ECG 원칩 솔루션의 진단용 심전계 적용을 위한 타당성 연구
A Feasibility Study for Application of Single-Chip Solution for Diagnostic Resting ECG
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
In order for medical devices to be used outside hospital, they have to be not only of small size but also power consumption has to be kept at low level. This study investigates the feasibility of application of ADS1298 ECG single-chip solution developed by Texas Instruments Inc. for use in development of a new platform for diagnostic resting ECG. To prove the feasibility of commercial products based on the ADS1298 chip, the performance of the ADS1298 chip was measured in terms of input impedance, common mode rejection, frequency response, and input dynamic range using the testing method under the suitability criteria of the IEC 60601-2-25 standard. Result of the this study shows that commercialization of the ECG products based on the ADS1298 ECG single-chip solution that satisfies the international standards would be possible, if the manufactures take the filter characteristics into account in building a new platform for diagnostic resting ECG.
Abstract
In order for medical devices to be used outside hospital, they have to be not only of small size but also power consumption has to be kept at low level. This study investigates the feasibility of application of ADS1298 ECG single-chip solution developed by Texas Instruments Inc. for use in development of a new platform for diagnostic resting ECG. To prove the feasibility of commercial products based on the ADS1298 chip, the performance of the ADS1298 chip was measured in terms of input impedance, common mode rejection, frequency response, and input dynamic range using the testing method under the suitability criteria of the IEC 60601-2-25 standard. Result of the this study shows that commercialization of the ECG products based on the ADS1298 ECG single-chip solution that satisfies the international standards would be possible, if the manufactures take the filter characteristics into account in building a new platform for diagnostic resting ECG.
참고문헌 (9)
- Y. S. Lee, "Introduction to Medical Engineering", pp.155~162 (1999), Shinkwang Press
- Jan A. Kors, "Variability in ECG Computer Interpretation", Journal of Electrocardiology, 25(4), pp.263~271 (1992)
- Barbara Drew, "Standardizing electrocardiographic leads", Journal of Electrocardiology, 41, pp.187~189 (2008)
- Electrocardiogram Measurement Circuit Design Lab, , Design of Medical Devices, Dept. of ECEE, Univ. of Colorado, ~ (2013)
- B. Drew, "Standardizing electrodcardio-graphic leads", Journal of Electrocardiology, 41, pp.187~189 (2008)
- "Diagnostic electrocardiographic devices", American National Standard, ~ (2001)
- "Part 2-25: Particular requirements for the basic safety and essential performance of electrocardiographs", International Electrotechnical Commission, ~ (2011)
- "Part 2-51: Particular requirements for safety, including essential performance, of recording and analysing single channel and multichannel electrocardiographs", International Electrotechnical Commission, ~ (2013)
- Per Förstberg, "Evaluation of Commercial Analog Front Ends for Pattern Recognition Based Control of Robotic Prostheses", Chalmers University of Technology, 22~23 (2011)