모형 실험과 수치 해석을 통한 단선용 모형 오일펜스의 성능 해석
Efficiency of Model Oil Fences for One Vessel Using a Physical Experiment and Numerical Calculation
0
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
This study evaluated the efficiency of an oil fence and spreading devices for one vessel in a towing tank. A series of model experiments and numerical calculations were conducted using an existing oil fence for two vessels and a new method for one vessel. Models of the oil fence and spreading devices were constructed on 1/20th scale from waterproofed nylon fabric and canvas. The tensions acting on the model of the oil fences and the horizontal distance between the spreading devices were calculated numerically while the oil fences were being towed. The results were extremely close to the results of the model experiments. The ratio of the opening width to the total length of the oil fence, which shows the efficiency of the oil fence for one vessel, was 49.7% in 0.4m/sec. Therefore, the proposed oil fence system should be very useful for oil containment at sea. As the opening width of the oil fence is not proportional to the length of the towing rope, it may be reasonable to maintain the towing rope at approximately 100m. Furthermore, a reasonable towing speed, when operating the oil fence for one vessel equipped with spreading devices, was within 0.4m/sec.
Abstract
This study evaluated the efficiency of an oil fence and spreading devices for one vessel in a towing tank. A series of model experiments and numerical calculations were conducted using an existing oil fence for two vessels and a new method for one vessel. Models of the oil fence and spreading devices were constructed on 1/20th scale from waterproofed nylon fabric and canvas. The tensions acting on the model of the oil fences and the horizontal distance between the spreading devices were calculated numerically while the oil fences were being towed. The results were extremely close to the results of the model experiments. The ratio of the opening width to the total length of the oil fence, which shows the efficiency of the oil fence for one vessel, was 49.7% in 0.4m/sec. Therefore, the proposed oil fence system should be very useful for oil containment at sea. As the opening width of the oil fence is not proportional to the length of the towing rope, it may be reasonable to maintain the towing rope at approximately 100m. Furthermore, a reasonable towing speed, when operating the oil fence for one vessel equipped with spreading devices, was within 0.4m/sec.
참고문헌 (19)
- Cho, I.H., "Tension calculation on trash curtain in current", J. Kor. Soc. Mar. Environ. Eng, l4, pp.65~73 (2001)
- CONCAWE (Conservation of Clean Air and Water in Europe), "A field guide to coastal oil spill control and clean-up techniques", CONCAWE Report Hague Netherlands, 9, pp.110~112 (1981)
- Fang, F, "Oil containment by boom in waves and wind. I. Numerical model", J. Waterw. Port C-ASCE, 127, pp.222~227
- Fang, F, "Oil containment by boom in waves and wind. II. Waves", J. Waterw. Port C-ASCE, 127, pp.228~233
- Fang, F, "Oil containment by boom in waves and wind. III. Containment failure", J. Waterw. Port C-ASCE, 127, pp.233~239
- Jeong, J.H, "Advanced Hydrodynamics", pp.1~221 (1996), Dongmyung
- Kim,D.A, "Design of Fishing Gear", pp.1~345 (1999), Pyounghwa
- Kim,D.A, "Flow resistance and modeling rule of fishing nets. 3. Establishment of modeling rule and its theoretical examination", J. Kor. Fish. Soc, pp.543~549 (1997)
- Kim, D.A., "Development of opening apparatus for unfolding and towing of oil boom by one ship", Proceedings of the Korea Society for Marine Environmental Engineering, pp.274~286 (2004)
- KMPA (Korea Maritime Police Agency), "The Guide Book to Clean up Techniques of Marine Pollution" (1999), KMPA
- KMPRC(Korea Marine Pollution Response Corporation), "Technical Manual for Protection and Clean up of Marine Pollution", pp.49~55 (2000), KMPRC
- Koyama, T., "Drag and sheer of süberkrüb type trawl boards", Bull. Nat. Res. Fish. Eng, 2, pp.95~103 (1981)
- Lee, C.M, "Analysis of containment capability of oil fence in currents and waves", J. Kor. Soc. Mar. Environ. Eng, 1, pp.29~38 (1998)
- Na, S.C., "Spreading efficiency of opening apparatus for oil fence by one ship", Proceedings of the 2006 Joint Meeting of the Korean Societies on Fisheries Science, pp.35~36 (2006)
- Oebius, H.U, "Physical properties and processes that influence the clean up of oil spills in the marine environment", Spill Sci. Technol. Bull, 5, pp.177~289 (1999)
- Riley, W.F, "Engineering Mechanics Statics", pp.1~670 (1996), John Wiley & Sons
- Steven, C.C, "Numerical Methods for Engineers, McGraw Hill", pp.63~674 (1988), Columbus
- Yu, J.S., "Performance tests of oil boom at open sea", J. Kor. Soc. Mar. Environ. Eng, 2, pp.49~62 (1999)
- Yu, J.S., "An experiment study on fire resistant boom", J. Kor. Soc. Mar. Environ. Eng, 3, pp.25~131 (2000)