A three-region movable-boundary helical coil once-through steam generator model for dynamic simulation and controller design
2
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
A simple but accurate mathematical model is crucial for dynamic simulations and controller design of helical coil once-through steam generator (OTSG). This paper presents a three-region movable boundary dynamic model of the helical coil OTSG. Based on the secondary side fluid conditions, the OTSG is divided into subcooled region (two control volumes), two-phase region (two control volumes) and superheated region (three control volumes) with movable boiling boundaries between each region. The nonlinear dynamic model is derived based on mass, energy and momentum conservation equations. And the linear model is obtained by using the transfer function and state space transformation, which is a 37-order model of five input and three output. Validations are made under full-power steady-state condition and four transient conditions. Results show good agreements among the nonlinear model, linear model and the RELAP5 model, with acceptable errors. This model can be applied to dynamic simulations and controller design of helical coil OTSG with constant primary-side flow rate.
Abstract
A simple but accurate mathematical model is crucial for dynamic simulations and controller design of helical coil once-through steam generator (OTSG). This paper presents a three-region movable boundary dynamic model of the helical coil OTSG. Based on the secondary side fluid conditions, the OTSG is divided into subcooled region (two control volumes), two-phase region (two control volumes) and superheated region (three control volumes) with movable boiling boundaries between each region. The nonlinear dynamic model is derived based on mass, energy and momentum conservation equations. And the linear model is obtained by using the transfer function and state space transformation, which is a 37-order model of five input and three output. Validations are made under full-power steady-state condition and four transient conditions. Results show good agreements among the nonlinear model, linear model and the RELAP5 model, with acceptable errors. This model can be applied to dynamic simulations and controller design of helical coil OTSG with constant primary-side flow rate.
참고문헌 (25)
- G. Xia, "Analysis of load-following characteristics for an integrated pressurized water reactor", Int. J. Energy Res, 38(3), pp.380~390 (2014)
- Z. Liu, "Technology readiness assessment of small modular reactor(SMR)designs", Prog. Nucl. Energy, 70, pp.20~28 (2014)
- Q. Liang, "Frequency domain analysis of two-phase flow instabilities in a helical tube once through steam generator for HTGR", Appl. Therm. Eng, 168, pp.114839~ (2020)
- A. V. Zrodnikov, "SVBR-100 module-type fast reactor of the IV generation for regional power industry", J. Nucl. Mater, 415(3), pp.237~244 (2011)
- M.-H. Lee, "Nonlinear Dynamic Modeling of a Once-Through Steam Generator" (1978)
- C. K. Sanathanan, "Dynamic modeling of a large once-through steam generator", Nucl. Eng. Des, 23(3), pp.321~330 (1972)
- A. T. -l. Chen, "A DIGITAL SIMULATION FOR NUCLEAR ONCE-THROUGH STEAM GENERATORS", pp.1976
- A. Ray, "A Nonlinear Dynamic Model of a Once-Through Subcritical Steam Generator" (1976)
- A. Ray, "Dynamic modelling of once-through subcritical steam generator for solar applications11 This work was done while the author was at Carnegie-Mellon University", Appl. Math. Model, 4(6), pp.417~423 (1980)
- C. P. Tzanos, "A movable boundary model for once-through steam generator analysis", Nucl. Technol, 82(1), pp.5~17 (1988)
- M. A. Abdalla, "A four-region, moving-boundary model of a once-through, helical-coil steam generator", Ann. Nucl. Energy, 21(9), pp.541~562 (1994)
- H. Li, "A lumped parameter dynamic model of the helical coiled once-through steam generator with movable boundaries", Nucl. Eng. Des, 238(7), pp.1657~1663 (2008)
- Z. Dong, "Saturated output feedback dissipation steam temperature control for the OTSG of MHTGRs", IEEE Trans. Nucl. Sci, 58(3), pp.1277~1289 (2011)
- Z. Dong, "A differential-algebraic model for the once-through steam generator of MHTGR-based multimodular nuclear plants", Math. Probl Eng, 2015, pp.1~12 (2015)
- J. Yoon, "Development of a computer code, ONCESG, for the thermal-hydraulic design of a once-through steam generator", J. Nucl. Sci. Technol, 37(5), pp.445~454 (2000)
- S. E. Arda, "Nonlinear dynamic modeling and simulation of a passively cooled small modular reactor", Prog. Nucl. Energy, 91, pp.116~131 (2016)
- G. Xia, "Numerical studies of a helical coil oncethrough steam generator", Ann. Nucl. Energy, 109, pp.52~60 (2017)
- Y. Wu, "Accuracy and efficient solution of helical coiled once-through steam generator model using JFNK method", Ann. Nucl. Energy, 159, pp.108290~ (2021)
- H. Yao, "Study on the systematic thermal-hydraulic characteristics of helical coil once-through steam generator", Ann. Nucl. Energy, 154, pp.108096~ (2021)
- H. Ding, "Development of a model for thermalhydraulic analysis of helically coiled tube once-through steam generator based on Modelica", Ann. Nucl. Energy, 137, pp.107069~ (2020)
- K. Ye, "Numerical analysis of the flow behavior in a helically coiled once through steam generator", Nucl. Eng. Des, 330, pp.187~198 (2018)
- E. F. Schmidt, "Warmeübergang und druckverlust in rohrschlangen", Chem.-Ing.-Tech, 39(13), pp.781~789 (1967)
- SPES3-IRIS Facility RELAP5 Sensitivity Analyses on the Containment System for Design Review, "F. Bianchi", ENEA Ricerca Sistema Elettrico, ~, pp.Report No. NNFISS-LP2-017 (2010)
- C. Galvez, "Design and Transient Analysis of Passive Safety Cooling Systems for Advanced Nuclear Reactors", pp.2011
- Deterministic Safety Analysis of Station Blackout Postulated Accident on the Basis of the SMR Simulator MASLWR, "A. Del Nevo", ~ (2012)