Vanadium-Boride코팅의 고온 내입자침식성 평
Evaluation of High Temperature Particle Erosion Resistance of Vanadium-Boride Coating
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
The components in ultra super critical (USC) steam turbine, which is under development for high efficient power generation, are encountering harsher solid particle erosion by iron oxide scales than ones in the existing steam turbines. Therefore, the currently used boride coating will not be able to hold effective protection from particle erosion in USC system and should be replaced by new particle erosion resistant coatings. One of the best protective coatings developed for USC steam turbine parts was found to be vanadium-boride (V-boride) coating which has a hardness of about 3000 HV, much higher than that of boride, 1600∼2000 HV. In order to evaluate particle erosion resistance of the various coatings such as V-boride, boride and Cr-carbide coatings at high temperature, particle erosion test equipments were designed and manufactured. In addition, erosion particle velocity was simulated using FLUENT software based on semi-implicity method for pressure linked equations revised (SIMPLER). Based on experimental results of this work, the vanadium-boride coating was found to be superior to others and to be a candidate coating to replace the boride coating
Abstract
The components in ultra super critical (USC) steam turbine, which is under development for high efficient power generation, are encountering harsher solid particle erosion by iron oxide scales than ones in the existing steam turbines. Therefore, the currently used boride coating will not be able to hold effective protection from particle erosion in USC system and should be replaced by new particle erosion resistant coatings. One of the best protective coatings developed for USC steam turbine parts was found to be vanadium-boride (V-boride) coating which has a hardness of about 3000 HV, much higher than that of boride, 1600∼2000 HV. In order to evaluate particle erosion resistance of the various coatings such as V-boride, boride and Cr-carbide coatings at high temperature, particle erosion test equipments were designed and manufactured. In addition, erosion particle velocity was simulated using FLUENT software based on semi-implicity method for pressure linked equations revised (SIMPLER). Based on experimental results of this work, the vanadium-boride coating was found to be superior to others and to be a candidate coating to replace the boride coating
참고문헌 (9)
- W. Tabakoff, , J. Eng. Gas Turbines Power, 117, pp.146~ (1995)
- R. Chatterjee-Fischer, , Proceedings of the Eight International Conference on Chemical Vapor Deposition, pp.508~ (1981), Electrochemical Soc
- R. Chatterjee-Fischer, "Proceedings of Heat Treatment", pp.27~ (1976), Stratford-upon-Avon Metals Society
- K. C. Goretta, , Mater. Sci. Eng. A, 161, pp.L7~ (1993)
- A. V. Levy, , Surf. Coating Tech, 36, pp.387~ (1988)
- S. T. Wlodek, , Electr. Power Res. Inst. Rep, CS-5415, pp.30~ (1987)
- S. Usmani, , JOM, 48, pp.51~ (1996)
- B. Venkataraman, , Surf. Coating Tech, 73, pp.177~ (1995)
- J. S. Vandergraft, "Introduction to Numerical Computation", pp.149~ (1983), Academic Press