is used as the air channel for insufflators to decrease the cost, volume, and the malfunction according to aging of the device. Three layers of PCB made of FR4 are combined with prepreg as adhesive which has the internal airway channel according to the design. By mounting the pressure sensors and valves, the PCB based fluidic system is implemented. After calibration of flow sensor, the flow rate of the gas also can be measured. The climate test, temperature test, and biocompatibility test showed this idea can be used in insufflators for laparoscopic surgery.
참고문헌 (7)
- G.Meeks, "Advanced laparoscopic gynecologic surgery", Surgical Clinics of North America, 80(5), pp.1443~1464 (2000)
- A. Kong, "Laparoscopic-assisted colectomy: technique and discussion", Surgical Technology International, 15(2), pp.95~101 (2006)
- E. Verdaasdonk, "Problems with technical equipment during laparoscopic surgery.An observational study", Surgical Endoscopy, 21(2), pp.275~279 (2007)
- S. Gassmann, "Realization of a flow injection analysis in PCB technology", Sensors and Actuators A: Physical, 133(8), pp.231~235 (2007)
- S. Gassmann, "Printed Circuit Boards in Micro Fluidic Applications", Actuator 2008, 11th International Conference on New Actuators, pp.230~233 (2008)
- Carmen Aracil, "Pneumatic impulsion device for microfluidic systems", Sensors and Actuators A: Physical, 163(1), pp.247~254 (2010)